Wood milled to overlap with others and is 12 inches wide by 8 feet long. you...

Wood milled to overlap with others and is 12 inches wide by 8 feet long. you need to replace a section that is 6 feet wide. each milled board costs $15.50. You also need a gallon of paint ($35.00), sand paper ($5.50), and new paint brush ($9.95). what will this project cost?

A. 143.35, B. 140.50, C. 143.00, D. 145.43

Solutions

Expert Solution

Rahul Sunny answered 1 year ago

Next > < Previous

Related Solutions

A package of aluminum foil is 66.7 yards long, 12 inches wide, and 0.00030 inches thick....

A package of aluminum foil is 66.7 yards long, 12 inches wide, and 0.00030 inches thick. Aluminum has a density of 2.70 g/cm^3. What is the mass, in grams, of the foil? a. 250 grams b. 380 grams c. 100 grams d. 8.8 grams

A parabolically shaped bookshelf has a width of 10 feet 8 inches at the top and...

A parabolically shaped bookshelf has a width of 10 feet 8 inches at the top and height 9 ft. 2 in.. Their are 7 rows of shelves with the same height. How tall is each shelf? How long is the board needed for the bottom of the shelf that is the fourth row of shelves from the bottom?

A swimming pool is 20ft wide and 40 feet long and its bottom is an inclined...

A swimming pool is 20ft wide and 40 feet long and its bottom is an inclined plane, the shallow end having a depth of 3 ft and the deep end 12 ft. If the pool is full of water, find the hydrostatic force on (a) the shallow end side, (b) the deep end side, (c) the side of the pool, and (d) the bottom of the pool.

Given a wall that is 36 feet long and 8 feet high calculate the heat loss...

Given a wall that is 36 feet long and 8 feet high calculate the heat loss per hour when the inside temperature is 70 degrees inside and 10 degrees outside. The wall assembly consists of: A = Face brick B = 1” Polystyrene ins. board C = 2 X 6 studs D = Fiberglass batt ins. E = ½” Sheet rock F = Paneling

1 design a column that supports 4500 lb if it is 12 feet long

Design a steel flexural member that is continuously braces and 12 feet long. There is a...

Design a steel flexural member that is continuously braces and 12 feet long. There is a uniformly distributed live load of 1 k/ft, and uniformly distributed dead load of 1 k/ft and a concentrated live load of 8.4 kips at a distance of 5 feet from the left support. use 36 ksi steel.

If the slab is 21 ft wide x 36 ft long x 15 inches deep with...

If the slab is 21 ft wide x 36 ft long x 15 inches deep with the total steel reinforcement of 20,000 ft of #5 bar. Find the quantity of concrete required (in cubic yards). The capacity of concrete truck is 9 cubic yards. Assume waste factor as 10%. Density of steel is 490 lbs/cubic feet. (a) Calculate Slab Volume: (b)Calculate Steel Volume and Weight: (c) Calculate concrete Volume:

A 4 foot spring measures 8 feet long after a mass weighing 8 pounds is attached...

A 4 foot spring measures 8 feet long after a mass weighing 8 pounds is attached to it. The medium through which the mass moves offers a damping force numerically equal to 2^1/2 times the instantaneous velocity. Find the equation of motion if the mass is initially released from the equilibrium position with a downward velocity of 9 ft/a. (Use g =32 ft/s^2 for the acceleration due to gravity.) a) Find the time at which the mass attains its extreme...

10. Kyla C. is a 27-year-old professional woman who is 5 feet 8 inches tall and...

10. Kyla C. is a 27-year-old professional woman who is 5 feet 8 inches tall and vigilantly maintains her weight at 118 pounds by following a lacto-ovo (non-fat milk and egg whites only) vegetarian diet that supplies approximately 1200 kcalories a day. With her understanding that protein should provide between 10 and 35 percent of her daily calories, she reasons that her daily intake of 40 grams of protein from milk, eggs, legumes, and nuts is adequate for her needs....

Suppose that you own a vacant lot that is 220 feet wide by 150 deep. The...

Suppose that you own a vacant lot that is 220 feet wide by 150 deep. The lot is zoned for apartment use with setback requirements of 30 feet for the front, 15 feet for the back, and 15 feet on each side. The building cannot occupy more than 50 percent of the lot area, and the floor area ration is two-to one. With a lot area of 400 square feet per dwelling unit, what is the maximum allowable number of...

Subjects