Question

In: Civil Engineering

A rectangular, well-mixed aeration lagoon is 75 m long, 5 m wide, and 2 m deep....

  1. A rectangular, well-mixed aeration lagoon is 75 m long, 5 m wide, and 2 m deep. It receives 400 m3/d of wastewater with a BOD5 of 367mg BOD5/L for treatment. The biodegradation rate constants for the wastewater are the following: yield coefficient = 0.8 mg VSS/mg BOD5, endogenous decay constant = 0.08 d-1, maximum specific microbial growth rate = 1 d-1, and half velocity constant = 76.0 mg BOD5/L.                                                                                                       
  1. What must the hydraulic detention time be in the aeration pond? (days)

  1. What is the efficiency of the lagoon? (%)   

  1. The pond’s efficiency depends on oxygen being always available for the microbes to use in degrading the wastewater organic carbon. How much oxygen must be supplied daily to the pond? (in kg)

  1. What mass of microbes will be produced in the pond each day? (in kg)   
  2. Suppose the operators decide to perform a recycle of the lagoon’s effluent to boost the efficiency. They decide to pump sludge from where it accumulates at the bottom of the pond to mix with the influent such that the incoming flow contains the same concentration of bacteria as the pond itself (X0 = X). What will the new treatment efficiency be? (%)

Mainly need part a, d, e

Solutions

Expert Solution


Related Solutions

A rectangular tank 1.5 m wide, 3 m long and 1.8 m deep contains water to...
A rectangular tank 1.5 m wide, 3 m long and 1.8 m deep contains water to a depth of 1.2 m. Find the horizontal acceleration that may be imparted to the tank in the direction of its length so that 1. the water is just about to spill 2. the front bottom corner of the tank is just exposed. 3. the bottom of the tank is exposed to its midpoint. For (2) and (3) above, compute the volume of the...
A rectangular swimming pool is 5 ft deep, 10 ft wide, and 15 ft long. The...
A rectangular swimming pool is 5 ft deep, 10 ft wide, and 15 ft long. The pool is filled with water to 1 ft below the top.  If the weight density of water is 62.4 lb / ft3 and if x = 0 corresponds to the bottom of the tank, then which of the following represents the work done (in ft-lb) in pumping all the water into a drain at the top edge of the pool?
A rectangular car tank 20m long, 4m wide and 3m deep is completely open at the...
A rectangular car tank 20m long, 4m wide and 3m deep is completely open at the top. If it is initially filled to the top: (a) How much liquid will be spilled if it is given a horizontal acceleration of 0.3g in the direction of its length? (b) What is the maximum hydrostatic force acting on the side opposite the direction of the acceleration. (c) Determine the volume of the remaining water at the tank.
A well-mixed sample (volume = 30 mL) of mixed liquor from an aeration tank of an...
A well-mixed sample (volume = 30 mL) of mixed liquor from an aeration tank of an activated sludge wastewater treatment plant was divided into two halves. The first half was filled in a 22.285 g crucible and placed in a drying oven at 105°C for 24 hours. The weight of the crucible and the residue after drying was 22.344 g. The crucible was then placed in a furnace at 550 °C for 30 minutes. After that the crucible with the...
A 2-m-high, 4-m-wide rectangular advertisement panel is attached to a 4-m-wide, 0.15 m-high rectangular concrete block...
A 2-m-high, 4-m-wide rectangular advertisement panel is attached to a 4-m-wide, 0.15 m-high rectangular concrete block (density = 2300 kg/m3) by two 5-cm-diameter, 4-m-high (exposed part) poles, as shown in the figure. If the sign is to withstand 150 km/h winds from any direction, determine (a) the maximum drag force on the panel, (b) the drag force acting on the poles, and (c) the minimum length L of the concrete block for the panel to resist the winds. Take the...
A closed rectangular tank 1.2 m high, 2.4 m long and 1.5 m wide is two-thirds...
A closed rectangular tank 1.2 m high, 2.4 m long and 1.5 m wide is two-thirds full of gasoline (specic gravity 0.8). Calculate the acceleration which may be imparted to the tank so that the bottom front end of the tank is just exposed. Also calculate the total forces on each end of the tank and show that the dierence between these forces equals the unbalanced force necessary to accelerate the liquid mass in the tank.
A rectangular channel 6m wide by 1m deep is lain on slope of 0.001 and has...
A rectangular channel 6m wide by 1m deep is lain on slope of 0.001 and has roughness coefficient of n = 0.013. What is the mean velocity of flow (m/s) when the canal is full? What is the maximum capacity of the channel in m3/s? If the most efficient rectangular section is used, what depth of canal is required for the same discharge, slope, and roughness coefficient?
: A rectangular plate 1.5m wide and 2.5m deep is placed vertically in water so that...
: A rectangular plate 1.5m wide and 2.5m deep is placed vertically in water so that the center of plate is 4m below the free surface. Determine the total pressure and the depth of center of pressure. State also whether the equilibrium is stable or unstable. The above rectangular plate is taken out of the water which weighs 350.5 N in air and 173.3 N in water of specific gravity 0.99. Find the volume and specific gravity of the plate....
A 5 m wide rectangular channel carries a flow of 20 m3/s. The slope of the...
A 5 m wide rectangular channel carries a flow of 20 m3/s. The slope of the channel is 0.005 and the Manning’s n is 0.03. The flow encounters a 0.5 m step up that is 0.1 m long. The depths far upstream and downstream are normal. Classify this channel Qualitatively sketch this scenario, label gradually varied flow curves and provide appropriate depths. Draw this scenario on an E-Y cycle graph, and label all depth changes.
A rectangular channel 2 m wide has a bottom slope of 0.01 and a roughness coefficient...
A rectangular channel 2 m wide has a bottom slope of 0.01 and a roughness coefficient of 0.017. A sluice gate 2 m wide is located in the channel. The sluice gate has a contraction coefficient of 0.61 and a discharge coefficient of 0.58. The depth of water just upstream from the gate is 2 m. The depth of water just downstream from the gate is 0.5 m. Determine how far upstream from the gate the depth of water will...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT