Question

In: Physics

In an RC circuit as depicted in the figure above, what happens to the time required...

In an RC circuit as depicted in the figure above, what happens to the time required for the capacitor to be charged to half its maximum value if either the resistance or capacitance is increased with the same applied voltage? (Select all that apply.)

A.Increasing the resistance increases the time.

B.Increasing the resistance decreases the time.

C.Increasing the capacitance increases the time

D.Increasing the capacitance decreases the time.

Solutions

Expert Solution

time constant = R* C

greater the time constant, greater time it will take to charge

Answers are :
A.Increasing the resistance increases the time.
C.Increasing the capacitance increases the time


Related Solutions

What is a time constant and what does it mean for a decaying RC circuit?
What is a time constant and what does it mean for a decaying RC circuit?
An RC circuit, hooked up to a battery as shown in the figure,starts with an...
An RC circuit, hooked up to a battery as shown in the figure, starts with an uncharged capacitor. The resistance in the circuit is R = 784.0 Ω the capacitor has capacitance of C = 68.0 μF and the battery maintains the emf of ε = 32.0 V. The switch is closed at time t = 0.0 s and the capacitor begins to charge.What is the time constant for this circuit?Tries 0/5What is the charge on the capacitor after the...
Consider a RC circuit. At time t=0, the circuit is closed. ( a) Draw how the...
Consider a RC circuit. At time t=0, the circuit is closed. ( a) Draw how the current behaves with time. (b) What about the power dissipated by the resistor ? (also draw it as a function of t)
Consider a RC circuit. At time t = 0, the circuit is closed. (a) Draw how...
Consider a RC circuit. At time t = 0, the circuit is closed. (a) Draw how the current behaves with time (b) What about the power dissipated by the resistor? (also draw it as a function of t)
The figure below shows an RC circuit. The capacitor is initially uncharged. At t = 0,...
The figure below shows an RC circuit. The capacitor is initially uncharged. At t = 0, the switch is closed to point a. Find the time it takes for the capacitor voltage to reach one third the battery voltage. Use the figure above. In the figure, the switch has been at point a for a long time and the capacitor voltage is equal to the battery voltage. At t = 0, the switch is moved to point b. Find the...
show that the relaxation time for a heavily damped rlc circuit is RC
show that the relaxation time for a heavily damped rlc circuit is RC
According to Ohm's Law, if you have a simple circuit (Figure 2), what happens to the...
According to Ohm's Law, if you have a simple circuit (Figure 2), what happens to the voltage and current of the resistor as the resistance increases? If a 100 Ohm resistor is attached to a 5 V battery, how much current flows through the resistor?  If a wire's length is cut in half, what happens to the wire's resistance?  If a wire's area is reduced by half, what happens to the wire's resistance? If the diameter and length of a wire are split in...
In an RC circuit the time constant is defined as Select one: True False
In an RC circuit the time constant is defined as Select one: True False
What is the maximum charge on a capacitor in an RC circuit? As the capacitor in...
What is the maximum charge on a capacitor in an RC circuit? As the capacitor in an RC circuit charged, what is the current as a function of time?Explain your answer physically. 1.5 V batteries are usually connected in series. Would the batteries last longer or shorter if they were connected in parallel instead?
Solve the equation for a charging capacitor (Vc = Vs(1-e^(t/t))) for an RC Circuit for the ratio of the time (t) to the RC time constant (t):
it is rc time constant problem. 1. Solve the equation for a charging capacitor (Vc = Vs(1-e^(t/t))) for an RC Circuit for the ratio of the time (t) to the RC time constant (t): Show all steps. 2. Using the answer to Part 1, calculate the fraction of a time constant (t) to charge an initially uncharged capacitor to 10% of the source voltage (Vs). Show all steps. 3. Using the appropriate answers from Part 1, calculate the fraction of...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT