Question

In: Physics

2) a). The resistivity of a wire varies with its length area of cross-section mass material...

2) a). The resistivity of a wire varies with its

length
area of cross-section
mass
material

b) Given the units of a physical quantity. Choose the correct relation (J is for Joule, V is for volt, C is for Coulomb)

A) J = CV

B) J = VA

C) J = C/A

D) V = J C

c) A charge of 3 C moving in a uniform electric field experiences a force 3000 N. The potential difference between two points situated in the field at a distance 1 cm from each other will be

A) 10 V

B) 90 V

C) 1000 V

D) 9000 V

d) Choose the only incorrect relation:

A) ampere = coulomb/second

B) volt = coulomb/joule

C) ohm = volt/ampere

D) coulomb = Joule/volt

e) In an astronomical telescope, the image formed by the objective is I₀ and that formed by eye piece is I_e . Then

A) I₀ and I_e are both real

B) I₀ and I_e are both virtual

C) I₀ is virtual and I_e is real

D) I₀ is real and I_e is virtual

Expert Solution

As it is not mentioned that how many questions has to be attempted. Therefore I have done the first four question as per instructions given to us. Kindly consider it please as this is our protocol if many questions are posted without mentioning that how many of them have to be attempted.

=>If your doubt is cleared please give an upvote it means a lot. Its a humble request to you. If you have any doubts feel free to ask in comment section.

genius_generous answered 2 years ago

A steel wire with a cross-section area 2.5X10^-3 m2 and a length of 10 m is...

A steel wire with a cross-section area 2.5X10^-3 m2 and a length of 10 m is used to pull a truck on the road. The truck is 10 tons and the friction coefficient between the tires and road is 0.25N/kg. Steel has a Young’s modulus 250MPa. Suppose this wire contain surface cracks. Determine the largest linear size of the surface crack so that the wire will not fail due to fracture in this application. Kc = 0.1 MPa m^0.5

The electrical resistance of a wire varies directly as its length and inversely as the square...

The electrical resistance of a wire varies directly as its length and inversely as the square of its diameter. A wire with a length of 200 inches and a diameter of one-half of an inch has a resistance of 10 ohms. Find the electrical resistance in a 500 inch wire with the same diameter. Group of answer choices 25 ohms 50 ohms 200 ohms 400 ohms

Consider the cylindrical wire of radius R= 5mm having current density through a cross section varies...

Consider the cylindrical wire of radius R= 5mm having current density through a cross section varies with radial distance ‘r’ as J= (3x 109 A/m4 ) r2 , and ‘r’ is in meters. What is the current through the outer portion of the wire between radial distances r=0.75R and r=R.

A wire of length L has a rectangular cross-section with height H and width W. The...

A wire of length L has a rectangular cross-section with height H and width W. The wire has a hole all the way through it of area a. The wire is made of material with constant resistivity ρ1 . A battery with a known voltage is applied across the ends of the wire. a. Find the electric field inside the material and the current flowing through the wire. b. If the hole is totally filled with a material that has...

A wire of resistivity ρ must be replaced in a circuit by a wire of the same material but 4 times as long.

A wire of resistivity ρ must be replaced in a circuit by a wire of the same material but 4 times as long. If, however, the resistance of the new wire is to be the same as the resistance of the original wire, how does the diameter of the new wire change?

A metallic airfoil of elliptical cross section has a mass of 50 kg, surface area of...

A metallic airfoil of elliptical cross section has a mass of 50 kg, surface area of 12 m2, and a specific heat of 0.50 kJ/kg °C. The airfoil is subjected to air flow at 1 atm, 25°C, and 6m/s along its 3-m-long side. The average temperature of the airfoil is observed to drop from 160°C to 140°C within 1 min of cooling. Assuming the surface temperature of the airfoil to be equal to its average temperature and using momentum-heat transfer...

1-What four physical factors affect the resistance of a wire? 2-A wire of uniform cross-section has...

1-What four physical factors affect the resistance of a wire? 2-A wire of uniform cross-section has a resistance of R. What would be the resistance of a similar wire, made of the same material, but twice as long and of twice the diameter? 3- A block of carbon, 1.0 cm by 2.0 cm by 5.0 cm, has a resistance of 0.015 Ω between its two smaller faces. What is the resistivity of carbon? 4-What length of German silver wire, diameter...

The figure shows wire 1 in cross section; the wire is long and straight, carries a...

The figure shows wire 1 in cross section; the wire is long and straight, carries a current of 4.20 mA out of the page, and is at distance d1 = 2.61 cm from a surface. Wire 2, which is parallel to wire 1 and also long, is at horizontal distance d2 = 5.22 cm from wire 1 and carries a current of 7.06 mA into the page. What is the x component of the magnetic force per unit length on...

A 1.5 m length of wire has a cross-sectional area of 5.0×10−8 m2. When the potential...

A 1.5 m length of wire has a cross-sectional area of 5.0×10−8 m2. When the potential difference across its ends is 0.20 V, it carries a current of 0.40 A. What is the resistivity of the material from which the wire is made?

Consider cylindrical shape rod of silicon with circular cross-section (resistivity of 3345 , the diameter of...

Consider cylindrical shape rod of silicon with circular cross-section (resistivity of 3345 , the diameter of 2.53 cm and length of 32.7 cm). Consider a voltage of 1.25*103 V is applied. The temperature coefficient of silicon is -0.005 0C-1 (negative because Silicon is a semiconductor). (a) Find the resistance of this rod at room temperature? (2 points) (b) Find the electric field inside the silicon rod? (3 points) (c) Find the energy dissipations in 3 min? (2 points) (d) If...