Heptadecane (A) is being absorbed from a dilute gaseous mixture with 1-Octyne (B) by Hydrochloric Acid...

Heptadecane (A) is being absorbed from a dilute gaseous mixture with 1-Octyne (B) by Hydrochloric Acid in a wetted wall column. The following experimental data are available:

a. Inside diameter = 43 mm

b. Average gas velocity = 250 cm/s

c. Gas Temperature = 50 °C

d. Total Pressure = 1 atm

At a certain point in the column, the partial pressure of A in B is 30 mmhg and the mol fraction of Heptadecane at the gas side of the interface is 0.009. Predict the mass diffusivity using Fuller et. al. equation. Calculate the rate of absorption of A.

Expert Solution

First we have to calculate Diffusivity value then after General convective mass transfer equation should be taken and derive flux equation in terms of average Velocity or bulk motion of gases.

Amanda K answered 7 months ago

A solute A is being absorbed from a binary gas mixture of A and C into...

A solute A is being absorbed from a binary gas mixture of A and C into a pure solvent B in a packed tower with a cross sectional area of 0.2 m2 at a temperature of 300 K and pressure of 1 atm. The inlet gas contains 3 mol% of A and its desired to remove 85% percent of A from the gas stream. The feed gas flowrate is 14 kmol/h and the solvent flowrate is 45 kmol/h. ky’ah =...

Aluminum reacts with hydrochloric acid, but copper does not react with the acid. When a mixture...

Aluminum reacts with hydrochloric acid, but copper does not react with the acid. When a mixture of aluminum and copper having a mass of 0.3579 grams is combined with excess hydrochloric acid, 315.50 mL of hydrogen gas, measured over water, is generated. The temperature at the time of collection is 27.3 oC (vapor pressure of water at 27.3 oC = 27.214 torr), and the total pressure in the collection container is 764.1 torr. Determine the mass percentage of aluminum in...

Concentrated hydrochloric acid solution is 37.0% HCL and has a density of 1.19g/ml. A dilute solution...

Concentrated hydrochloric acid solution is 37.0% HCL and has a density of 1.19g/ml. A dilute solution of HCL is prepared by diluting 4.50mL of this acid to 100.00mL with water. Then 10.0mL of the dilute HCL is used for the reaction with AgNO3 solution as shown below: HCL(aq)+AgNO3(aq) to HNO3(aq)+AgCL(s) How many mL of 0.1105M AgNO3 solution is required to precipitate all of the chloride as AgCl(s)? Please show how you get the answer. Thank you!

Hydrochloric acid is produced by absorbing gaseous HCl (hydrogen chloride) in water. Calculate the heat that...

Hydrochloric acid is produced by absorbing gaseous HCl (hydrogen chloride) in water. Calculate the heat that must be transferred to or from an absorption unit if HCl(g) at 100°C and H2O(l) at 25°C are fed to produce 1000 kg/h of 20 wt% HCl(aq) at 40°C. Assume the heat capacity of the produced HCl is 0.557 kJ/mol HCl .°C

1.a) If ΔE > 0 then energy is being absorbed by the system. True False 1.b)...

1.a) If ΔE > 0 then energy is being absorbed by the system. True False 1.b) If ΔEsystem is positive then ΔEsurrounding must be: negative none of these positive zero 1.c) Consider the following chemical equation and calculate how much heat is released when 77.90 grams of C2H6 reacts. 2 C2H6 + 7 O2 --> 4 CO2 + 6 H2O ΔH = -385 kJ - answer should read out to one place after the decimal - do not include units 1.d)...

Chapter 15 1) The name of HClO is ________. a. hydrogen chloride b. hydrochloric acid c....

Chapter 15 1) The name of HClO is ________. a. hydrogen chloride b. hydrochloric acid c. chloric acid d. perchloric acid e. hypochlorous acid 2) Identify the Bronsted-Lowry acid in the following reaction. H2O + CO3 2- (aq) ? HCO3 - (aq) + OH- (aq) a. H2O b. CO3 2- c. HCO3 - d. OHe. H2CO3 3) What is the [H3O+] in a solution with [OH- ] = 1.0 � 10-12 M? a. 1.0 � 10-12 M b. 1.0 �...

1. A gas mixture containing a solute with a concentration of Y1=0.02 to be absorbed in...

1. A gas mixture containing a solute with a concentration of Y1=0.02 to be absorbed in a packed tower. The gas-liquid equilibrium is described by: Y*=1.0X. (a) (10%) To achieve a 99% solute recovery, calculate the required gas phase overall mass transfer unit NtOG and the composition X1 at the liquid exit. X2=0.0001 at the liquid inlet with L/G=1.2. (b) (10%) For pure liquid inlet with L/G=0.8, what is the maximum percentage solute recovery? 2. For a packed tower for...

1, Which of the following is NOT a role of Hydrochloric acid in the stomach? There...

1, Which of the following is NOT a role of Hydrochloric acid in the stomach? There may be more than one correct answer - select all that apply. Group of answer choices activate salivary amylase unraveling/ "denaturing" proteins hydrolysis of proteins digestion of polysaccharides activate pepsin 2, The standard used to estimate the average daily amount of a nutrient considered adequate to meet the 97% of the needs of most healthy people is the Group of answer choices DRI. UL....

Determine the pH of (a) 0.20 M sulfuric acid (b) 0.20 M hydrochloric acid, (c) 0.20...

Determine the pH of (a) 0.20 M sulfuric acid (b) 0.20 M hydrochloric acid, (c) 0.20 M sodium hydroxide, (d) 0.20 M acetic acid, and (e) 0.20 M solution of NH3 at 25 oC.

500mL of a dilute phosphoric acid solution was prepared. If the concentration dropped from 36% to...

500mL of a dilute phosphoric acid solution was prepared. If the concentration dropped from 36% to 2%, how much water was needed for the dilution?

Question