A hydraulic jump is formed in a rectangular channel 6.5 ft wide. The conjugate depths are...

A hydraulic jump is formed in a rectangular channel 6.5 ft wide. The conjugate depths are 0.5 ft and 4.0 ft respectively. Calculate: a. specific discharge, b. energy lost in the jump, c. critical depth, minimum specific energy, d. Horsepower lost, e. Length of the jump and f. Classify the Jump.

Solutions

Expert Solution

Ally Wells answered 6 months ago

Next > < Previous

Related Solutions

The sequent depth, ys of a hydraulic jump in a rectangular channel is related to the...

The sequent depth, ys of a hydraulic jump in a rectangular channel is related to the initial yi, the discharge per unit length, q, gravity acceleration, g and density r. Express the ratio ys/yi in term of non-dimensional group and compare with the equation developed from momentum principles as shown below: ?! #

Explain how to calculate depths, velocities, and headloss for a hydraulic jump. What is the difference...

Explain how to calculate depths, velocities, and headloss for a hydraulic jump. What is the difference between free and drowned outflow?

a) Sketch the specific energy curves for the following open channel flows: · A hydraulic jump...

a) Sketch the specific energy curves for the following open channel flows: · A hydraulic jump formed in a rectangular open channel · Flow through a channel width constriction, where the depths remain subcritical throughout · Flow through a sluice gate, where the gate opening is less than the flow’s critical depth. · Flow through a combined channel width constriction together with an upward step, where the depth remains subcritical throughout. b) Define and explain the following terms · Critical...

A rectangular swimming pool is 5 ft deep, 10 ft wide, and 15 ft long. The...

A rectangular swimming pool is 5 ft deep, 10 ft wide, and 15 ft long. The pool is filled with water to 1 ft below the top. If the weight density of water is 62.4 lb / ft3 and if x = 0 corresponds to the bottom of the tank, then which of the following represents the work done (in ft-lb) in pumping all the water into a drain at the top edge of the pool?

Q5. Derive an equation relating the sequent depths in a rectangular channel which has a bed...

Q5. Derive an equation relating the sequent depths in a rectangular channel which has a bed slope of So. Assume that y2=5Lj where Lj is jump length and shape of the jump between upstream and downstream is trapezoid. Draw the control volume and show all variables. Hint: Apply momentum equation and take into account the weight force.

An asphalt rectangular channel is 7m wide and has a slope of 1° . The water...

An asphalt rectangular channel is 7m wide and has a slope of 1° . The water is 1.5m deep. Find the discharge rate for uniform flow. What is the radius of an asphalt cylindrical channel, which is half-full, to give a similar discharge rate?

A rectangular channel 6m wide by 1m deep is lain on slope of 0.001 and has...

A rectangular channel 6m wide by 1m deep is lain on slope of 0.001 and has roughness coefficient of n = 0.013. What is the mean velocity of flow (m/s) when the canal is full? What is the maximum capacity of the channel in m3/s? If the most efficient rectangular section is used, what depth of canal is required for the same discharge, slope, and roughness coefficient?

A 5 m wide rectangular channel carries a flow of 20 m3/s. The slope of the...

A 5 m wide rectangular channel carries a flow of 20 m3/s. The slope of the channel is 0.005 and the Manning’s n is 0.03. The flow encounters a 0.5 m step up that is 0.1 m long. The depths far upstream and downstream are normal. Classify this channel Qualitatively sketch this scenario, label gradually varied flow curves and provide appropriate depths. Draw this scenario on an E-Y cycle graph, and label all depth changes.

A rectangular channel 2 m wide has a bottom slope of 0.01 and a roughness coefficient...

A rectangular channel 2 m wide has a bottom slope of 0.01 and a roughness coefficient of 0.017. A sluice gate 2 m wide is located in the channel. The sluice gate has a contraction coefficient of 0.61 and a discharge coefficient of 0.58. The depth of water just upstream from the gate is 2 m. The depth of water just downstream from the gate is 0.5 m. Determine how far upstream from the gate the depth of water will...

Q1. Gradually varied flow of water in a wide rectangular channel with a per unit width...

Q1. Gradually varied flow of water in a wide rectangular channel with a per unit width flow rate of 1 m3 /s-m and a Manning coefficient of n = 0.02 is considered. The slope of the channel is 0.001, and at the location x=0.0, the flow depth is measured to be 0.80 m. (a) Determine the normal and critical depths of the flow and classify the water surface profile, and (b) calculate the flow depth y at x=1000 m by...

Subjects