1)A geothermal reservoir in Indonesia has a downhole fluid of water at a temperature of 235°C....

1)A geothermal reservoir in Indonesia has a downhole fluid of water at a temperature of 235°C. The specific enthalpy of the fluid is 2500 kJ/kg, and consists of two phases. What is the quality of the steam?

Expert Solution

by mistake, i have taken property at 335 instead of 235. now i have corrected mistake and upload steam property also at the 235 C. feel free if u have any doubt regarding same.

Amanda K answered 2 years ago

A Carnot's engine has a low temperature reservoir at 7 °C with efficiency of 40%. It...

A Carnot's engine has a low temperature reservoir at 7 °C with efficiency of 40%. It is desired to increase the efficiency to 50%. By how many degrees should the temperature of the high temperature reservoir be increased?

A binary geothermal power plant uses geothermal water at 160°C as the heat source. The plant...

A binary geothermal power plant uses geothermal water at 160°C as the heat source. The plant operates on the simple Rankine cycle with isobutane as the working fluid. Heat is transferred to the cycle by a heat exchanger in which geothermal liquid water enters at 160°C at a rate of 555.9 kg/s and leaves at 90°C. Isobutane enters the turbine at 3.25 MPa and 147°C and leaves at 79.5°C and 410 kPa. Isobutane is condensed in an air-cooled condenser and...

A refrigerator with R-410a as the working fluid has a minimum temperature of −10°C and a...

A refrigerator with R-410a as the working fluid has a minimum temperature of −10°C and a maximum pressure of 1 MPa. Assuming an ideal refrigeration cycle, find the specific heat transfer FROM the cold space, the specific heat transfer TO the hot space, and the coefficient of performance. Will this refrigeration cycle work in an ordinary kitchen?

What will be the equilibrium temperature when a 275 g block of copper at 235 ?C...

What will be the equilibrium temperature when a 275 g block of copper at 235 ?C is placed in a 135 g aluminum calorimeter cup containing 875 g of water at 14.0 ?C?

Table 1: Temperature of Frozen Water Over Time Time (min.) Temperature (°C) Observation 0 -12 Water...

Table 1: Temperature of Frozen Water Over Time Time (min.) Temperature (°C) Observation 0 -12 Water is frozen 5 0 Water is frozen 10 1 Ice is attached to thermometer but unstuck from test tube 15 14 There is a pool of water in the bottom of the test tube 20 2 The pool of water is flightly bigger, ice chunk is getting smaller 25 4 The ice chunk is over halfway melted 30 5 The Ice chunk is over...

A water has a temperature of 10o C and pH = 8. What should be the...

A water has a temperature of 10o C and pH = 8. What should be the C.t value for 3-log Giardia removal using (a) chlorine, (b) chloramine. Assume a chlorine residual of 1.0 mg/L is required. If the chlorine dosage required to achieve this residual is 1.6 mg/L, what is the chlorine requirement in lbs/d for a 2 mgd water plant.

Cooling water (T= 20 C) is pumped from a reservoir to rock drills on a construction...

Cooling water (T= 20 C) is pumped from a reservoir to rock drills on a construction job using the pipe system With Diameter D = 10 cm. The flow rate must be 130 m3/h and water must leave the spray nozzle at 30 m/s. Nozzle discharge at the 100 m above reservoir (a) Calculate the minimum pressure needed at the pump outlet. (b) Estimate the required power input if the pump efficiency is 70 percent. know that, K 1 =...

1. Your bag of fluid has 60grams of dextrose in 300ml of water. What is the...

1. Your bag of fluid has 60grams of dextrose in 300ml of water. What is the percentage of dextrose in this bag ? 2. The label on a 100 mL Vancomycin solution bag indicates a strength of 5mg/1mL. How many mg of vancomycin are in this solution? 3. How many grams of sodium are in 150ml of 0.9% NS? ROOUND TO THE NEAREST 10TH. PLACE NUMBER ONLY IN LINE PROVIDED

3 Kg mass of water is heated to a temperature of 99.5 C at 1 bar...

3 Kg mass of water is heated to a temperature of 99.5 C at 1 bar of pressure. It is slowly poured into a heavily insulated beaker containing 7.5 Kg of water at a temperature and pressure of 4 C, 1 bar, respectively. The specific heat of the water, an incompressible material is, c = 4.1 KJ/(Kg K). The beaker can be considered to be an adiabatic system. The two water mass’ reach an equilibrium temperature. There is no kinetic...

A pump having the characteristics given in Fig. 14.10 pumps water at 20°C from a reservoir...

A pump having the characteristics given in Fig. 14.10 pumps water at 20°C from a reservoir at an elevation of 366 m to a reservoir at an elevation of 450 m through a 36 cm steel pipe. If the pipe is 610 m long, what will be the discharge through the pipe? Fig. 14.10Performance curves for a typical centrifugal pump; D = 37.1 cm

Question