Question

In: Civil Engineering

A field test is conducted in a confined aquifer by pumping a constant discharge of 14.9...

A field test is conducted in a confined aquifer by pumping a constant discharge of 14.9 m3/hr from 20-cm-diameter well. After an approximate steady state is reached, a drawdown of 0.98 m is measured in the pumped well. Also measured are drawdowns of 0.73 m, 0.65 m, 0.60 m, and0.57 m, respectively, at 8.0 m, 30.0 m, 80.0 m, and 132 m from the pumped well. Determine the transmissivity of this aquifer. Also, determine how far away from the well you must be before the drawdown becomes less than 0.45 m.

Solutions

Expert Solution


Related Solutions

In a pumping test of a confined aquifer, the steady state water level in an observation...
In a pumping test of a confined aquifer, the steady state water level in an observation well 10m from the pumping well was 38mOD and was 42 mOD in another observation well 100m from the pumping well. The water levels in both wells were steady at 50mOD before the test began and then water was pumped at a constant rate of 0.005m^3/s from the pumping well. Estimate the aquifer transmissivity. If the aquifer is 15m thick, estimate the hydraulic conductivity...
Problem One (33%) – water usage calculation in a confined aquifer A confined aquifer with a...
Problem One (33%) – water usage calculation in a confined aquifer A confined aquifer with a storativity of 7.8 x 10-5 extends over an area of 50 km2. During the wet season the aquifer has been recharged and the storage in that area has been increased by 8 ML.      How much has the potentiometric surface raised?      If the aquifer was unconfined with a specific yield of 18%, what would be the volume recharged (in ML) for the same...
Two discharge wells (1 and 2) penetrating an unconfined aquifer are pumped at constant rates of...
Two discharge wells (1 and 2) penetrating an unconfined aquifer are pumped at constant rates of 3,000 and 500 m^3 per day , respectively. The steady-state head (i.e., water table height) measured at an observation well is 40 meters . The observation well is 50 meters from well 1 and 64 meters from well 2. The water table height measured at a second observation well is 32.9 meters , which is located 20 meters from well 1 and 23 meters...
From a 2-hr test on a confined aquifer at 400 gpm, the following drawdowns were measured...
From a 2-hr test on a confined aquifer at 400 gpm, the following drawdowns were measured on a number of wells. Determine the transmissivity and storage coefficient using the Theis approach. Well number 1 2 3 4 5 6 7 Distance (ft) 29 35 44 60 85 100 163 Drawdown (ft) 14.9 13.8 12.7 11.7 10.1 9.6 7
3) Draw or describe the structure of a confined and of an unconfined aquifer. Why are...
3) Draw or describe the structure of a confined and of an unconfined aquifer. Why are aquifers important?
This is the previous example the answer is there in cgegg: A confined aquifer has been...
This is the previous example the answer is there in cgegg: A confined aquifer has been fully penetrated with a well of 200 mm diameter The thickness of the aquifer is 25 m. If you know that the well was pumped at a constant rate of 2000 m3/day and the steady state drawdown in the well is 8 m and the drawdown in a piezometer 100 m from the well is 1.4 m. Calculate the following: Aquifer transmissivity, hydraulic conductivity...
Two piezometers are installed 2430 m apart in a confined aquifer. The head at the first...
Two piezometers are installed 2430 m apart in a confined aquifer. The head at the first piezometer is measured as 29.1 m and the head at the second piezometer as 26.7 m. The aquifer has a saturated thickness of 17.3 m, and hydraulic conductivity of 8x10-4 m/s, and effective porosity of 0.16. Determine: 1.1. without any calculation, predict the direction of groundwater flow 1.2. the discharge rate through the aquifer in m3/d/m of aquifer width 1.3. the specific discharges (Darcy...
A confined aquifer 250m thick has bulk modulus of compression of 2.1x103kg/cm2 and porosity of 23%....
A confined aquifer 250m thick has bulk modulus of compression of 2.1x103kg/cm2 and porosity of 23%. Given the bulk modulus of elasticity of water is 2.4x104kg/cm2 and specific 3 weight of water as 1000kg/m , Determine A. The storage coefficient of the aquifer. B. Specific storage of an aquifer
. A proctor test has been conducted and it was verified that the relative field compaction...
. A proctor test has been conducted and it was verified that the relative field compaction is 96.2%. Can we conclude that the in-situ conditions meet the compaction specifications?
A conducting sphere with a radius of R = 14.9 mm has a uniform and constant...
A conducting sphere with a radius of R = 14.9 mm has a uniform and constant surface charge density of a = 4.7 nC / m ?. What will be the magnitude of the electric field produced by that sphere at a distance from the center of the sphere of r = 34.3 cm?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT