Question

In: Chemistry

In organic chemistry lab, we separated a sample of benzion and benzoic acid. We tested the...

In organic chemistry lab, we separated a sample of benzion and benzoic acid. We tested the purity of the samples we obtained using a TLC plate. All of our benzoin spots also showed an impurity of benzoic acid. However, our benzoic acid spot did not show an impurity of benzoin. Why is this?

Solutions

Expert Solution

In your question you have not mentioned the method used for the separation, Extraction or column chromatographic purification.

I persume that you have used column chromatographic purification, which separating both the spot, you must have used a higher percent of solvent mixture to run the column that is why you have observed the tailing of benzoic acid in benzoin.

Whereas, benzoic acid is polar and requires higher percent of solvent mixture. So by the time, benzoic acid eluded from the column, all the benzoin was already separated.

Suggestion to completely separated each other

Take a mixture of  benzion and benzoic acid in organic solvent (ethyl acetate) in a separating funnel. To this add saturated NaHCO3 and shake, all the benzoic acid will be converted into sodium benzoate and go into water layer and benzoin will stay in the organic layer. Separate both layers

Concentrate the organic layer to obtain pure benzoin

To the aqueous layer add 5 N HCl until the pH of solution becomes acidic and the solid benzoic acid precipitates out. Filter the solid was with water and dry.


Related Solutions

In organic chemistry lab, we separated a sample of benzion and benzoic acid. We tested the...
In organic chemistry lab, we separated a sample of benzion and benzoic acid. We tested the purity of the samples we obtained using a TLC plate. All of our benzoin spots also showed an impurity of benzoic acid. However, our benzoic acid spot did not show an impurity of benzoin. Why is this?
In an organic chemistry lab we were looking at the substrate and nucleophile effects in Sn2...
In an organic chemistry lab we were looking at the substrate and nucleophile effects in Sn2 reactions. Our experimental data showed that 1-bromobutane with 1.0mL of 0.25M NaI in 2-Butanone reacted faster than 1-bromobutane with 1.0mL 0.50M NaI in 2-butanone. Also, our experimental data showed that 1-bromobutane with 1.0mL of 0.50M NaI reacted faster than 1-bromobutane with 2.0mL of 0.05M NaI. These result are the opposite of the theoritcal rate aren't they? From my understanding, the Sn2 reaction rate should...
Pre-lab 1. Provide the Lewis structures for the organic molecules of benzoic acid, C6H5CO2H, and o-methoxybenzaldehyde,...
Pre-lab 1. Provide the Lewis structures for the organic molecules of benzoic acid, C6H5CO2H, and o-methoxybenzaldehyde, CH3OC6H4C(O)H. 2. Describe the intermolecular forces involved with each compound. 3. Formulate a hypothesis regarding the melting point relation between benzoic acid, C6H5CO2H, and o-methoxybenzaldehyde, CH3OC6H4C(O)H, using intermolecular forces terminology.
A chemistry graduate student is given 300.mL of a 1.10M benzoic acid HC6H5CO2 solution. Benzoic acid...
A chemistry graduate student is given 300.mL of a 1.10M benzoic acid HC6H5CO2 solution. Benzoic acid is a weak acid with Ka=6.3x10^−5. What mass of KC6H5CO2 should the student dissolve in the HC6H5CO2 solution to turn it into a buffer with pH =4.40? You may assume that the volume of the solution doesn't change when the KC6H5CO2 is dissolved in it. Be sure your answer has a unit symbol, and round it to 2 significant digits
This is Organic Chemistry Lab, Solvent Extraction. 1. What are the criteria for solubility of organic...
This is Organic Chemistry Lab, Solvent Extraction. 1. What are the criteria for solubility of organic molecules in water? 2. If methylene chloride was used as the organic solvent in solvent extraction, instead of ether, what would the top layer be in the separation step? 3. What formula was used to calculate interaction of organic compounds with the stationary phase? 4. In the given mixture (liquid-liquid), which compound (be specific) has the weakest interaction with the stationary phase? Why?
I did an organic chemistry lab where I purified a sample of crude biphenyl. The following...
I did an organic chemistry lab where I purified a sample of crude biphenyl. The following questions are in regard to the lab. a. More polar solvents move molecules more rapidly than less polar solvents. If you used a 1:1 hexanes: methanol instead of the 4:1 hexanes:ethyl acetate, would the products elute fater or slower? is the mixture of 1:1 hexanes:methanol a good choice as an eluent with biphenyl? b. Why do impure compounds have lower melting points than the...
In the Week 2 lab, we determined the partition coefficients of benzoic acid between the binary...
In the Week 2 lab, we determined the partition coefficients of benzoic acid between the binary solvent systems CH2Cl2 / H2O and CH2Cl2 / (10% NaHCO3). a. Explain why the observed partition coefficient for CH2Cl2 / H2O is greater than for CH2Cl2 / (10% NaHCO3). b. Compared to CH2Cl2 / H2O, what change would you expect to see in the partition coefficient for benzoic acid if 1M HCl were used as the aqueous solvent? What about 1M NaOH? Why
In organic chemistry lab we just completled a "Lidocaine Synthesis". I have some questions to clarify...
In organic chemistry lab we just completled a "Lidocaine Synthesis". I have some questions to clarify before we take the in class exam. 1. Based on apperence and melting point; how can we validate if the crystals are pure lidocaine? 2. When using the seperatory funnel in extraction, we washed the organic layer with water and would shake then drain the aqueous layer out. After a couple of washes with water, we then use HCL to extract and collect this...
This lab experiment is on the preparation of benzoic acid: a Grignard reaction. In the procedure:...
This lab experiment is on the preparation of benzoic acid: a Grignard reaction. In the procedure: following the addition of carbon dioxide; then 6M HCL(aq); diethyl ether was added and the aqueous layer discarded; then 6M NaOH(aq) was added and the ether layer discarded; Finally, concentrated HCL(aq) was added and a precepitate formed, which was filtered and rinsed with cold deionized H2O. The purpose of these steps was to isolate, and thus purify, benzoic acid from both water-soluble and organic-soluble...
Physical Chemistry Thermodynamics: The enthalpy of combustion of benzoic acid (C6H5COOH) is commonly used as the...
Physical Chemistry Thermodynamics: The enthalpy of combustion of benzoic acid (C6H5COOH) is commonly used as the standard for calibrating constant-volume bomb calorimeters; its value has been accurately determined to be —3226.7 kJ mol-1, (a) When 0.9862 g of benzoic acid was oxidized, the temperature rose from 21.84°C to 25.67°C. What is the heat capacity of the calorimeter? (b) In a separate experiment, 0.4654 g of glucose (C6H1206) was oxidized in the same calorimeter, and the temperature rose from 21.22°C to...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT