You dig a hole in the ground, removing a volume 0.87 m3 of earth. If the...

You dig a hole in the ground, removing a volume 0.87 m3 of earth. If the density of the earth is 5044 kg/m3 calculate the weight of the earth removed in N, to 2 sf.

Expert Solution

genius_generous answered 6 hours ago

A rigid tank of volume 0.75 m3 is initially evacuated. A hole develops in the wall,...

A rigid tank of volume 0.75 m3 is initially evacuated. A hole develops in the wall, and air from the surroundings at 1 bar, 30°C flows in until the pressure in the tank reaches 1 bar. Heat transfer between the contents of the tank and the surroundings is negligible. Determine the final temperature in the tank, in °C.

How much work, in Joules, does it take to dig up a cylindrically shaped hole of...

How much work, in Joules, does it take to dig up a cylindrically shaped hole of depth 2 meters and outer diameter 3 meters? How many servings of pasta are required to complete this work, assuming the energy from the pasta is converted with 5% efficiency to work? Assume that one serving of pasta contains 200 Cal, and the density of soil is 1,200 kg/m3.

If we dig down into the Earth, we find that the temperature rises with increasing depth....

If we dig down into the Earth, we find that the temperature rises with increasing depth. This indicates that heat is flowing out from the center of the Earth. The rate of heat flow per unit area is measured to be about 80 ergs/cm2/sec. a) Give the total rate of loss of heat of the Earth’s interior, in ergs/sec. b) Most solids have a heat capacity which is about 3kT per atom. Assume that the typical atom in the Earth’s...

You are removing imidazole from your pooled nickel column samples by dialysis. The volume of the...

You are removing imidazole from your pooled nickel column samples by dialysis. The volume of the pooled sample is 32 mL and the imidazole concentration is 0.5 M. a. What is the concentration of imidazole after exposure to three consecutive dialyses against 1 L of buffer? b. If the imidazole at the start is 3.4% (w/v), what is the concentration in weight percent at the end of the dialysis (three consecutive exposures to one liter of buffer)?

You have nitrogen at a temperature of 145 K and a volume of 0.061629 m3 /...

You have nitrogen at a temperature of 145 K and a volume of 0.061629 m3 / kmol. Determine the pressure of this gas with the following methods (with R=8.314 KPam^3/kmolK). And determine the percentage deviation presented by each equation of state if the actual nitrogen pressure at these conditions is 100 atm. a) ideal gas b) Vander Walls c) Beattie Bridgeman. with A0 =136.2315, a=0.02617, B0=0.05046, b=-0.0061, c=4.20x10^4 d) Redlich Kwong e) Peng Robison With w=0.038 f) Benedict web rubin....

A CM basin with a volume of 475 m3 receives a flow of 2000 m3 d−1....

A CM basin with a volume of 475 m3 receives a flow of 2000 m3 d−1. The basin has a dead volume of 42 m3. Find the effluent tracer curve if a mass of 5 g of tracer is added instantaneously to the influent. Also plot the effluent tracer curve for the reactor without dead volume.

A steam boiler of volume 2.3 m3 initially contained 1.7 m3 liquid water in equilibrium with...

A steam boiler of volume 2.3 m3 initially contained 1.7 m3 liquid water in equilibrium with 0.6 m3 of vapour at 100 kPa. The boiler is heated keeping the inlet and discharge valves closed. The relief valve is set to lift when the pressure in the boiler reaches 5500 kPa. Determine the amount of heat supplied to the contents in the boiler before the relief valve lifts.

For a sample of 12 trees, the volume of lumber (in m3) and the diameter (...

For a sample of 12 trees, the volume of lumber (in m3) and the diameter ( in cm ) at a fixed height above the ground level was measured. The results were as follows. Use Excel sheet Diameter Volumes 35.1 0.81 48.4 1.39 47.9 1.31 35.3 0.67 47.3 1.46 26.4 0.47 33.8 0.8 45.3 1.69 25.2 0.3 28.5 0.19 30.1 0.63 30 0.64 a)Construct a scatterplot of volume ( y ) versus diameter ( x ). using Excel b)Compute the...

The volume of water in the ocean is approximately 1.36 ✕ 1018 m3 and 0.030% of...

The volume of water in the ocean is approximately 1.36 ✕ 1018 m3 and 0.030% of the hydrogen in this water is deuterium. (Assume ρwater = 1000 kg/m3 and the atomic masses MH-2 and MHe-4 are 2.0141 u and 4.0026 u, respectively.) (a) Determine the amount of energy (in J) that would be generated if all this deuterium fused to He-4. (B)Determine the number of years this amount of energy could sustain the world's power consumption if it remained constant...

A centrifugal pump delivers water at rate of 0.22 m3/s from a reservoir at a ground...

A centrifugal pump delivers water at rate of 0.22 m3/s from a reservoir at a ground level to another reservoir to height 'h' through a vertical pipe of 0.2 m diameter. Both are open to atmosphere. Power input to pump is 90 kW and it operates with 75% efficiency . f=0.004 use g=9.8 m/s2 density=1000kg/m3. Find 'h'.

Question