In: Electrical Engineering
You have a camera that is sensitive in the visible light range.
Your 3D printing
facility has informed you that all inks are out except the
transparent type. Your group
mates try to paint or attach opaque black tape to the printed
transparent ink, but only
small, tiny pieces manage to stick and you cannot cover the box
with such pieces - it is
too much work. To make matters worse, your assignment to make a
pinhole camera is
due tomorrow and you did not work on it, even though the instructor
warned you
multiple times about this.
Suddenly you realize that you could create a "negative pinhole" or
pinspeck camera, by
blocking the light that would have been collected by a pinhole
camera.
a) How do you implement your pinhole camera?
b) Does it have any limitations?
As in above question if i am out of ink .there are many other alternative ways i can use them like
I can paint it with black primer paint , rubber paint
Or you can make glue paint at home just mix some glue with black painting color
-> I can use black sheet/paper and make it stick with glue (this is time taking and neither recommend because it take time to cover all place)
-> I can use cardboard boxes like i used shoe box during my school days
Now i am going to tell you the procedure to make pin hole camera
Material required
box, photo paper, thin piece of metal like a can or brass shim, aluminum foil ,tape, knife, needle, and sand paper(if possible rough surface also work)
And if you are thinking about of making pinspeck camera it is just a optical reverse of pinhole so it will make a negative image (shadow image) for that you have to buy light sensitive plastic sheets
I can tellhow i imliment my pin hole camera
1 Poke a tiny hole in the brass shim with a needle and sand it smooth. Trim the shim so there is a little space around the hole you can also use aluminum foil with multiple layers
2 You can use a shoe box, or other any cardboard box The box must be light proof if it is not then cover that place with tape or black paper with glue. When the lid is on and the shutter is closed the inside is completely dark. The only light comes through the pinhole. Make sure there are no holes or openings in the box. In case if you have paint then i will suggest you to paint it but as per your question paint is not possible then use black paper and stick it with the help of glue. It is better if your box is already black
3 fix your pinhole behind square opeaning withbthe help of tape
Then make a flape cover so it can shutter yourbpin hole like in shutter camera or in every camera
4 now fix your light sensitive photo paper in to the black box this is the most sensitive part of all process bc this thing you have to do in the dark place , you can use store room ,bathroom or you can make temporary dark room
5 You will need developer, fixer, water, tongs, towels, and a safe light in you dark room. It must be pitch black when safe light is off. you can use orange LED halloween lights as a safe light. It is cheaper and you get more light than a small red darkroom bulb. If you are not expert in this then you can take help of developer
I am attaching some pics of prototype
2 Limitation
(a) the image formed is detail less it is faint
(b) it can not be used for moving object
(c) For changing film or to see your last capture pic you need to access to dark room
(d) long exposure time
(e) you can not see what are you capturing untill you have a temporary dark room
I Think it will be helpful
Please give review on answer