Question
In: Physics
In a spring gun system, a spring with a spring force constant 420 N/mN/m , is compressed...
In a spring gun system, a spring with a spring force constant 420 N/mN/m , is compressed 0.13 mm . When fired, 80.9 %% of the elastic potential energy stored in the spring is eventually converted into kinetic energy of a 6.10×10−2 kgkg uniform ball that is rolling without slipping at the base of a ramp. The ball continues to roll without slipping up the ramp with 89.6 %% of the kinetic energy at the bottom converted into an increase in gravitational potential energy at the instant it stops.
a)What is the velocity of the ball's center of mass at the base of the ramp?
Express your answer using two significant figures.
b)At this position, what is the velocity of a point at the top of the ball?
Express your answer using two significant figures.
c)At this position, what is the speed of a point at the bottom of the ball?
Express your answer using two significant figures.
d)What maximum vertical height up the ramp does the ball move?
Take the free fall acceleration to be 9.80m/s29.80m/s2. Express your answer using two significant figures.
Solutions
genius_generous answered 2 years agoRelated Solutions
The spring of a toy gun has a force constant of k = 533 N/m and...
The spring of a toy gun has a force constant of k = 533
N/m and negligible mass. The spring is compressed the length of the
gun barrel, 7.25 cm, and a 0.168-g ball is placed against the
compressed spring. A constant frictional force of 5.45-N acts on
the ball as it travels through the barrel. The ball leaves the
barrel at the moment that it loses contact with the spring. The toy
gun is ‘fired’ at a height of...
A light spring of force constant 4.45 N/m is compressed by 8.00 cm and held between...
A light spring of force constant 4.45 N/m is compressed by 8.00
cm and held between a 0.250 kg block on the left and a 0.450 kg
block on the right. Both blocks are at rest on a horizontal
surface. The blocks are released simultaneously so that the spring
tends to push them apart. Find the maximum velocity each block
attains if the coefficient of kinetic friction between each block
and the surface is the following. In each case, assume...
The potential energy stored in the compressed spring of a dart gun, with a spring constant...
The potential energy stored in the compressed spring of a dart
gun, with a spring constant of 36.00 N/m, is 1.440 J. Find by how
much is the spring is compressed. A 0.070 kg dart is fired straight
up. Find the vertical distance the dart travels from its position
when the spring is compressed to its highest position. The same
dart is now fired horizontally from a height of 4.30 m. The dart
remains in contact until the spring reaches...
The spring (force) constant of HF is 970 N/m (1 N = 1 kg m s2...
The spring (force) constant of HF is 970 N/m (1 N = 1 kg m
s2 ).
(A) Calculate the fundamental frequency (expressed in units of
cm-1 ) and the zero point energy (in energy units, J).
(B) Earlier in the term we discussed the relationship between
the energy and the position and momentum uncertainties. For the
harmonic oscillator case, it would be
E ≥ ((Δp) 2 / 2µ) + (1 / 2) µω2 (Δx)
2
(Equation 1)
The ground...
A spring with force constant k = 175 N/m is attached to the ground. On top...
A spring with force constant k = 175 N/m is attached to the
ground. On top of the spring a 1.30 kg metal pan is attached. The
combination could be used as a scale, but we are going to do
something more interesting. We place a metal ball with mass 0.250
kg on the tray and then the tray is pushed down 0.150 m below its
equilibrium point and released from rest (take this as t = 0).
a) At...
A spring that has a force constant of 1050 N/m is mounted vertically on the ground....
A spring that has a force constant of 1050 N/m is mounted
vertically on the ground. A block of mass 1.40 kg is dropped from
rest from height of 1.40 m above the free end of the spring. By
what distance does the spring compress?
A spring (70 N/m ) has an equilibrium length of 1.00 m. The spring is compressed...
A spring (70 N/m ) has an equilibrium length of 1.00 m. The
spring is compressed to a length of 0.50 m and a mass of 2.2 kg is
placed at its free end on a frictionless slope which makes an angle
of 41 ? with respect to the horizontal. The spring is then
released. (Figure 1)
Part A
If the mass is not attached to the spring, how far up the slope
from the compressed point will the mass move...
A horizontal spring with a spring constant of 190 N/cm is compressed 6.3 cm. A wooden...
A horizontal spring with a spring constant of 190 N/cm is
compressed 6.3 cm. A wooden block with a mass of 1.5 kg is placed
in front of and in contact with the spring. When the spring is
released it pushes the block, which slides on a frictionless
horizontal surface for some distance. The block then slides up a
frictionless incline of 27 above the horizontal and comes to a
momentary stop before sliding back down. The system is the...
A horizontal spring with a spring constant of 190 N/cm is compressed 6.3 cm. A wooden...
A horizontal spring with a spring constant of 190 N/cm is
compressed 6.3 cm. A wooden block with a mass of 1.5 kg is placed
in front of and in contact with the spring. When the spring is
released it pushes the block, which slides on a frictionless
horizontal surface for some distance. The block then slides up a
frictionless incline of 27 above the horizontal and comes to a
momentary stop before sliding back down. The system is the...
A horizontal spring with a spring constant of 190 N/cm is compressed 6.3 cm. A wooden...
A horizontal spring with a spring constant of 190 N/cm is
compressed 6.3 cm. A wooden block with a mass of 1.5 kg is placed
in front of and in contact with the spring. When the spring is
released it pushes the block, which slides on a frictionless
horizontal surface for some distance. The block then slides up a
frictionless incline of 27 degrees above the horizontal and comes
to a momentary stop before sliding back down. The system is...
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- 3) You are rolling a 12 sided die 8 times. a) What is the size for...
- explain the difference between quantitative and qualitative research strategies. Provide an example of a crime based...
- use postorder and inorder tree traversals to make preorder traversal. #!/usr/bin/env python3 # encoding: UTF-8 """Turning...
- 1. Write an if-else statement to describe an object. Print "Balloon" if isBalloon is true and...
- An investor is considering purchasing a Treasury bond with a 20 year maturity, an 8% coupon...
- Write a program that copies the contents of one file to a destination file. This program...
- how to conduct a marketing mix for 3d crest white strips
ADVERTISEMENT