Compound Y has a solubility of 2.0 g/100 mL in water and 20.0 g/100 mL of...

Compound Y has a solubility of 2.0 g/100 mL in water and 20.0 g/100 mL of ether. What mass of compound Y would be removed from a solution of 1.8 g of Y in 100 mL of water by a single extraction with 100 mL of ether? What mass of compound Y would be removed from the original water solution by two extractions using 50 mL of ether each time?

Solutions

Expert Solution

queen_honey_blossom answered 1 year ago

Next > < Previous

Related Solutions

Sodium nitrate has a solubility of 92.1 g/100 ml of water at 20°C. Calculate the solubility...

Sodium nitrate has a solubility of 92.1 g/100 ml of water at 20°C. Calculate the solubility product.

Given: • The solubility of X at 100ºC in water is 18.0 g/100 mL water. •...

Given: • The solubility of X at 100ºC in water is 18.0 g/100 mL water. • The solubility of X at 0ºC in water is 3.6 g/100 mL water. How many mL of boiling water would be required to dissolve 25g of X? If that solution was then cooled down to 0ºC, how many grams of X could then crystallize out? What would be the maximum yield recovery for X?

1. Assume that the solubility of caffeine in water is 4.0 g/100 mL and in methylene...

1. Assume that the solubility of caffeine in water is 4.0 g/100 mL and in methylene chloride it is 16.0 g/100 mL at 25°C. What is KD for this system? 3. Once you calculate KD, calculate how much caffeine would be extracted by mixing 1.0 g of caffeine in 100 mL of water and performing three consecutive extractions with 25 mL CH2Cl2 each time. Show your work. 2. Assume you changed the solvent to ethyl acetate which has a KD...

The solubility of phthalic acid in water is 0.54 g/100 mL at 14 C and 18...

The solubility of phthalic acid in water is 0.54 g/100 mL at 14 C and 18 g/100 mL at 99 C.What is the smallest volume of boiling water that should be used to recrystallize 600 mg of phthalic acid from hot water? You will have to recrystallize many compounds throughout organic I and II. Write a short procedure on how you would do a simple recrystallization( no hot gravity filtration involved). Assume you know which solvent to use but not...

19. The solubility of ammonium nitrate in water at 25°C is 118 g per 100 mL...

19. The solubility of ammonium nitrate in water at 25°C is 118 g per 100 mL of water and the density of a saturated aqueous solution of ammonium nitrate is 1.296 g/mL. Determine the concentration of a saturated aqueous ammonium nitrate solution in the following units. a) Molarity b) Molality c) Mole Fraction d) Weight Percent e) ppm 25. A 0.944 M solution of glucose in water has a density of 1.0624 g/mL at 20°C. What is the concentration of...

The solubility of SImpsonium in toluene is 7.50g/100 mL and its solubility in water is 30.0...

The solubility of SImpsonium in toluene is 7.50g/100 mL and its solubility in water is 30.0 g/mL. Estimate the distribution coefficient of Simpsonium between toluene and water. The options are A. 0.250 B. 22.5 C. 37.5 D. 225 I do not understand how to set this equation up or where to get the numbers from, so please show all steps. Thank you.

The solubility of benzoic acid in water is 6.80g per 100 mL at 100 ℃, and 0.34g per 100 mL at 25 ℃.

The solubility of benzoic acid in water is 6.80g per 100 mL at 100 ℃, and 0.34g per 100 mL at 25 ℃.(a) Calculate the min. volume of water needed to dissolve 1.00g of benzoic acid at 100 ℃. (b) Calculate the maximum theoretical percent recovery from the recrystallization of 1.00g benzoic acid from 15 mL of water assuming the solution is filtered at 25 ℃?

1. Glucose has a solubility of 125 g /100 mL. What is the approximate concentration of...

1. Glucose has a solubility of 125 g /100 mL. What is the approximate concentration of glucose in a saturated solution? How much glucose can be dissolved in 745 mL of water? [glucose] _________ M Glucose _________ g 2. Determine whether the following salts or molecules will have higher or lower solubility in water at higher temperatures. KCl(s) + H2O(l) KCl(aq), ?Hrxn > 0 __________ NH3(g) + H2O(l) NH3(aq), ?Hrxn< 0 __________ 3. BaF2 has a Ksp of 2.45 x...

MW (g/mol) / MP ( oC) / Solubility in cold H2O (g / 100 mL) /...

MW (g/mol) / MP ( oC) / Solubility in cold H2O (g / 100 mL) / Solubility in boiling H2O (g / 100 mL) Acetanilide 135.2 / 114 / 0.54 / 5.0 Phenacetin 179.2 / 135 / 0.076 / 1.22 Using solubility data in the table of reagents, calculate the minimum amount water needed to recrystallize: i. 1.5 g of phenacetin. ii. 1.5 g of acetanilide. b. If the minimum amount of water needed is used, how many grams of...

A 5.59 g sample of a solid containing Ni is dissolved in 20.0 mL water. A...

A 5.59 g sample of a solid containing Ni is dissolved in 20.0 mL water. A 5.00 mL aliquot of this solution is diluted to 100.0 mL and analyzed in the lab. The solution was determined to contain 5.70 ppm Ni. Determine the molarity of Ni in the 20.0 mL solution. Determine the mass in grams of Ni in the original sample. Determine the weight percent of Ni in the sample.

Subjects