Question

In: Physics

The right half of the square loop of wire shown in Figure P24.37

The right half of the square loop of wire shown in Figure P24.37  is in a 0.85 T magnetic field directed into the page. The current in the loop is  1.3 A in a clockwise direction. What is the magnitude of the force on the loop, and in which direction does it act?

image.png

Solutions

Expert Solution


Related Solutions

The right half of the square loop of wire shown in (Figure 1) is in a...
The right half of the square loop of wire shown in (Figure 1) is in a 0.25 T magnetic field directed into the page. The current in the loop is 1.5 A in a clockwise direction. Part A What is the magnitude of the force on the loop? Express your answer with the appropriate units. Part B In which direction does this force act? to the left downward to the right upward
A piece of insulated wire is shaped into a figure eight as shown in the figure...
A piece of insulated wire is shaped into a figure eight as shown in the figure below. For simplicity, model the two halves of the figure eight as circles. The radius of the upper circle is 4.00 cm and that of the lower circle is 8.00 cm. The wire has a uniform resistance per unit length of 7.00 Ω/m. A uniform magnetic field is applied perpendicular to the plane of the two circles, in the direction shown. The magnetic field...
The current in the wire shown in (Figure 1) is increasing
The current in the wire shown in (Figure 1) is increasing. Part A What is the direction of the induced current in loop A? clockwise counterclockwise No current is induced in this loop.   Part B What is the direction of the induced current in loop B? clockwise counterclockwise No current is induced in this loop. 
A very long thin wire carries a current I1 is next to a square wire loop...
A very long thin wire carries a current I1 is next to a square wire loop of width L = 5 .0 cm. Both the wire and the loop lay in the same plane with a gap of s = 1 .0 cm between them. The square loop has a break where two parallel plates with surface area A = 4 .0 cm 2 are separated by a gap of d = 1 µm. The radius of the wire that...
Problem 3. A square loop of wire is made up of 50 turns of wire, 40...
Problem 3. A square loop of wire is made up of 50 turns of wire, 40 cm on each side. The loop is immersed in a 0.4−T magnetic field perpendicular to the plane of the loop. The loop of wire has little resistance but it is connected to two resistors in parallel as shown. When the loop of wire is rotated by 180°, how much charge flows through the circuit? How much charge goes through the smaller resistor? What is...
A square loop of wire 0.17 m on a side lies on a horizontal table and...
A square loop of wire 0.17 m on a side lies on a horizontal table and carries a counterclockwise current of 4.8 A. The component of Earth’s magnetic field that is in the plane of the loop is 2.4×10−5T and points toward the top of the loop. Consider a horizontal axis of rotation that passes through the center of the loop from left to right. Does the top wire of the loop want to rotate toward you (up from the...
A square loop of wire with sides of length 34 cm is in a uniform magnetic...
A square loop of wire with sides of length 34 cm is in a uniform magnetic field perpendicular to its area. Part A If the field's strength is initially 110 mT and it decays to zero in 0.011 s , what is the magnitude of the average emf induced in the loop? Part B What would be the average emf if the sides of the loop were only 17 cm ? Express your answer using two significant figures.
1: A square footing is to be constructed as shown in the Figure at a founding...
1: A square footing is to be constructed as shown in the Figure at a founding depth of 2 m. Using the Terzaghi equation compute the ultimate surface capacity, [ (qult)Surf ], possible for the layered soil profile shown. Keeping in mind that Terzaghi’s semi-empirical bearing capacity equation can only be applied to a soil layer with a thickness greater than or equal to the applied stress contact-area-breadth (either virtual or real breadth). In such a case, second layer cannot...
The area enclosed by the wire loop in the figure below is reduced from 31 cm2...
The area enclosed by the wire loop in the figure below is reduced from 31 cm2 to 12 cm2 in a time interval of 0.11 s. The magnitude of the magnetic field is 0.53 T. Find the emf induced in the wire.
A square single loop of wire 4.00 cm on a side with 875 turns lies in...
A square single loop of wire 4.00 cm on a side with 875 turns lies in the xy-plane. The loop is in a uniform magnetic field that changes at a steady rate from B⃗ =(0.200T)i^+(0.150T)k^B→=(0.200T)i^+(0.150T)k^ at t = 0 to B⃗ =(0.300T)i^+(−0.200T)k^ B→=(0.300T)i^+(−0.200T)k^ at t=3.00s. At the time t=2.00s, a) find the magnitude of the induced emf in the coil. b) Find the direction of the induced current in the coil as seen from a point on the +z-axis.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT