Question

In: Electrical Engineering

A buck converter is operated from the rectified 230 V ac mains, such that the converter...

A buck converter is operated from the rectified 230 V ac mains, such that the converter de input voltage
IS
V8 = 325 v ± 20%
A control circuit automatically adjusts the converter duty cycleD, to maintain a constant de output voltage
of V = 240 V de. The de load current I can vary over a 10: 1 range:
lOA::;J:s;lA
The MOSFET has an on-resistance ofO.S Q. The diode conduction loss can be modeled by a 0.7 V
source in series with a 0.2 Q resistor. All other losses can be neglected.
(a) Derive an equivalent circuit that models the converter input and output ports, as well as the loss
elements described above.
(b) Given the range of variation of V8 and I described above, over what range will the duty cycle
vary?
(c) At what operating point (i.e., at what value of V8 and I) is the converter power loss the largest?
What is the value of the efficiency at this operating point?

Solutions

Expert Solution


Related Solutions

Design a buck-boost converter with a source varying from 10 to 14 V. The output voltage...
Design a buck-boost converter with a source varying from 10 to 14 V. The output voltage is regulated at – 12 V. The load varies from 10 to 15 W. The output voltage ripple must be less than 1 % for any operating condition. a) Determine the range of the duty ratio of the switch. b) Design the inductor and capacitor values used in your design. c) Confirm your solutions using a simulation software for every operating condition (you must...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected in series with a 0.300 H inductor, a 4.30 μF capacitor and a 256 Ω resistor. What is the impedance of the circuit? What is the rms current through the resistor? What is the average power dissipated in the circuit? What is the peak current through the resistor? What is the peak voltage across the inductor? What is the peak voltage across the capacitor?...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected...
An AC generator supplies an rms voltage of 230 V at 60.0 Hz. It is connected in series with a 0.400 H inductor, a 3.40 μF capacitor and a 206 Ω resistor. What is the impedance of the circuit? Tries 0/20 What is the rms current through the resistor? Tries 0/20 What is the average power dissipated in the circuit? Tries 0/20 What is the peak current through the resistor? Tries 0/20 What is the peak voltage across the inductor?...
Perform the following task of dc-dc Buck converter. 1). Provide matlab code for DC-DC buck converter...
Perform the following task of dc-dc Buck converter. 1). Provide matlab code for DC-DC buck converter I need matlab code for dc-dc buck converter
Perform the following tasks of dc-dc Buck converter. 1). Provide matlab code for DC-DC buck converter...
Perform the following tasks of dc-dc Buck converter. 1). Provide matlab code for DC-DC buck converter 2). Mathematical Analysis of fourier series and filters to remove harmonics
For buck and boost type converter, compare the impact of load resistance when the converter goes...
For buck and boost type converter, compare the impact of load resistance when the converter goes from continuous conduction mode (CCM) to discontinuous conduction mode (DCM) on (give reasons to validate your answer) a. Voltage Gain b. Output voltage ripple c.   Inductor current (nature of waveform)
A buck-boost converter has an input voltage V_in= 10 V, switching frequency fs= 100 kHz, duty...
A buck-boost converter has an input voltage V_in= 10 V, switching frequency fs= 100 kHz, duty ratio d= 30%, load resistance R_L= 20Ω, inductance =100 μH, and capacitance= 680 μF. 1) Calculate the following values, and include units in your answers: a) Peak-to-peak current ripple through the inductor, Δ_iL b) Average inductor current that will cause the converter to enter DCM b) Load resistance that will cause the converter to enter DCM (R_crit) d) Average voltage across the inductor insteady-state
In an AC to DC rectifier circuit, the output DC signal of the rectified wave was...
In an AC to DC rectifier circuit, the output DC signal of the rectified wave was measured to be VDC= (6.6±0.6)V and its ripple voltage was measured to be Vripple=(0.27±0.02) mV. What is the uncertainty on the quality factor of the rectifier?
Q13. A buck converter is constructed with a MOSFET which has an on-state resistance of 75m?,...
Q13. A buck converter is constructed with a MOSFET which has an on-state resistance of 75m?, and a diode with a forward voltage drop of 1.3V. The MOSFET exhibits switching rise and fall times of 50ns. The converter operates from an input voltage of 400V and. The converter supplies 1.2kW at an output voltage of 300V and switches at 150kHz. The MOSFET and the diode are mounted onto separate heatsinks. The ambient temperature in which the power converter operates is...
What are the pros and cons of a continuous mode buck converter? Give suggestions to improve...
What are the pros and cons of a continuous mode buck converter? Give suggestions to improve it.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT