Question

In: Other

10) When the directions of current and magnetization are usually parallel to each other in ferromagnetic...

10)

When the directions of current and magnetization are usually parallel to each other in ferromagnetic metals, the resistance becomes maximum, and when they are perpendicular to each other, the phenomenon becomes minimum. In the multilayer thin film structure separated by the ferromagnetic metal thin film, A magnetoresistance change may occur. This phenomenon is called (________) and occurs by (________) electron scattering

Solutions

Expert Solution

When the directions of current and magnetization are usually parallel to each other in ferromagnetic metals,the resistance becomes maximum and when they are perpendicular to each other ,the phenomenon become minimum .In the multilayer thin film structure separated by the ferromagnetic metal thin film.This phenomenon is called GMR(Giant magnetoresistance )effect and occurs by spin dependent electron scattering

This effect is the term for the sudden change in magnetoresistance (Sudden dip for parallel orientation of current and magnetic field (about 10% - 80% decrease) in multilayer systems separated by ferromagmetic metals

This drop of resistance is due to the saturation of magnetization of the multilayer due to aligning of the magnetic moment with magnetic field

Similar sudden change is seen for perpendicular orientation , but here there happens a similar increase

Hope it helps .....And if it does plz give thumbs up


Related Solutions

1) Two wires each of length I with current I are placed parallel to each other...
1) Two wires each of length I with current I are placed parallel to each other separated by a distance d. What physical quanti­ties can you determine using this information? How will the values of these quantities change if one of the currents is re­versed? If one of the currents is doubled? Include a diagram to explain your reasoning. 2) An electric motor has a square armature with 500 turns. Each side of the coil is 12 cm long and...
Two infinite thin sheets of current are parallel to each other. Both sheets conduct a linear...
Two infinite thin sheets of current are parallel to each other. Both sheets conduct a linear current density of 8 A/m, but the top sheet current is out of the page, while the bottom sheet carries current into the page: A 8 A/m (out) B 8 A/m (in) C A. Calculate the magnetic field at point ‘B’, halfway between these sheets. B. Calculate the magnetic field at a point ‘A’, 1 meter above the top plate. C. The bottom plate...
Two projectiles with 50kg mass each are launched in opposite directions towards each other, both at...
Two projectiles with 50kg mass each are launched in opposite directions towards each other, both at an angle of 30 degrees off the horizontal. They both have the same initial velocity of 75m/s and they are separated by a distance of 200m. a.) What is their combined initial kinetic energy? b.) Right before they collide, how high off the ground are they? c.) What is their total momentum here? (both directions) d.) When they collide they stick together and lost...
1. Directions: List TEN (10)  recreation and leisure activities. 2.) Directions: Give an example (domain) for each...
1. Directions: List TEN (10)  recreation and leisure activities. 2.) Directions: Give an example (domain) for each type of recreation and leisure activities that you listed in question #1. 3.) Directions: Answer the question. Why a person should do each type of activity listed in question #2? 4.) Directions: List ten (10) benefits of recreation and leisure activities
Three long wires are all parallel to each other and are all in the xy plane....
Three long wires are all parallel to each other and are all in the xy plane. Wire 1 runs along the y axis and carries a current of 1.64 A in the +y direction. Wire 2 runs along the x = 25.0 cm line and carries a current of 4.04 A in the −y direction. (a) Determine the location of wire 3 on the x axis so that when it carries a certain current (to be determined later) each wire...
Three parallel wires, each carrying a current I (left and right wire carry upward current and...
Three parallel wires, each carrying a current I (left and right wire carry upward current and middle wire carries downward current....but all wires have the same magnitude current). Four points are identified on the picture as well.   What are the directions of the magnetic fields at the four points, starting with point 1, then 2, etc. 1 Question options: 1: in, 2: in, 3: out, 4: out 1: in, 2: out, 3: out, 4: in none of these 1: out,...
Find the current through each resistor using the rules for series and parallel resistors.
Consider the circuit shown in the figure. Suppose the four resistors in this circuit have the values R1 = 12 Ω , R2 = 7.1 Ω , R3 = 7.1 Ω , and R4 = 13 Ω, and that the emf of the battery is E = 18 V.Part AFind the current through each resistor using the rules for series and parallel resistors.Express your answers using two significant figures separated by commas.I1,I2,I3,I4 =___________ A  Part BFind the current through each resistor...
Two parallel wires are 5.85 cm apart, each with 3.45 A of current in the same...
Two parallel wires are 5.85 cm apart, each with 3.45 A of current in the same direction. (a) What is the magnitude of the force per unit length between the wires? (b) Is the force attractive or repulsive?
When a message is sent electronically it is usually sent as a stream of bits, each...
When a message is sent electronically it is usually sent as a stream of bits, each of which can be either a 0 or a 1. If the digital channel is noisy then each bit has some probability of being flipped (ie changed from a 0 to a 1 or vice versa) resulting in a corrupted message. Assume that a message is being sent through a noisy channel where the probability that any individual bit will be flipped is 0.1....
Two large thin metal plates are parallel and close to each other as in figure shown...
Two large thin metal plates are parallel and close to each other as in figure shown above. On their inner faces, the plates have surface charge densities of opposite signs and of magnitude 7 * 10-22 C/m2. The negatively charged plate is on the left and the positively charged plate is on the right. What are the magnitude and direction of the electric field E (a) to the left of the plates? » Direction: ? Straight out of the computer...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT