PLEASE BREIFLY STATE THE DESCRIPTIONS OF FOLLOWING:
Circuit breaker
Relay
Fuse
AutoRecloser
Latching current
Holding current
Thrysitor
Choppter
Inverter
PLEASE BREIFLY DISCUSS EACH AND DRAW THE CIRCUIT DIAGRMAm OF EACH WITH THE EQUATION INVOLVED WITH EXPLANATIONS
In: Electrical Engineering
mention some technologies used in 5G?
In: Electrical Engineering
what characteristic of an LED is critical to successful charlieplexing but not important for traditional multiplexing?
In: Electrical Engineering
Discussion of electromagnetic principles that enable motion in servo motor
In: Electrical Engineering
Write short notes on the following
(a) Floating input (b) setpoint (c) CMRR
In: Electrical Engineering
What are the properties of Biosignals ( i.e. signals generated from Biological sources like ECG, EMG, EEG etc. ) How does an OPAMP based circuit address this issues?
In: Electrical Engineering
In: Electrical Engineering
Conclude the accuracy of real-time measurements by using DAQ.
In: Electrical Engineering
Project Description:
Utilizing the 8x8 dot matrix display the smile face and then rotate the face 90 degrees at a time until the face is back to the original position. The face can be rotated clockwise or counter clockwise. Place a 1 second delay for each 90 degree rotation.
Provide pictures of the smile in each position
Provide the following:
Code listing.
Electronic Parts used:
8x8 dot matrix
Resistors (recommended but optional)
Electronic pictures of your setup.
Schematic of circuit.
d. Hand in project both electronically and hard copy.
In: Electrical Engineering
VLSI:
Show the timing constraints that might be required between the end of one four-cycle handshake to the beginning of the next.
In: Electrical Engineering
Implement the synchronous 2-bit Up/Down counter with saturation at the end states. The flip-flop outputs Q1, Q0 serve as the outputs of the counter. The counting direction is set with mode control input M. With M =1 the flip-flop outputs follow the incrementing binary sequence starting from a current state with saturation at state 11 as shown in the following example: 00-> 01-> 10-> 11-> 11-> 11... With M =0 the outputs follow the decrementing binary sequence from a current state with saturation in state 00 as illustrated below: 11-> 10-> 01->00->00->00... Obtain the state table, the flip-flop input excitation equations and implement them with any number of 2-to-1 multiplexers. Inverters can be used. Obtain the counter schematic.
In: Electrical Engineering
Assignment:
Prepare an essay (of approximately 250 words), that utilizes critical thinking*, in considering the issues surrounding the question: Does Solar Energy have a future in World Developing Nations?
In: Electrical Engineering
1.) Explain the difference between a time domain signal and a frequency domain signal.
2.) When would you select the frequency domain signal over the time domain signal.
In: Electrical Engineering
1.) Discuss the concept of an alias signal and how do we prevent this from occurring.
2.) In a control system the safety loop should be (part of) or (external to) the main control loop?
In: Electrical Engineering
Given the following register settings in a PIC32MX, give the
sampling sequence that takes place showing what buffer(s) is/are
filled by what input (including which MUX) and show when an
interrupt would be generated.
AD1CON2 = 0x00000008
AD1CHS = 0x86080000
AD1CSSL = 0x0000004F
In: Electrical Engineering