Question

In: Chemistry

Compute the pressure in bar of hydrogen gas produced at 311 K in a container of...

Compute the pressure in bar of hydrogen gas produced at 311 K in a container of volume 1.59 L that results when 2.34 g of aluminum react with 103 mL of a 0.359 mol L-1 sulfuric acid solution.
You must write the chemical equation, balance it, work the stoichiometry problem and finally use the ideal gas law. The reaction produces aluminum sulfate and hydrogen gas.

P = _____________bar

Solutions

Expert Solution


Related Solutions

Flue gas from a methane combustor is at 1400 K and 1 bar pressure for stoichiometric...
Flue gas from a methane combustor is at 1400 K and 1 bar pressure for stoichiometric combustion with air. Estimate the radiant heat transfer to the walls of a 0.50-m square duct maintained at 700 K. Assume the walls are black. Repeat the calculation for an excess air ratio of 2.
1.sample of a gas is in a sealed container. The pressure of the gas is 345...
1.sample of a gas is in a sealed container. The pressure of the gas is 345 torr , and the temperature is 43 ∘ C . If the temperature changes to 93 ∘ C with no change in volume or amount of gas, what is the new pressure, P 2 , of the gas inside the container? Using the same sample of gas (P1 = 345 torr , T1 = 43 ∘C ), we wish to change the pressure to...
PART A A sample of ideal gas is in a sealed container. The pressure of the...
PART A A sample of ideal gas is in a sealed container. The pressure of the gas is 735 torr , and the temperature is 22 ∘C . If the temperature changes to 76 ∘C with no change in volume or amount of gas, what is the new pressure, P2, of the gas inside the container? Express your answer with the appropriate units. PART B Using the same sample of gas (P1 = 735 torr , T1 = 22 ∘C...
Pure hydrogen is contained in a long cylindrical container at a pressure of 10 ATM and...
Pure hydrogen is contained in a long cylindrical container at a pressure of 10 ATM and a temperature of 325 K. The inner diameter of the container is 50 mm and the wall thickness is 4 mm. Air flowing outside of the container does not contain any hydrogen. The mass diffusivity and the solubility of hydrogen in the container material are 1.8x10-11 m2/s and 16 kmol/(m3 ATM), respectively. (a) What is the rate of hydrogen transfer through the walls of...
Hydrogen and chlorine gas are placed in a 10.0 L container and allowed to react. The...
Hydrogen and chlorine gas are placed in a 10.0 L container and allowed to react. The initial density of the mixture is 5.01 x10-3 gm/ml. The vessel is at 300K and the initial pressure is 6.52 atm. After the reaction is complete , the pressure is 6.52 atm. The gas is bubbled into 1.00 liter of deionized water. In another part of the universe, a grey haired chemistry instructor prepares an acetic acid/ acetate buffer. The buffer was prepared by...
A gas at a pressure of 2.00 atm is contained in a closed container. Indicate the...
A gas at a pressure of 2.00 atm is contained in a closed container. Indicate the changes in its volume when the pressure undergoes the following changes at constant temperature. (Assume that the volume of the container changes with the volume of the gas.) Part A The pressure increases to 8.50 atm . Give your answer as a factor. Vo is the original volume of the gas (container). V1 =
What is the pressure (in millimeters of mercury) inside a container of gas connected to a...
What is the pressure (in millimeters of mercury) inside a container of gas connected to a mercury-filled open-end manometer of the sort shown in Figure 9.4 in the textbook when the level in the arm connected to the container is 18.0 cm lower than the level in the arm open to the atmosphere, and the atmospheric pressure reading outside the apparatus is 765.3 mm Hg ?
Evaluate the fugacity for a gas of Ar at 100 bar and 298 K
Evaluate the fugacity for a gas of Ar at 100 bar and 298 K
4- Hydrogen and chlorine gas are placed in a 10.0 L container and allowed to react....
4- Hydrogen and chlorine gas are placed in a 10.0 L container and allowed to react. The initial density of the mixture is 5.01 x10-3 gm/ml. The vessel is at 300K and the initial pressure is 6.52 atm. After the reaction is complete , the pressure is 6.52 atm. The gas is bubbled into 1.00 liter of deionized water. In another part of the universe, a grey haired chemistry instructor prepares an acetic acid/ acetate buffer. The buffer was prepared...
a) clculate the partial pressure (in atm) of Ne and Ar in the container. gas mixture...
a) clculate the partial pressure (in atm) of Ne and Ar in the container. gas mixture in a 1.45 L at 298 K container contains 10.0 g of Ne and 10.0 g of Ar. Calculate the partial pressure (in ) of and in the container. PNe = 4.22 atm , PAr = 4.22 atm PNe = 8.36 atm , PAr = 4.22 atm PNe = 8.36 atm , PAr = 8.36 atm PNe = 4.22 atm , PAr = 8.36...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT