Question

In: Physics

a. Laser light comes in to a rectangular block of thick (12 cm) glass with an...

a. Laser light comes in to a rectangular block of thick (12 cm) glass with an incident angle (relative to normal) of 25 degrees. What angle does the light have inside and as it leaves the block, and by what distance (in cm) does it seem displaced compared to where the laser beam would be with not glass ? b If instead of laser light you were viewing an object or bug on the other side of the block, how would you perceive its location compared to its actual location.

Solutions

Expert Solution

b.) If instead of laser the bug being the object through which light is refracting through the glass slab, the shift in position of the bug would have been AA' instead of A'B. Thus, the shift in position of the image formed in case of bug is 4 cm.


Related Solutions

A laser beam enters a 19.0 cm thick glass window at an angle of 39.0° from...
A laser beam enters a 19.0 cm thick glass window at an angle of 39.0° from the normal. The index of refraction of the glass is 1.50. At what angle from the normal does the beam travel through the glass? Tries 0/20 How long does it take the beam to pass through the plate?
A rectangular block of copper has sides of length 12 cm, 26 cm, and 37 cm....
A rectangular block of copper has sides of length 12 cm, 26 cm, and 37 cm. If the block is connected to a 5.4 V source across two of its opposite faces, find the following. (a) What is the maximum current the block can carry? (b) What is the minimum current the block can carry?
A beam of light from a monochromatic laser shines into a piece of glass. The glass...
A beam of light from a monochromatic laser shines into a piece of glass. The glass has thickness L and index of refraction n=1.5 . The wavelength of the laser light in vacuum is L/10 and its frequency is f In this problem, neither the constant c nor its numerical value should appear in any of your answers. (1)How long does it take for a short pulse of light to travel from one end of the glass to the other?
A 5.3-cm-thick layer of oil (n=1.46) is sandwiched between a 1.1-cm-thick sheet of glass and a...
A 5.3-cm-thick layer of oil (n=1.46) is sandwiched between a 1.1-cm-thick sheet of glass and a 2.0-cm-thick sheet of polystyrene plastic (n=1.59). How long (in ns) does it take light incident perpendicular to the glass to pass through this 8.4-cm-thick sandwich? A 2.0-cm-wide diffraction grating has 1000 slits. It is illuminated by light of wavelength 570 nm . What are the angles of the first two diffraction orders?
A thermopane window consists of two glass panes, each 0.50 cm thick, with a 1.0 cm...
A thermopane window consists of two glass panes, each 0.50 cm thick, with a 1.0 cm thick sealed layer of air in between a) if the inside surface temperature is 22.2 c and the outside surface temperature is 0.0 c determine the rate fo energy transfer through 1.35 m^2 of the window _______W b) compare your answer to a) with the rate of energy transfer through 1.35 m^2 of a single 1.0 cm thick pane fo glass. Disregard surface air...
A beam of light hits a 2.36cm thick silicate glass plate at an angle of 64...
A beam of light hits a 2.36cm thick silicate glass plate at an angle of 64 degrees (as measured from the normal to the surface of the glass). If the coefficient of linear absorption is 0.019 cm-1 and the index of refraction is 1.417, what fraction of light is passed through the plate. The answer should have three decimals of accuracy. You Answered: .867 Correct Answer 0.888 You will need to calculate the actual distance the light travels in the...
Light strikes a flat piece of uniformly thick glass at an incident angle of 60?. If...
Light strikes a flat piece of uniformly thick glass at an incident angle of 60?. If the index of refractino of the glass is 1.5, and it has a width of 10 cm, A) What is the angle of refractino in the glass? B) What angle will the light leave the glass at on the other side?
The active element of a certain laser is made of a glass rod 29.0 cm long...
The active element of a certain laser is made of a glass rod 29.0 cm long and 1.40 cm in diameter. Assume the average coefficient of linear expansion of the glass is equal to 9.00 10-6 (°C)−1. The temperature of the rod increases by 62.0°C. (a) What is the increase in its length? . cm (b) What is the increase in its diameter?. cm (c) What is the increase in its volume? cm3
The rectangular block below has front-face dimensions of 10 cm by 4 cm, with a depth...
The rectangular block below has front-face dimensions of 10 cm by 4 cm, with a depth of 3 cm.(Figure 1) You will be asked to treat this object as an electrical resistor. Rank the block based on its electrical resistance along the three illustrated coordinate directions (x, y, and z). Rank from largest to smallest. To rank items as equivalent, overlap them. PART B: If all of the dimensions of the block double (to become 20 cm wide, 8 cm...
A ray of light traveling in a block of glass (n=1.52) is incident on the top...
A ray of light traveling in a block of glass (n=1.52) is incident on the top surface at an angle of 57.4? with respect to the normal in the glass. If a layer of oil is placed on the top surface of the glass, the ray is totally reflected. What is the maximum possible index of refraction of the oil?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT