Question

In: Physics

A vertical glass tube of length L = 1.280000 m is half filled with a liquid...

A vertical glass tube of length L = 1.280000 m is half filled with a liquid at 20.000 000 degrees C. How much will the height of the liquid column change when the tube and liquid are heated to 30.000000 degrees C? Use coefficients alpha_glass = 1.000 000 x 10^-5/K and Beta_liquid = 4.000 000 x 10^-5/K

Solutions

Expert Solution

Initial length of glass tube .

Initial radius of glass tube is  , final radius of glass tube is

Initial area of cross section of glass tube is  , final area of cross section of glass tube is

Initial volume of liquid and final volume of liquid is

Final volume of liquid can also be written as

Final length of liquid column

Change in length of liquid column

genius_generous answered 1 year ago
Next > < Previous

Related Solutions

A glass tube filled with water is used to guide light along its length. What is...
A glass tube filled with water is used to guide light along its length. What is the NA of the guiding system? Refractive Index of glass and water is 1.5 and 1.33 respectively.
The water level in a vertical glass tube 1.00 m long can be adjusted to any...
The water level in a vertical glass tube 1.00 m long can be adjusted to any position in the tube. A tuning fork vibrating at 716 Hz is held just over the open top end of the tube, to set up a standing wave of sound in the air-filled top portion of the tube. (That air-filled top portion acts as a tube with one end closed and the other end open.) take the speed of sound to be 343 m/s....
reveals a longitudinal section of a circular tube with a length of l = 300 m....
reveals a longitudinal section of a circular tube with a length of l = 300 m. Additionally, the absolute roughness of the boundary, the diameter of the circular tube, the continuous loss over the whole length and the kinematic viscosity of the real fluid are given. Longitudinal section of a steel tube Given l = 300 m k = 1 mm d = 1.00 m hLoss, continuous = 0.50 m ν = 1.3 * 10-6 m2 /s For a similar...
A) a container is half filled with a liquid and sealed at room temperature and atmospheric...
A) a container is half filled with a liquid and sealed at room temperature and atmospheric pressure. what happens? b) NaCl crystallizes in a cubic unit cell with Cl- ions on each corner and each face and Na+ ions on each edge (12) and one inside. how many Na+ and Cl- ions are in each unit cell? c) the energy absorbed when dry ice (co2) sublimely is required to overcome which type of interaction
A uniform plank of mass M and length L leans against a vertical wall. The initial...
A uniform plank of mass M and length L leans against a vertical wall. The initial angle it makes with the horizontal ground is 60º. It is let go from rest and slides down frictionlessly. The moment it leaves contact with the wall, what angle does it make with the ground? There is no friction anywhere.
A uniform ladder of length L and mass m leans against a frictionless vertical wall, making...
A uniform ladder of length L and mass m leans against a frictionless vertical wall, making an angle of 57° with the horizontal. The coefficient of static friction between the ladder and the ground is 0.42. If your mass is four times that of the ladder, how high can you climb before the ladder begins to slip? L
A thin wall cubic container is half-filled with water. What is the vertical position of the...
A thin wall cubic container is half-filled with water. What is the vertical position of the center of gravity if the container is tipped over just to the point where is about to spill water? Consider the side of the cube d = 0.30 m. a. yCG = 0.14 m b. yCG = 0.21 m c. yCG = 0.23 m d. yCG = 0.25 m
Consider a rigid, thick-walled tube that is filled with H2O liquid and vapor at 0.1 MPa....
Consider a rigid, thick-walled tube that is filled with H2O liquid and vapor at 0.1 MPa. After it is sealed, it is heated so that it passes through its critical point. What fraction of the mass in the tube is liquid?
A large tank containing a mystery liquid is filled to a depth of L = 35...
A large tank containing a mystery liquid is filled to a depth of L = 35 m. The upper surface of the liquid is exposed to the atmosphere (of density 1.2 kg/m3). A pipe of cross-sectional area Ain = 0.01 m2 is inserted in to the liquid. The other ’outlet’ end of the pipe, of smaller cross sectional area Aout = 0.005 m2, is placed outside the liquid at a height of h = 2 m below the surface of...
A large tank containing a mystery liquid is filled to a depth of L = 35...
A large tank containing a mystery liquid is filled to a depth of L = 35 m. The upper surface of the liquid is exposed to the atmosphere (of density 1.2 kg/m3). A pipe of cross-sectional area Ain = 0.01 m2 is inserted in to the liquid. The other ’outlet’ end of the pipe, of smaller cross sectional area Aout = 0.005 m2, is placed outside the liquid at a height of h = 2 m below the surface of...
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT