Question

In: Physics

A steel tank is completely filled with 1.60 m3m3 of ethanol when both the tank and...

A steel tank is completely filled with 1.60 m3m3 of ethanol when both the tank and the ethanol are at a temperature of 35.0 ∘C∘C.

A)When the tank and its contents have cooled to 18.0 ∘C∘C, what additional volume of ethanol can be put into the tank?

Expert Solution

change in volume for ethanol;

new volume of ethanol;

change in volume for steel;

new volume of tank;

Additional volume of ethanol can be put into the tank = new volume of tank - new volume of ethanol;

genius_generous answered 3 years ago

A large storage tank with an open top is filled to a height h0. The tank...

A large storage tank with an open top is filled to a height h0. The tank is punctured at a height h above the bottom of the tank. Find an expression for how far from the tank the exiting stream lands. (Let d be the horizontal distance the stream of water travels. Use any variable or symbol stated above as necessary. ? for the density of water and g. Do not substitute numerical values; use variables only.)

A storage tank contains ethanol. As liquid ethanol is taken from the lower part of the...

A storage tank contains ethanol. As liquid ethanol is taken from the lower part of the tank, nitrogen is fed into the upper part of the tank so that the pressure above the liquid in the tank is always 780 mmHg. Currently the depth of the liquid ethanol in the tank is 1.2 m. It is a summer day. The temperature in the tank is 50 OC. (a) If you took a sample of the vapor in the tank, what...

An open empty tank (filled with atmospheric air at 27oC and 100 kPa) is filled with...

An open empty tank (filled with atmospheric air at 27oC and 100 kPa) is filled with liquid nitrogen as much as 14 kg quickly. After that, the tank is immediately closed and allowed to stand for a certain period of time. The tank is equipped with an open pipe manometer where the manometer fluid used is mercury (s.g. = 13.55). In the condition of the closed tank, the results of reading the manometer when it is constant shows that the...

The PLC program simulates a process tank being filled with a fluid. The tank will start...

The PLC program simulates a process tank being filled with a fluid. The tank will start filling (via a valve) whenever the start process button is enabled and the tank is below 50% full. It will shut off when the tank is 100% full. In case the level sensor is out of calibration or not working properly, there is a high-level safety limit to prevent the tank from overfilling. If the high limit is met at a preset value of...

A steel storage tank 20m in diameter will be used to hold liquid petroleum product. When...

A steel storage tank 20m in diameter will be used to hold liquid petroleum product. When filled, the tank causes a bearing pressure of 150kPa. The soil underlying the tank has a unit weight of 16.5kN/m3 above the water table and 19.8kN/m3 below the water table. For a depth of 10m below the base of the tank, compute the effective vertical stress when the tank is empty and when it is full, for points under the center and the edge....

A closed, rigid tank is filled with water. Initially, the tank holds 0.6 lb of saturated...

A closed, rigid tank is filled with water. Initially, the tank holds 0.6 lb of saturated vapor and 6.0 lb of saturated liquid, each at 212°F. The water is heated until the tank contains only saturated vapor. Kinetic and potential energy effects can be ignored. Determine the volume of the tank, in ft3, the temperature at the final state, in °F, and the heat transfer, in Btu.

An 800-gallon, 1.2 m wide cylindrical water tank is filled to the brim. The tank has...

An 800-gallon, 1.2 m wide cylindrical water tank is filled to the brim. The tank has a hole formed at 13.3 cm above the ground. It is observed that water leaks out of the reservoir at a speed that reduces by 3.2 m.s-1 in 1 minute 39 seconds. If the tank was initially filled to the brim how much water leaked out of the tank, and 8.2 by how much shall the point, at which water lands, change? (1 gallon...

Problem 3.034 A closed, rigid tank is filled with water. Initially, the tank holds 0.4 lb...

Problem 3.034 A closed, rigid tank is filled with water. Initially, the tank holds 0.4 lb of saturated vapor and 4.0 lb of saturated liquid, each at 212°F. The water is heated until the tank contains only saturated vapor. Kinetic and potential energy effects can be ignored. Determine the volume of the tank, in ft3, the temperature at the final state, in °F, and the heat transfer, in Btu.

A tank whose bottom is a mirror is filled with water to a depth of 19.4...

A tank whose bottom is a mirror is filled with water to a depth of 19.4 . A small fish floats motionless 7.10 under the surface of the water. part A) What is the apparent depth of the fish when viewed at normal incidence to the water? Express your answer in centimeters. Use 1.33 for the index of refraction of water. Part B) What is the apparent depth of the reflection of the fish in the bottom of the tank...

A balloon is filled up completely with helium gas and left in a room with a...

A balloon is filled up completely with helium gas and left in a room with a controlled temperature of 230C. After two days of being in the same room, the balloon was found to have shrunk to half its filled-up size. However, there was no leakage of helium gas from the balloon during the two days. Explain what happened to the pressure inside the balloon due to the change in the size of the balloon. ? Use Boyle's Law to explain...