Sketch water surface profile in two rectangular channels that are joined with the following information. a....

Sketch water surface profile in two rectangular channels that are joined with the following information. a. Slope is changing from 0.0016 to 0.015 ? = 0.013 ? = 10 ?? ? = 400 ??? ?0−?ℎ????? 1 = 0.0016 ?0−?ℎ????? 2 = 0.015

Solutions

Expert Solution

if you have any doubts please ask me.......please upvote me. . . thank you.......have a good day

Ally Wells answered 2 months ago

Next > < Previous

Related Solutions

1. All of the following regions are given in rectangular coordinates. Give a sketch of the...

1. All of the following regions are given in rectangular coordinates. Give a sketch of the region and convert to a coordinate system, which you believe would be the most convenient for integrating over the given region, and a brief explanation as to why you chose that coordinate system. d) E = {(x, y, z) | − 2 ≤ x ≤ 2, − √ 4 − x^2 ≤ y ≤ √ 4 − x^2 , 2 − sqrt4 − x^2...

Design an overflow spillway profile for a design discharge of 1200 m3/s. The upstream water surface...

Design an overflow spillway profile for a design discharge of 1200 m3/s. The upstream water surface level is at an elevation of 220 m and the upstream channel floor is at 180 m. The spillway, having a vertical face, is 40 m long.

. Sketch the layout for a typical conventional surface water treatment plant. Label each process. Briefly...

. Sketch the layout for a typical conventional surface water treatment plant. Label each process. Briefly describe the different water treatment processes and their basic functions.

consider the following information for a rectangular primary clarifier a)determine the required surface area(m^2),tank volume(m^3) and...

consider the following information for a rectangular primary clarifier a)determine the required surface area(m^2),tank volume(m^3) and detention time (hrs) under both the average flow conditions and peak flow conditions b) calculate and compare the scour velocity (m/s) and peak flow horizontal velocity (m/s) Based on these two values,do you expect the particles to re-suspend during the clarification process. No of rectangular clarifiers=2 Qaverage=20,000m^3/d Qpeak=50,000m^3/d channel width =6m side water depth=4m overflow rate at average flow=40m^3/m^2.d density of water=1000kh/m^3 density of...

Two water reservoirs are joined by a sharp ended flexible pipe 100 mm in diameter and...

Two water reservoirs are joined by a sharp ended flexible pipe 100 mm in diameter and 36 m long. The ends of the pipe differ in level by 4 m. The surface level of the upper reservoir is 1.8 m above the pipe inlet whilst that of the lower reservoir is 1.2 m above the pipe outlet. At a position 7.5 m horizontally from the upper reservoir, the pipe is required to pass over a barrier. Assuming that the pipe...

For the soil profile shown in the figure above of Problem 4, when the water table elevation is raised to the top of the ground surface:

For the soil profile shown in the figure above of Problem 4, when the water table elevation is raised to the top of the ground surface:(a) What is the change in the effective stress at Point A?(b) What will be the consequence of the effective stress change?Assume that the total unit weight of the top soil below the water table will increase 5% from its moist unit weight after raising the water table.

For the following soil profile, when the water table elevation is lowered to the level shown:

For the following soil profile, when the water table elevation is lowered to the level shown:(a). What is the change in the effective stress at Point A?(b). What will be the consequence of the effective stress change?Assume that the total unit weight γ of the sand layer above the water table will decrease 5% from its saturated unit weight after lowering the water table.

1.Sketch a graph of the perfect information equilibrium in an insurance market with two types of...

1.Sketch a graph of the perfect information equilibrium in an insurance market with two types of consumers, sick and healthy. 2?Why won’t the perfect information equilibrium work when health status is private information.

The surface tension of pure water is 72 dyne/cm at 20C. You are provided with two...

The surface tension of pure water is 72 dyne/cm at 20C. You are provided with two surfactants, A and B. A 1% solution of surfactant A reduced the surface tension of water to 35 dynes/cm and a 1% solution of surfactant B reduces the surface tension to 44.5 dynes/cm. Now, let's assume that you are making two foams using surfactants A and B. The total interfacial area of the foam in both cases is 600 cm^2. What is the interfacial...

Water flows between two reservoirs through 800 ft of 12-inch diameter welded-steel pipe. The water surface...

Water flows between two reservoirs through 800 ft of 12-inch diameter welded-steel pipe. The water surface elevation difference between the two reservoirs is 16 ft. Find the flowrate (a) assuming head loss is only due to pipe friction, and (b) Accounting for both friction losses and minor losses due to a flush square-edged pipe entrance, the pipe exit, and a half-open gate valve in the line. Assume the water temperature is 60°F.

Subjects