mean water temperature downstream from a discharge pipe at a power plant cooling tower should be...

mean water temperature downstream from a discharge pipe at a power plant cooling tower should be no more than 100°F. Past studies has shown that the standard deviation of temperature is 2°F. The water temperature was measured on 10 randomly chosen days, and the results are shown below: 96.15 , 97.81 , 97.09 , 95.0P , 99.46 , 100.03 , 99.74 , 98.85 , 95.08 , 98.71

a. State the null hypothesis and alternative hypothesis for the above problem.

b. Is there evidence that the water temperature is acceptable at α = 1%?

c. Compute the 95% confidence interval for the mean temperature of water.

Expert Solution

99%

95%

Thank you...

please do not forgot to like

orchestra answered 2 years ago

The mean water temperature downstream from a power plant cooling tower discharge pipe should be no...

The mean water temperature downstream from a power plant cooling tower discharge pipe should be no more than 97oF. Past experience has indicated that the standard deviation of temperature is 2oF. The water temperature is measured on 4 randomly chosen days, and the average temperature is found to be 94oF. Conduct a hypothesis testing using the 7 steps at a 5% significance level.

The mean water temperature downstream from a discharge pipe at a power plant cooling tower should...

The mean water temperature downstream from a discharge pipe at a power plant cooling tower should be no more than 100°F. Past studies has shown that the standard deviation of temperature is 2°F. The water temperature was measured on 10 randomly chosen days, and the results are shown below: 96.15 97.81 97.09 95.08 99.46 100.03 99.74 98.85 95.08 98.71 a. State the null hypothesis and alternative hypothesis for the above problem. b. Is there evidence that the water temperature is...

The cross-section of a nuclear power plant's cooling tower is in the shape of a hyperbola....

The cross-section of a nuclear power plant's cooling tower is in the shape of a hyperbola. Suppose the tower has a base diameter of 156 meters and the diameter at its narrowest point, 48 meters above the ground, is 52 meters. If the diameter at the top of the tower is 104 meters, how tall is the tower? The tower is about ___ meters tall.

Consider a 400-MW, 32 percent efficient coal-fired power plant that uses cooling water withdrawn from a...

Consider a 400-MW, 32 percent efficient coal-fired power plant that uses cooling water withdrawn from a nearby river (with an upstream flow of 10-m3/s and temperature 20 °C) to take care of waste heat. The heat content of the coal is 8,000 Btu/lb, the carbon content is 60% by mass, and the sulfur content is 2% by mass. How much electricity (in kWh/yr) would the plant produce each year? How many pounds per hour of coal would need to be...

Hot water from a boiler of power plant are discharged through a 0.2-m-diameter, thin-walled pipe with...

Hot water from a boiler of power plant are discharged through a 0.2-m-diameter, thin-walled pipe with a velocity of 3.5 m/s. The pipe passes through a room whose air temperature is 3°C and the exterior surface of the pipe is uninsulated and pipe length is 30 m. (a) At a position in the pipe where the mean water temperature is 40°C, determine the heat loss and the pipe wall temperature. (b) If the pipe is covered with a 20-mm-thick layer...

A water tower supplies water to a city through a pipe with 1 ft diameter. The...

A water tower supplies water to a city through a pipe with 1 ft diameter. The pipe is 0.5 miles long and is made of commercial steel pipe. Over the years, the supply line lost head and engineers are considering the replacement of 94 percent of the pipe length with a larger diameter pipe (same type). The peak water demand is 3.53 ft3/sec. How much pressure head could be gained by this strategy?

1. Consider a 400-MW, 32 percent efficient coal-fired power plant that uses cooling water withdrawn from...

1. Consider a 400-MW, 32 percent efficient coal-fired power plant that uses cooling water withdrawn from a nearby river (with an upstream flow of 10-m3/s and temperature 20 °C) to take care of waste heat. The heat content of the coal is 8,000 Btu/lb, the carbon content is 60% by mass, and the sulfur content is 2% by mass. v. If the cooling water is only allowed to rise in temperature by 10 °C, what flow rate (in m3/s) from...

A wastewater plant needs to reduce the methane content in water in a stripping tower to...

A wastewater plant needs to reduce the methane content in water in a stripping tower to 0.3 mol %. The liquid stream is entering the tower with a flow rate of 200 mole/h and contains 0.8 mol % methane. The tower uses pure air for stripping and its temperature and pressure are held constant at 300 K and 1 atm, respectively. The equilibrium relation for methane in the air-water system is ? = 1.2?. a) Find the minimum vapor flow...

An experimental power plant at the Natural Energy Laboratory of Hawaii generates electricity from the temperature...

An experimental power plant at the Natural Energy Laboratory of Hawaii generates electricity from the temperature gradient of the ocean. The surface and deep-water temperatures are 30 ∘C and 6 ∘C, respectively. The surface and deep-water temperatures are 30 ∘C and 6 ∘C, respectively. Part A What is the maximum theoretical efficiency of this power plant? Express your answer using two significant figures. Part B If the power plant is to produce a power of 190 kW , at what...

If the compressor efficiency is 0.8, what is the power requirement of the compressor and what is the discharge temperature of the propylene?

Propylene b compressed adiabatically from 113 bar and 30oC to I8 bar at the rate of 1 kg mol s-l. If the compressor efficiency is 0.8, what is the power requirement of the compressor and what is the discharge temperature of the propylene?

Question