Question

In: Physics

A motor has coils with a resistance of 26 Ω and operates from a voltage of...

A motor has coils with a resistance of 26 Ω and operates from a voltage of 244 V. When the motor is operating at its maximum speed, the back emf is 146 V.

(a) Find the current in the coils when the motor is first turned on.

(b) Find the current in the coils when the motor has reached maximum speed.

(c) If the current in the motor were 7.0 A at some instant, what is the back emf at that time?

Expert Solution

a)

V = 244 Volts

R = 26 ohm

i = V/R = 244/26 = 9.4 A

b)

at maximum speed :

V_b = 146

V = 244

hence i = (V - V_b)/R = (244 - 146)/26 = 3.77 A

c)

i = (V - V_b)/R

7 = (244 - V_b)/26

V_b = 62 volts

genius_generous answered 2 years ago

A shunt motor has a supply voltage of 200 V and armature resistance of 3.6 Ω....

A shunt motor has a supply voltage of 200 V and armature resistance of 3.6 Ω. At certain torque the motor run at speed = 1200 R.P.M and take a current of 10 Amp from the supply and its field current is 0.5 Amp. Find starting torque, no-load speed, and the load torque when the current supplied by the supply is 5 Amp.

AB is a potentiometer wire of resistance 1 Ω being used to measure a small voltage...

AB is a potentiometer wire of resistance 1 Ω being used to measure a small voltage of 2/3 mV. The cell has an emf of 2 V and negligible internal resistance. For the balance point to be 2/3 (two thirds) of the way along the slidewire, as shown, the value of R in ohms must be:

A 3-phase line has a resistance of 9 Ω/phase and a reactance of 23 Ω/phase. The...

A 3-phase line has a resistance of 9 Ω/phase and a reactance of 23 Ω/phase. The load at the receiving end is 130 MW at 0.8 p. f. lagging. Find the capacity of the synchronous condenser required to be connected at the receiving end to maintain the voltage at both ends of the transmission line at 132 KV.

a) A light bulb has a resistance of 5.0 Ω and a current of 0.4 A...

a) A light bulb has a resistance of 5.0 Ω and a current of 0.4 A when it is connected to a voltage. At what voltage is it operating? (Express your answer to two significant figures.) b) A piece of copper wire is 1.00 m long and has a diameter of 2.00 mm. Copper has a resistivity of 1.725⋅10−8Ω1.725⋅10−8Ω Calculate the resistance of this piece of copper wire. (Express your answer to three significant figures.)

The resistance of the loop in the figure is 0.30 Ω.

The resistance of the loop in the figure is 0.30 Ω. a) Is the magnetic field strength increasing or decreasing? b) At what rate (T/s)?

An ac circuit has a resistance of 40 Ω connected in series to an inductor of...

An ac circuit has a resistance of 40 Ω connected in series to an inductor of inductive reactance equal to 30 Ω at a frequency of 50 Hz. Find the inductance of the inductor.

The resistance in the two arms of the meter bridge are 5 Ω and R Ω , respectively.

The resistance in the two arms of the meter bridge are 5 Ω and R Ω , respectively. When the resistance R is shunted with an equal resistance, the new balance point is at1.6l1. The resistance R is

An electric space heater has a Nichrome heating element with a resistance of 6 Ω at...

An electric space heater has a Nichrome heating element with a resistance of 6 Ω at 20°C. When 120 V are applied, the electric current heats the Nichrome wire to 1004°C. The temperature coefficient of resistivity of Nichrome is 4 x 10-4 K-1. (a) What is the initial current drawn by the cold heating element? (b) What is the resistance of the heating element at 1004°C? (c) What is the operating wattage of this heater?

The heater element of a kettle has a constant resistance of 105ohm and apllied voltage of...

The heater element of a kettle has a constant resistance of 105ohm and apllied voltage of 240V Calculate the time taken to raise the temperature of on litre of water from 15degrees celsius to 90 degrees celsius assuming that only 80% of the power input to the kettle is usefully employed If the water equivalent of the kettle is 150g, find out how long it will take tobraise a second litre of water through the same temperature range immediately after...

A. If an RLC circuit with a resistance of 450 Ω is in resonance, the phase...

A. If an RLC circuit with a resistance of 450 Ω is in resonance, the phase angle of the circuit is (1) positive, (2) zero, (3) negative. B. A circuit has an inductive reactance of 280 Ω at 60 Hz. What value of capacitance would set this circuit into resonance ? C. What is the inductance value ? D. If the inductance doubles from the value in part (C) what is the circuit's phase angle now ?