Question
In: Other
Air at a temperature of 20 0C and 750 mm Hg has a relative humidity of...
Air at a temperature of 20 0C and 750 mm Hg has a relative humidity of 80%. Calculate,
(i)The molal humidity of the air
(ii)The molal humidity of this air if its temperature is reduced to 10 °C and pressure increased to 2000 mm Hg condensing out some of the water
(iii)Weight of water condensed from 1000 litre of the original wet air
Vapour pressure of water at 20 °C = 17.5 mm Hg
Vapour pressure of water at 10 °C = 9.2 mm Hg
Solutions
Amanda K answered 6 months agoRelated Solutions
If at 30F the air has 25% relative humidity, what is the relative humidity at 70F...
If at 30F the air has 25% relative humidity, what is the
relative humidity at 70F and how much moisture must be added to get
it up to 50% relative humidity.
At 200 C relative humidity of 1 m3 of air is 60%. when temperature is kept...
At 200 C relative humidity of 1 m3 of air
is 60%. when temperature is kept constant and volume is reduced to
0.25 m3 find the mass of moist air that would be
condensed.
SVP of water at 200 C = 17.5mmHG R= 8.31 J
mol-1 K-1
I need answers on 3.2.4 3.2.3 If the air temperature is 15°C and the relative humidity...
I need answers on 3.2.4
3.2.3 If the air temperature is 15°C and the relative humidity
35 percent, calculate the vapor pressure, specific humidity, and
air density. Assume standard atmospheric pressure (101.3 kPa).
3.2.4 Solve Prob. 3.2.3 if the air temperature rises to 300C. By
what percentage does the specific humidity increase as a result of
the temperature rise from 15 to 300C?
In a low temperature drying system, air at 60°C and 10% Relative humidity passes over a...
In a low temperature drying system, air at 60°C and 10% Relative
humidity passes over a bed of diced carrots at 20 kg-dry air/sec.
The rate of water removal from the carrots Is measured by
difference in total weight over time and found to be approximately
.16 kg-water/sec. In the system described above, calculate the
temperature and relative humidity of the air exiting the drying
system.
300% excess air having a dry bulb temperature of 25 degree celsius and relative humidity of...
300% excess air having a dry bulb temperature of 25 degree
celsius and relative humidity of 60% is used to fully combust 1
kg/hr of methane in a boiler and the heat of reaction is used to
generate steam. Hot water enters the boiler as a saturated liquid
at 102 degree celsius and leaves as superheated at 40 bar and 400
degree celsius.
The combusted gases leave the boiler at 450 degree celsius and
are then cooled to 25 degree...
Moist air at 55 oF dry bulb temperature and 40% relative humidity is first heated through...
Moist air at 55 oF dry bulb temperature and 40% relative
humidity is first heated through a heating coil. The air is then
adiabatically humidified by saturated water vapor at 4.5 psia. The
exit air has a dry bulb temperature of 90 oF and wet bulb
temperature 65 oF. Air is supplied at a volume flow rate of 478.5
cfm. Assume sea level pressure throughout. Determine the
following.
a) Show the inlet and outlet air condition clearly on the
psychrometric...
The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling...
The atmospheric air 32 °C dry bulb temperature and 70% relative
humidity supplied to the cooling coil at a rate of 45m3 /min. The
air cooling to the saturated state and leaving at a temperature of
16 °C. Determine: () a- Specific humidity at each state. b- Wet
bulb and dew point temperatures at the final state c- Final
relative humidity. d- Mass of water condensed. e- Rate of heat
removed from the air in kW. f- Show the process...
The atmospheric air 32 °C dry bulb temperature and 70% relative humidity supplied to the cooling...
The atmospheric air 32 °C dry bulb temperature and 70% relative
humidity supplied to the cooling coil at a rate of 45m3 /min. The
air cooling to the saturated state and leaving at a temperature of
16 °C. Determine: (10 points) a- Specific humidity at each state.
b- Wet bulb and dew point temperatures at the final state c- Final
relative humidity. d- Mass of water condensed. e- Rate of
heat removed from the air in kW. f- Show the...
Relative humidity isn't everything. Why is it that outdoor air of 80 Fo at 55% humidity...
Relative humidity isn't everything. Why is it that outdoor air
of 80 Fo at 55% humidity will feel more “muggy” than a 50 Fo cave
at 75% humidity? What other parameter is a better measure of the
actual amount of moisture in the air, and how do we define it? Then
give two examples of when keeping close track of moisture in the
air is important.
Relative humidity isn't everything. Why is it that outdoor air of 80 Fo at 55% humidity...
Relative humidity isn't everything. Why is it that outdoor air
of 80 Fo at 55% humidity will feel more “muggy” than a 50 Fo cave
at 75% humidity? What other parameter is a better measure of the
actual amount of moisture in the air, and how do we define it? Then
give two examples of when keeping close track of moisture in the
air is important.
ADVERTISEMENT
ADVERTISEMENT
Latest Questions
- Write a program that computes the tax and tip on a restaurant bill for a patron...
- clear all close all % %*******Parameter Settings******** %********************************* Fs=8192; %Sampling frequency (MATLAB's default) Ts=1/Fs; %Sampling time...
- Name a business that you believe has experienced declining costs attributable to computerization. Were variable costs...
- With C++, 1. Assume we use two linked lists that represent Set A and Set B...
- A beam of light shines on an equilateral glass prism at an angle of 45∘ to...
- This is an intro to python question. #Write a function called search_for_string() that takes two #parameters,...
- C++ Give an example of overloading by implementing a function square(x), which calculates the square of...
ADVERTISEMENT