Question

In: Physics

A resistor R = 475 Ohm and an inductor of L = 1.4 H are used...

A resistor R = 475 Ohm and an inductor of L = 1.4 H are used in and RL circuit to control the timing of some device. What time constant does this device exhibit?

Question options:

2.9 ms

67 ms

39 ms

29 ms

none of these

Question

A long wire carries a steady current of I = 5.5 A. What is the strength of the magnetic field 5.5 cm away from the wire?

Question options:

5.5 x 10^-7 T

2.0 x 10^-6 T

none of these

2.0 x 10^-5 T

5.5 x 10^-5 T

Question

An ideal step up transformer changes 12.5 V in the primary to 118 V in the secondary. How much current is in the secondary if there is 0.475 A in the primary?

Question options:

0.503 A

0.0503 A

none of these

5.03 A

50.3 A

Question

A 400. turn solenoid, 24 cm long, has a diameter 2.2 cm. A 12-turn coil is wound tightly around the center of the solenoid. If the current in the solenoid increases by 3.5 A/s, what will be the induced emf in the short coil?

Question options:

0.33 micro V

33 micro volts

3.3x10^2 micro V

none of these

3.3 micro volts

Solutions

Expert Solution


Related Solutions

A 10.0 v battery, a 5.00 ohm resistor, and a 10.0 H inductor are connected in...
A 10.0 v battery, a 5.00 ohm resistor, and a 10.0 H inductor are connected in series. After the current in the circuit has reached its maximum value, calculate (a) the power being supplied by the battery, (b) the power being delivered to the resistor, (c)the power being delivered to the inductor, and (d) the energy stored in the magnetic field of the inductor.
In a RLC circuit of 60 ohm resistor, a 0.1 H inductor, and a 30 microfarad...
In a RLC circuit of 60 ohm resistor, a 0.1 H inductor, and a 30 microfarad capacitor. it is attached to a 120/60 Hz household power line. calculate: a) peak current b) the phase angle c) the average power loss d) resonance frequency e) maximum possible current?
An LRC series circuit consists of a 3.15 H inductor, a 6.36 ohm resistor, and a...
An LRC series circuit consists of a 3.15 H inductor, a 6.36 ohm resistor, and a 5.48 microFarand capacitor. The combination is connected to an AC votage source that has a peak voltage of 147 V and an angular frequency of 441 rad/s. What is the peak voltage measured across the inductor?
A resistor of R = 10 Ω is connected in series with an inductor of L...
A resistor of R = 10 Ω is connected in series with an inductor of L = 2 H and a direct voltage source of 50 V forming an RL circuit. Determine the current at time t, assuming that current does not initially flow through the circuit. What is the maximum current flowing through the circuit? In what time is half the maximum current reached?
In the given circuit an inductor of L = 8.95-mH and a resistor of R =...
In the given circuit an inductor of L = 8.95-mH and a resistor of R = 17.9-Ω resistor are connected in series with a dc battery of E = 8.80-V. What is the voltage across the resistor immediately after the switch is closed? What is the voltage across the resistor after the switch has been closed for a long time? What is the current in the inductor after the switch has been closed for a long time?
A circuit is consisted of an inductor L, a capacitor C, and a resistor R. It...
A circuit is consisted of an inductor L, a capacitor C, and a resistor R. It is driven by an AC voltage of the form ?0sin (??). At the steady state, find (a) the charge and current as a function of time (b) the maximum amplitude of the current and the corresponding resonance frequency (c) the average power at the current’s resonance frequency (c) the quality factor Q
A 20 volt battery is connected in series to an inductor and a 2 Ohm resistor....
A 20 volt battery is connected in series to an inductor and a 2 Ohm resistor. After 8.36 milli-seconds, the current in the circuit is 6.30 A. What is the time constant of the circuit in milli-seconds?
Just need E A resistor R = 6 Ωis connected in series with an inductor L...
Just need E A resistor R = 6 Ωis connected in series with an inductor L = 135 mH and a battery V = 12 volts at t = 0. a) What is the time constant of this LR circuit? b) How many seconds will it take for the voltage across the inductor to equal 10 volts? c) How many seconds will it take for the current to increase to 80% of its maximum value? d) How many seconds will...
One RL series circuit contains the resistor R1= 2 Ω and inductor L = 10 H....
One RL series circuit contains the resistor R1= 2 Ω and inductor L = 10 H. (i) Write the first order differential equation for this circuit in time constant form. (ii) Determine the time constant for this system (iii) Calculate the steady state gain of the system. (iv) Determine the time constant and steady state gain when the inductance is doubled (v) In the context of positioning of poles on the S-plane, what does the ‘real part’ represent and what...
In a series R-L-C circuit, R= 360 ohm , L= 0.410 H and C= 1.1*10^-2 micro...
In a series R-L-C circuit, R= 360 ohm , L= 0.410 H and C= 1.1*10^-2 micro F. 1.What is the resonance angular frequency of the circuit? 2. The capacitor can withstand a peak voltage of 550 V. If the voltage source operates at the resonance frequency, what maximum voltage amplitude can it have if the maximum capacitor voltage is not exceeded?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT