Question

In: Physics

A stretchy cord has a diameter of 0.33 mm when lying loose off the spool. Loops...

A stretchy cord has a diameter of 0.33 mm when lying loose off the spool. Loops are made on the two ends, 75.0 cm apart from knot to knot. The cord is hung vertically with one loop over a hook and the other with a 500 g mass hanging from it. After the mass is hung from it, the distance between the marks is now 79 cm.

a. What is the Young's modulus of the cord material?

b. If the same material also comes in a cord with diameter 0.66 mm, what would be its stretched length in the same scenario as above?

Solutions

Expert Solution

part b can also be done using the relation that youngs modulus is inversly proportional to R^2


Related Solutions

A coil lying in the plane of the page contains 40 turns (loops). The diameter of...
A coil lying in the plane of the page contains 40 turns (loops). The diameter of the coil is 5.00cm and its resistance is 12.0Ω. It is in a uniform magnetic field directed out of the page. At t = 0, the magnitude of the field is 0.800T. The strength of the field is increased at a constant rate for 10.0s until it reaches 1.50 T. It is held constant at that value for 5.00s. Then it is decreased at...
A copper wire has a diameter of 3.247 mm. What magnitude of current flows when the...
A copper wire has a diameter of 3.247 mm. What magnitude of current flows when the drift velocity is 4.40 mm/s? Take the density of copper to be 8.92 g/cm3. Give your answer in Amperes. PLEASE PLEASE PLEASE answer correctly
A centrifugal pump has an eye diameter and an impeller diameter of 300 mm and 600...
A centrifugal pump has an eye diameter and an impeller diameter of 300 mm and 600 mm respectively while running at 850 rpm. When rotating, the blade angle is measured at 35o at the outlet with considering the tangent. The flow velocity is limited at 5 m/s constantly. Determine the following; (a) inlet blade angle (b) outlet absolute velocity with its angle at outlet and (c) the manometric head.
A camera lens has a focal length of 224.0 mm, an aperture diameter of 14 mm,...
A camera lens has a focal length of 224.0 mm, an aperture diameter of 14 mm, and the shutter speed is set to 1/10 s. What f-number setting would be required in order that the same camera sensor receive the same light intensity (brightness) if the shutter speed is now set to 1/40 s?
‏1. The impeller in a centrifugal pump has inner diameter as 125 mm and outer diameter...
‏1. The impeller in a centrifugal pump has inner diameter as 125 mm and outer diameter as 270 mm. The pump runs at 1400 rpm. The vane angles of impeller at inlet and outlet are 17° and 30° respectively. The water enters the impeller radially and velocity of flow is constant. Determine the work done by impeller per unit weight of water.
A 5.0 mL syringe has an inner diameter of 5.5 mm , a needle inner diameter...
A 5.0 mL syringe has an inner diameter of 5.5 mm , a needle inner diameter of 0.22 mm , and a plunger pad diameter (where you place your finger) of 1.2 cm. A nurse uses the syringe to inject medicine into a patient whose blood pressure is 140/100. Assume the liquid is an ideal fluid. Part A What is the minimum force the nurse needs to apply to the syringe? Part B The nurse empties the syringe in 4.9...
A 4.5 mL syringe has an inner diameter of 6.0 mm , a needle inner diameter...
A 4.5 mL syringe has an inner diameter of 6.0 mm , a needle inner diameter of 0.29 mm , and a plunger pad diameter (where you place your finger) of 1.2 cm. A nurse uses the syringe to inject medicine into a patient whose blood pressure is 140/100. Assume the liquid is an ideal fluid. A. What is the minimum force the nurse needs to apply to the syringe? B. The nurse empties the syringe in 5.0 s ....
A tube has a diameter of 0.87 mm and is placed vertically in a liquid of...
A tube has a diameter of 0.87 mm and is placed vertically in a liquid of density 879 km/m^3, which rises 3.7 cm in the tube. The contact angle is 17 degrees between the liquid and tub. What is the surface tension of the liquid?
A hollow, round column has length (L = 1500 mm), outside diameter (do = 20 mm)...
A hollow, round column has length (L = 1500 mm), outside diameter (do = 20 mm) and inside diameter (di = 14 mm). If the column is made of steel (E = 207 GPa, Sy = 300 MPa), then determine if it is a Johnson or an Euler column and find the critical load Pcr for each of the following end-conditions: (a) Pinned-pinned (b) Fixed-pinned (c) Fixed-fixed (d) Fixed-free
An ACME double-threaded power screw has 45 mm major diameter, a pitch of 5 mm and...
An ACME double-threaded power screw has 45 mm major diameter, a pitch of 5 mm and thread angle 2α=29°. A vertical load on the screw reaches a maximum of 8.5 kN. The coefficients of friction are 0.05 for the thread and 0.1 for the collar. The frictional diameter of the collar is 65 mm. a) Find the efficiency of the power screw. b) Is this power screw self-locking? Explain why
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT