Question

Multiple Choice

1. Which of the following is not used to define a chamfer?

a. Angle and a distance

b. Distance and distance

c. Two angles and a distance

2. Which tool is used to draw a spring?

a. Coil

b. Loft

c. Sweep

3. The Edit Sketch tool can be applied to shapes created with which of the following tools?

a. Extrude

b. Rectangle

c. Revolve

d. Hole

4. The Edit Feature tool can be applied to shapes created with which of the following tools?

a. Circle

b. Line

c. Point, Center Point

d. Extrude

5. Which of the following parameters cannot be used to draw a work plane?

a. Angle to a plane

b. Point and a tangent

c. 3-Point

d. Tangent to face through

6. Which of the following is a material not listed under the Physical tab of the Properties dialog box?

a. Mild Steel

b. Aluminum Bronze

c. Glass

7. Sketched shapes can be projected between work planes using which tool?

a. Sweep

b. Boundary Patch

c. Move Face

d. Project Geometry

8. Which of the following will happen if a work plane is deleted?

a. The work plane will disappear from the screen and all entities will be deleted.

b. The work plane will disappear from the screen and all entities will remain in place.

9. Why are ribs used on molded parts?

a. To increase the part's flexibility

b. To balance the part

c. To increase the part's strength

10. The Face Draft tool is used to

a. Create airflow

b. Create an angled surface

c. Create a current behind a moving object

Answer 1

1. C) two angle and a distance is not used to define a chamfer.

2. A) coil tool is used to draw a spring.

3. B) Rectangle. Edit sketch is used to modify the 2D sketch which is drawn as a reference to perform further operations. Hence, rectangle is a 2D sketch and edit sketch can be applied to rectangle.

4. D) Extrude. The edit feature tool is used to edit the 3D operation done previously. Extrude is a 3 D operation hence edit feature can be used on extruded part.

5. D) Tangent to face through parameter cannot be used to draw a workplane.

6. B) Aluminum Bronze is a material not listed in physical tab.

7. D) By using Project geometry tool we can project any sketched shaped on the working plane.

8. A) If we delete a work plane then the workplane will disappear and all the entities willa get deleted.

9. C)Ribs are used in modelled part to increase the strength of part.

10. B) The face draft tool is used to create an angled surface.