6- You have a laser diode operating at 850 nm and capable of coupling 1 m...

6- You have a laser diode operating at 850 nm and capable of coupling 1 m W into a fiber, N sections of cable each of which is 500 m long, has 0.5 dB/km attenuation, and has connectors on both end. Each connector has a connector loss 0f 1.0 dB/connector. Also, you have a PIN photodiode receiver and an avalanche photodiode receiver. Using these components, you wish to construct a 7km link operating at 20Mb/s. If the sensitivities of the pin and APD receivers are -30 and -40dBm at 20Mb/s, respectively, perform calculations to determine which receiver or any or none should be used if a 6dB system operating margin is required?

Expert Solution

genius_generous answered 2 years ago

Consider a Fabry–Perot semiconductor laser diode operating at 1550 nm. The active region is a III–V...

Consider a Fabry–Perot semiconductor laser diode operating at 1550 nm. The active region is a III–V quaternary semiconductor alloy of InGaAsP (but quite close to being InGaAs). The LD has a cavity length of 250 μm. The refractive index of InGaAsP is approximately 3.60 and dn/dT = 2.5 * 10^-4 K^-1, the linear thermal expansion coefficient is 5.6 * 10^-6 K^-1. The bandgap of InGaAs follows the Varshi equation Eg = Ego - AT^2>(B + T) with Ego = 0.850...

Why is it difficult to get a 632 nm red laser diode (but you can get...

Why is it difficult to get a 632 nm red laser diode (but you can get a 637 nm one easily? Why are red laser diodes cheaper than green ones or blue ones?

1. What is diffraction? 2. Diode laser light ( λ = 670 nm) falls on single...

1. What is diffraction? 2. Diode laser light ( λ = 670 nm) falls on single slit with the width of slit 0.04 mm. If a screen is 1.05 m away from the slit, what is Δy1↔1 the distance between the first dark (m=1) above the central bright and the first dark (m=1) below the central bright? 3. What is interference? 4. Diode laser light ( λ = 670 nm) falls on double slits spaced 0.25 mm. If a screen...

Consider a 1550 nm laser diode with a rise time of 0.8 ns, spectral half-width of...

Consider a 1550 nm laser diode with a rise time of 0.8 ns, spectral half-width of 6 nm, that launches 2 mW optical power into a 60 km long single-mode fiber with an attenuation of 0.3 dB/km. The intramodal dispersion is 3 ps/nm.km. An InGaAs APD with a -32 dBm sensitivity is used at 2.5 Gb/s (NRZ coding). A short optical jumper cable at each end of the cable with a loss of 3 dB is used to connect the...

A particular HeNe laser operating at 632.8 nm has a tube that is 40 cm long....

A particular HeNe laser operating at 632.8 nm has a tube that is 40 cm long. The operating gas temperature is about 130 C. Calculate the frequency separation and the wavelength separation of the laser modes. How do these change as the tube warms up during operation? Taking the linear expansion coefficient to be 10-6 K-1, estimate the change in the mode frequency separation. (please calculate the frequency separation and the wavelength separation)

A Fabry–Perot laser diode has an internal loss coefficient is 40dB.cm-1 , longitudinal mode spacing is...

A Fabry–Perot laser diode has an internal loss coefficient is 40dB.cm-1 , longitudinal mode spacing is 88GHz and mirror reflectivity, R1 = R2 = 0.5. Compute the length of the cavity and the photon lifetime. Also, compute the minimum required gain to sustain laser oscillations. Assume that the velocity of light in the active region is 9.09 × 107 m/s.

1) A 600 nm laser illuminates a double slit apparatus with a slit separation distance of...

1) A 600 nm laser illuminates a double slit apparatus with a slit separation distance of 3.55 μm. The viewing screen is 1.50 meters behind the double slits. What is the distance (in meters) from the central bright fringe to the 3nd dark fringe? 2) A 600 nm laser illuminates a double slit apparatus with a slit separation distance of 3.55 μm. The viewing screen is 1.50 meters behind the double slits. What is the distance (in cm) between the...

1) A 680 nm laser illuminates a double slit apparatus with a slit separation distance of...

1) A 680 nm laser illuminates a double slit apparatus with a slit separation distance of 7.83 μm. On the viewing screen, you measure the distance from the central bright fringe to the 2nd bright fringe to be 88.2 cm. How far away (in meters) is the viewing screen from the double slits? 2) A 600 nm laser illuminates a double slit apparatus with a slit separation distance of 3.55 μm. The viewing screen is 1.50 meters behind the double...

You have a spacecraft that is capable of reaching a speed of 0.99c and desire to...

You have a spacecraft that is capable of reaching a speed of 0.99c and desire to travel to Vega, a nearby star about 25 light years away. In order to keep track of your position, your spacecraft sends out a flash of light every second (by your ship’s clock) during the journey that can be picked up on Earth. In addition, the Earth sends out a flash every second (by the Earth clock) that you can see with a telescope...

1. You are going to deposit $850 in a bank CD today, and you will withdraw...

1. You are going to deposit $850 in a bank CD today, and you will withdraw the money only once the balance is $1,000. If the bank pays 9 percent interest, how long will it take for the balance to reach $1,000? (If you solve this problem with algebra round intermediate calculations to 4 decimal places, in all cases round your final answer to 1 decimal place, e.g. 5.4.) Balance will reach $1,000 in years

Question