Explain the operation of the isolation amplifier. Design a
circuit that takes an input voltage and...
Explain the operation of the isolation amplifier. Design a
circuit that takes an input voltage and outputs a scaled
differentiated version of the input minus a scaled version of the
input, at the output of the circuit
Design a logic circuit that takes 2-bit input A and 2-bit input
B and subtracts the two numbers using full adders and inverters
with full adders diagram, which input is subtracted dos not
matter.
Design a circuit where the voltage across the capacitor matches
the input step function as closely as possible. Sketch/show a
picture of your result and which circuit parameters (R and C you
used). Explain why the output looks like it does.
Design a circuit where the voltage across the capacitor looks
like a triangle wave (each peak looks like a triangle). Sketch/show
a picture of your result and which circuit parameters (R and C you
used). Explain why the output...
Design a combinational logic circuit that takes a single digit
decimal number as its input and also detects if the input is an odd
number.
Design a combinational circuit that accepts a 3-bit number and
generates an output binary number equal to the square of the input
number.
1. the use of Amplifier Loading in a circuit.?
2. the DC operation of a BJT using an equivalent model in terms
of base current (master) and output current (slave) loops.
Design a complete single-stage amplifier using transistor to
amplifier a sine-wave voltage signal with an amplitude of 2 mV,
frequency range from 20-20kHz and internal resistance of 1k ohm.
the output of the amplifier supplies to a load of 5k ohm and the
required voltage amplitude around 300 mV.
Suppose that you design an amplifier circuit but measuring the
output on the oscilloscope shows that it is just oscillating
wildly. List the first three things to check to understand what is
causing the oscillation.
Explain the basic operation of an operation amplifier. What are
the most significant characteristics of such a device and in
designing a circuit what parameters of the device must be
considered?
Design a “disk spinning” animation circuit for a CD player. The
input to the circuit will be a 3-bit binary number A1, A2, A3
provided by 3-bit up counter. The circuit for 3-bit counter has
already been provided in CCT file on Google Classroom, so there is
no need to design the up counter yourself.
The animation will appear on the top four lights of the LED display
of Figure, i.e., on X1, X2, X7, and X6, going clockwise as...