A geothermal single effect water lithium bromide is operating between 10 kPa and 1 kPa, and...

A geothermal single effect water lithium bromide is operating between 10 kPa and 1 kPa, and between lithium bromide concentrations of 60% and 55 0/0 . The solution heat exchanger effectiveness is 0.9. The generator temperature is 110 degrees * C and the absorber temperature is 45.81 degrees * C . The refrigerant mass flow rate is 0.2 kg/ s. Calculate

a. The cooling load of the evaporator

b. The mass flow rate of the rich solution leaving the generator

c. The condenser heat removal rate d. The coefficient of performance

e. The maximum coefficient of performance

Expert Solution

samet mamat answered 7 months ago

1) Saturated liquid water at a pressure of 10 kPa is sent to a steam boiler...

1) Saturated liquid water at a pressure of 10 kPa is sent to a steam boiler with a pressure of 4MPa with a reversible adiabatic pump and heated up to 500oC at constant pressure in the boiler. The mass flow of the steam is 4.2 kg / s. Transactions are carried out continuously. a) Show the processes on the T-v or T-s diagram with saturated vapor and liquid curves. b) Calculate the required pump power c) Calculate the amount of...

An isentropic pump compresses water between the pressures listed in Problem 1 (30 & 8000 kPa)...

An isentropic pump compresses water between the pressures listed in Problem 1 (30 & 8000 kPa) at the same mass flow rate (3 kg/s). Assuming saturated liquid conditions at the inlet of the pump, determine: a) The power required to operate the pump b) The ratio of the turbine power output from problem 1 to the required power input of the pump

An adiabatic mixing chamber with operating pressure of 180 kPa is used to mix cold water...

An adiabatic mixing chamber with operating pressure of 180 kPa is used to mix cold water and hot water. The hot water enters at 80°C with mass flow rate of 4.1 kg/s. The cold water enters the chamber at 39°C and the mixture leaves at a temperature of 45°C. Determine (a) the mass flow rate of the cold water and (b) the rate of entropy generation during this process.

1. How much energy(kJ) is required to vaporize 10 kg of water at 500 kPa? 2....

1. How much energy(kJ) is required to vaporize 10 kg of water at 500 kPa? 2. What is the state of water of 150 deg Celcius and 415.7 kPa?

In a double flash geothermal power plant, the high-pressure separator is operating at 1 MPa and...

In a double flash geothermal power plant, the high-pressure separator is operating at 1 MPa and the adiabatic low-pressure separator is operating at 300 kPa. The steam quality entering the adiabatic high-pressure separator is 0.3. The mass flow of saturated liquid leaving the low-pressure separator is 15 kgs. The exit pressure of the steam turbine is 15 kPa and the turbine isentropic efficiency is 0.8. Calculate a. The mass flow at the turbine exit b. The mass flow rate entering...

1)A geothermal reservoir in Indonesia has a downhole fluid of water at a temperature of 235°C....

1)A geothermal reservoir in Indonesia has a downhole fluid of water at a temperature of 235°C. The specific enthalpy of the fluid is 2500 kJ/kg, and consists of two phases. What is the quality of the steam?

1.there are treatments for drugs such as antidepressants, antipsychosis, lithium. describe effect, area of use side...

1.there are treatments for drugs such as antidepressants, antipsychosis, lithium. describe effect, area of use side effects. 2. in which way are prejudices against mentally ill people a threat the their health describe some examples.

1) At 24 C the vapor pressure of water is 3 kPa. The vapor pressure of...

1) At 24 C the vapor pressure of water is 3 kPa. The vapor pressure of water over a sample is 2 kPa, what is the water activity of the sample? 2) The water activity above a saturated NaCl solution is 0.75. If a sample is enclosed in a jar with the NaCl solution and equilibrium is achieved, what is the water activity of the sample? NaCl and the sample are in separate containers within the jar.

a single effect evaporator is used to concentrate a solution of 10% of total solids to...

a single effect evaporator is used to concentrate a solution of 10% of total solids to 30% of total solids at a rate of 250 kg / h. if the evaporator pressure is 77 kpa, and if steam is available at 200 kpa gauge, the amount of steam needed per hour and the area of heat transfer area if the overall heat transfer coefficient is 1700 jm -22s-1 ° C. the feed temperature is 18 ° C and the boiling...

A 200 litre tank initially contains water at 100 kPa and a quality of 1%. Heat...

A 200 litre tank initially contains water at 100 kPa and a quality of 1%. Heat is transferred to the water, thereby raising its pressure and temperature. At a pressure of 2 MPa, a safety valve opens, and saturated vapour at 2 MPa flows out. The process continues, maintaining 2 MPa inside until the quality in the tank is 90%, then stops. Determine the total mass if water that flowed out and the total heat transfer. *I’ve seen others have...

Question