Question

In: Other

Two flash resistance drums operated at 101.3 kPa are connected continuously. You want to separate the...

Two flash resistance drums operated at 101.3 kPa are connected continuously.
You want to separate the hexaneooctane mixture. (Make the effective number two digits.

(a) fed feed with a zhexane of 0.3, 900 lbmol/hr, making V/F one-third flash at this time
How much is the liquid and vapor composition (yhexane,1, xhexane,1) of the hexane leaving the drum?
(b) (a) where the vapor disillate obtained through the problem is to be re-separated using the flash resistance drum;
All. The hexane composition (yhexane,2) of the projector stream leaving the second flash drum is to be 0.6
Calculate V2, L2, xhexane,2.

Solutions

Expert Solution


Related Solutions

Two parallel rails with negligible resistance are 10.0 cm apart and are connected by a resistor...
Two parallel rails with negligible resistance are 10.0 cm apart and are connected by a resistor of resistance R3=5.00Ω . The circuit also contains two metal rods having resistances of R1= 10.0 Ω and R2 = 15.0 Ω sliding along the rails (Fig. P31.31). The rods are pulled away from the resistor at constant speeds of v1= 4.00 m/s and v2= 2.00 m/s, respectively. A uniform magnetic field of magnitude B =0.0100 T is applied perpendicular to the plane of the rails. Determine...
1. Show that when two equal resistances are connected in parallel the equivalent resistance is just...
1. Show that when two equal resistances are connected in parallel the equivalent resistance is just one half that of either resistor. 2. Suppose that we replaced one of the bulbs in the setup with one rated at 6V, 7.5W. show that a 1A fuse in the circuit would blow out when this bulb is given power. What is the operating resistance of the filament in this bulb? Show Calculation
​Two parallel rails with negligible resistance are 10.0 cm apart and are connected by a 5.00 Ω resistor.
Two parallel rails with negligible resistance are 10.0 cm apart and are connected by a 5.00 Ω resistor. The circuit also contains two metal rods having resistances of 10.0 Ω and 15.0 Ω sliding along the rails. The rods are pulled away from the resistor at constant speeds of 4.00 m/s and 2.00 m/s, respectively. A uniform magnetic field of magnitude 0.010 T is applied perpendicular to the plane of the rails. a) Determine the power dissipated in the 5.00-Ω resistor.b)...
1. You want to separate two proteins, Protein A and Protein B, using ion exchange chromatography....
1. You want to separate two proteins, Protein A and Protein B, using ion exchange chromatography. Protein A has a pI of 4, and Protein B has a pI of 8. a) To get optimal separation of your proteins, what pH should your elution buffer be? ____________ b) At your chosen pH, would the charge on Protein A be ¨ positive, ¨ negative, or ¨ neutral? c) What about the charge on Protein B at the chosen pH? It is...
In genetics when using gel electrophoresis there are many decisions. If you want to separate fragments...
In genetics when using gel electrophoresis there are many decisions. If you want to separate fragments that are very close in size you should use a higher percentage of agarose. The power supply has two settings for voltage, 120V or 160V. It also has a timer that has 2 settings 15 minutes and 90 minutes. If you would be running whole genomic DNA samples you recently extracted and the fragments would be about 30 kb in size. If  performed a number...
You want to produce three 1.00-mm-diameter cylindrical wires, each with a resistance of 5.00 Ω at...
You want to produce three 1.00-mm-diameter cylindrical wires, each with a resistance of 5.00 Ω at room temperature. One wire is gold, one is copper, and one is aluminum. Refer to Table 25.1 in the textbook for the resistivity values. Part A What will be the length of the gold wire? Part B What will be the length of the copper wire? Part C What will be the length of the aluminum wire? Part D Gold has a density of...
Suppose you want to separate a mixture of the following compounds: benzoic acid, m-cresol, p-aminobenzophenone, and...
Suppose you want to separate a mixture of the following compounds: benzoic acid, m-cresol, p-aminobenzophenone, and napthalene. Come up with a list of steps and chemicals needed to most efficiently isolate all four compounds as solids with the greatest purity possible.
Consider that you have two blocks and they are connected to each other with a spring....
Consider that you have two blocks and they are connected to each other with a spring. Block AA  has mass 1.00 kgkg, and block BB has mass 3.00 kgkg. The blocks are compressed with a spring SS between them; then the system is released from rest on a level, frictionless surface. The spring, which has negligible mass, is not fastened to either block and drops to the surface after it has expanded. The spring has force constant 720 N/mN/m and is...
How would you resolve two DNA fragments of similar size as two separate bands on an...
How would you resolve two DNA fragments of similar size as two separate bands on an agarose gel?
Imagine you are in an open field where two loudspeakers are set up and connected to...
Imagine you are in an open field where two loudspeakers are set up and connected to the same amplifier so that they emit sound waves in phase at 688 Hz. Take the speed of sound in air to be 344 m/s. If you are 3.00 m from speaker A directly to your right and 3.50 m from speaker B directly to your left. What is the shortest distance d you need to walk forward to be at a point where...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT