Question

In: Physics

A) A henry inductor, a 9 ohm resistor, a .05=1/20 farad capacitor are placed in series...

A) A henry inductor, a 9 ohm resistor, a .05=1/20 farad capacitor are placed in series and attached to a 9 volt battery to complete the circuit. Find the function for the charge on the circuit at time t if an initial charge of 10 coulombs and an initial response of 10 amps are applied to the circuit at time 0.

b) What is the charge on the capacitor after 1 second?

c) Plot the function for the charge on the capacitor over the first second.

Solutions

Expert Solution


Related Solutions

A 20 volt battery is connected in series to an inductor and a 2 Ohm resistor....
A 20 volt battery is connected in series to an inductor and a 2 Ohm resistor. After 8.36 milli-seconds, the current in the circuit is 6.30 A. What is the time constant of the circuit in milli-seconds?
An inductor (0.2 Henry) and a resistor (2ohms) are connected in series with a battery of...
An inductor (0.2 Henry) and a resistor (2ohms) are connected in series with a battery of EMF 5.0 volts. a) Draw the circuit (don't forget the switch) b) At time t=0 and time= infinity find the current that passes through the battery c) What's the time constant for the circuit? d) What's the back EMF provided by the inductor at t= 1.0 sec? e) What's instantaneous energy saved in the inductor at time t= 1.0 sec? f) What is the...
An LRC series circuit consists of a 3.15 H inductor, a 6.36 ohm resistor, and a...
An LRC series circuit consists of a 3.15 H inductor, a 6.36 ohm resistor, and a 5.48 microFarand capacitor. The combination is connected to an AC votage source that has a peak voltage of 147 V and an angular frequency of 441 rad/s. What is the peak voltage measured across the inductor?
a circuit that has a resistor, capacitor, and inductor in series with a 5V AC voltage...
a circuit that has a resistor, capacitor, and inductor in series with a 5V AC voltage source R = 5 Ω; L = 1 mH; C = 447 a) Find ω0 and f0 b) Complete the table f = f0 f = 0.5f0 f = 1.5f0 I VL Vc c) What is the phase between circuit current and applied voltage at f = f0 (in radians) d) Determine if the below statements are true or false Below resonance (f <...
10.An AC voltage source is connected in series to an inductor, a capacitor, and a resistor...
10.An AC voltage source is connected in series to an inductor, a capacitor, and a resistor of 8 Ohms. At the frequency when the phase angle is zero, capacitive reactance is 7 Ohms. What is the phase angle between the current and voltage at a frequency which is a factor of 3.2 times less than this frequency? answer in degresss and if negative 6. the resistance of a coil spun in a generator is 2 Ohms. the coil is in...
A 3 Ohm resistor is connected in series with a 5 Ohm resistor to a battery....
A 3 Ohm resistor is connected in series with a 5 Ohm resistor to a battery. Which of the following statements are true (more than one can be true)? Group of answer choices A )The current flowing in each resistor is the same. B)The current through the 5 Ohm resistor is lower. C)The power loss in the 5 Ohm resistor is greater. D)The potential difference across both resistors is the same. E)The potential difference across the 3 Ohm resistor is...
A 3 Ohm resistor is connected in series with a 5 Ohm resistor to a battery....
A 3 Ohm resistor is connected in series with a 5 Ohm resistor to a battery. Which of the following statements are true (there can be more than one)? a) The power loss in the 5 Ohm resistor is greater. b) The current through the 5 Ohm resistor is lower. c) The potential difference across both resistors is the same. d) The potential difference across the 3 Ohm resistor is higher. e) The current flowing in each resistor is the...
A series AC circuit contains a resistor, an inductor of 240 mH, a capacitor of 5.40...
A series AC circuit contains a resistor, an inductor of 240 mH, a capacitor of 5.40 µF, and a source with ΔVmax = 240 V operating at 50.0 Hz. The maximum current in the circuit is 170 mA. (a) Calculate the inductive reactance. _________________Ω (b) Calculate the capacitive reactance. ______________-Ω (c) Calculate the impedance. _______________kΩ (d) Calculate the resistance in the circuit. ______________kΩ (e) Calculate the phase angle between the current and the source voltage. _______________°
An RLC series circuit has a 2.60 ? resistor, a 200 µH inductor, and a 78.0 µF capacitor.
  An RLC series circuit has a 2.60 ? resistor, a 200 µH inductor, and a 78.0 µF capacitor. (a) Find the circuit's impedance (in ?) at 120 Hz. (b) Find the circuit's impedance (in ?) at 5.00 kHz. (c) If the voltage source has Vrms = 5.60 V, what is Irms (in A) at each frequency? Irms, 120 Hz =_____ A Irms, 5.00 kHz =_____A (d) What is the resonant frequency (in kHz) of the circuit? (e) What is...
A resistor R = 475 Ohm and an inductor of L = 1.4 H are used...
A resistor R = 475 Ohm and an inductor of L = 1.4 H are used in and RL circuit to control the timing of some device. What time constant does this device exhibit? Question options: 2.9 ms 67 ms 39 ms 29 ms none of these Question A long wire carries a steady current of I = 5.5 A. What is the strength of the magnetic field 5.5 cm away from the wire? Question options: 5.5 x 10^-7 T...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT