At time t = -250/6 μs a sinusoidal voltage is zero and is increasing. The next...

a) Write the instantaneous voltage equation.

b) The value, in module, of the inductor's reactance.

c) The phasor value of the effective current flowing through the circuit.

d) Draw the phasor diagram of the voltage and current.

e) If the frequency of the voltage signal is reduced in half, determine the modulus of the effective current flowing through the inductor

Solutions

Expert Solution

Manojponduru answered 1 month ago

Next > < Previous

Related Solutions

At time t = -250/6 μs a sinusoidal voltage is zero and is increasing. The next...

At time t = -250/6 μs a sinusoidal voltage is zero and is increasing. The next zero voltage takes place at t = 1250/6 μs and t = 0, it has a value equal to 75 V. This voltage is applied to an inductor, whose inductance is equal 0,0041 H a) Write the instantaneous voltage equation. b) The value, in module, of the inductor's reactance. c) The phasor value of the effective current flowing through the circuit. d) Draw the...

Suppose we have a 10-Hz sinusoidal voltage source, vin(t). Draw the diagram of a circuit that...

Suppose we have a 10-Hz sinusoidal voltage source, vin(t). Draw the diagram of a circuit that clamps the positive peaks to −4V. The circuit should be composed of ideal diodes, dc voltage sources, and other components as needed. List any constraints that should be observed in selecting component values. Be sure to label the terminals across which the clamped output waveform vo(t) appears.

Given a sinusoidal signal: x(t) = Asin(2πft) Find Fourier Transform (FT) of the sinusoidal x(t) given...

Given a sinusoidal signal: x(t) = Asin(2πft) Find Fourier Transform (FT) of the sinusoidal x(t) given above and plot the spectrum with: a. A = 2, f = 1000Hz b. A = 2, f = 9000Hz c. A = 5, f = 1000Hz d. A = 10, f = 10000Hz

explain the following, enhance will sketches and describe the output voltage. - Sinusoidal PWM - Full...

explain the following, enhance will sketches and describe the output voltage. - Sinusoidal PWM - Full bridge inverter single phase - Bipolar PWM single phase inverter - Uni-polar WM single phase inverter - three phase inverter

A 325 V sinusoidal voltage generator at 50 Hz supplies a load modelled by a 35...

A 325 V sinusoidal voltage generator at 50 Hz supplies a load modelled by a 35  resistance in series with a 95.5 mH inductor. The loss of the transmission line between the generator and the load is modelled by a series resistance of 5 . Calculate the average, reactive and apparent power a) consumed by the generator, b) consumed by the load. Determine the power factor at which the load is operating. Please outline the method clearly. Answers should...

1.If an inverting voltage amplifier with a large gain were built to amplify a small sinusoidal...

1.If an inverting voltage amplifier with a large gain were built to amplify a small sinusoidal signal and the output waveform was observed to be sinusoidal but with a much lower amplitude than predicted by a theoretical analysis assuming an ideal operational amplifier, what non ideal property of the operational amplifier would be likely contributing to this degradation in performance? 40

1. A sinusoidal voltage wave on a transmission line has real amplitude, V_0. The wave is...

1. A sinusoidal voltage wave on a transmission line has real amplitude, V_0. The wave is expressed in phasor form as V_s(z) = V_0*e^(-alpha*z)*e^(-j*(beta)*z) a. In which direction does this wave propagate and why? b. Express the given wave in real instantaneous form. c. The parameters of the line, operating at ω= 6.0×10^8 rad/s are L = 0.350 μH/m, C = 40.0 pF/m, G = 0 and R = 15.0 Ω/m. Find α,β,λ, andZ_0 (in magnitude and phase). d. Calculate...

Do the VCO operate at the zero tuning voltage?

Does increasing the voltage of the stimulus result in an increasing force of contraction? Discuss why....

Does increasing the voltage of the stimulus result in an increasing force of contraction? Discuss why. - please do not include neuromuscular junctions and motor neurons, they were not used in the experiment

The price of a zero-coupon bond (ZCB) that matures at time t=10 and that has face...

The price of a zero-coupon bond (ZCB) that matures at time t=10 and that has face value 100 is $61.62 Build an n = 10 binomial model lattice model with the following parameters to compute the price of a forward contract on the same ZCB where the forward contract matures at time t = 4 r0,0 = 5% u = 1.1 d = 0.9 q = 1 - q = ½

Subjects