Question

In: Mechanical Engineering

QUESTION 16 – COOLING TOWERS AND EVAPORATIVE CONDENSERS Water flows at 5000 kg/h and 40°C into...

QUESTION 16 – COOLING TOWERS AND EVAPORATIVE CONDENSERS Water flows at 5000 kg/h and 40°C into a cooling tower and is cooled to 26°C. The unsaturated air enters the tower at 20°C with a relative humidity of 0.4. It leaves as saturated air at 30°C. The pressure is constant at 1 bar throughout. Calculate (a) the mass flow of air per hour. (b) the mass of water evaporated per hour.

Solutions

Expert Solution


Related Solutions

1. A circus performer stretches a 16 kg tightrope between two towers separated by 40 meters....
1. A circus performer stretches a 16 kg tightrope between two towers separated by 40 meters. He strikes one end of the rope and sends a wave along it toward the other tower. He notes that it takes the wave on the string 2.9 seconds to reach the opposite tower and come back. (a) At what frequency would he have to hop up and down to create a standing wave with 5 nodes? (b) What tension would the rope have?
Coal with 40% C, 30% H and 30% ash by weight at 1000 kg / h...
Coal with 40% C, 30% H and 30% ash by weight at 1000 kg / h flow (school the last digit of your number) is burned with dry air fed by kmol / second. Chimney from the oven In addition to its gas, there is a solid waste, 95% of this waste is all of the ash in coal, back the rest is unburned carbon. While all the hydrogen in the fuel is oxidized to water; carbon burns so that...
Water at a flow rate of 20,000 kg/h will be heated from 20°C to 35°C by...
Water at a flow rate of 20,000 kg/h will be heated from 20°C to 35°C by hot water at 140°C. A 15°C hot water temperature drop is allowed. A number of 3.5 m hairpins of 3 in. (ID = 0.0779 m) by 2 in. (ID = 0.0525 m, OD = 0.0603 m) counter flow double-pipe heat exchangers with annuli and pipes, each connected in series, will be used. Hot water flows through the inner tube. Fouling factors are: Rf i...
Water flowing at a rate of 0.03 kg/s is heated from 20 to 40°C in a...
Water flowing at a rate of 0.03 kg/s is heated from 20 to 40°C in a horizontal pipe (inside diameter = 3 cm). The inside pipe surface temperature is 70°C. Estimate the convective heat transfer coefficient if the pipe is 1 m long. Assume forced convection conditions.  Ts is not held constant! Properties of Water 20°C 30°C 40°C ρ (kg/m3) 998.2 995.7 992.2 k (W/mK) 0.597 0.615 0.633 μ (Pa s) 993.414 x 10-6 792.377 x 10-6 658.026 x 10-6 Cp...
Water at 15°C enters a tube of 2 cm of diameter with flow rate 3953 kg/h....
Water at 15°C enters a tube of 2 cm of diameter with flow rate 3953 kg/h. Assume the ratio L/D >10, and the wall temperature is constant at 80◦C. The outlet temperature is 50°C The properties of water at the film temperature are density rho = ? = 985 ?/?3, specific heat ?p = 4180 ?/?, conductivity ? = 0.651 ?/?, dynamic viscosity mu= ?? = 4.71 × 10−4 ?/?, At the wall temperature of 80°C we have dynamic viscosity...
Suppose 1.16 kg of water at 11.6 ◦C is mixed with 1.7 kg of water at...
Suppose 1.16 kg of water at 11.6 ◦C is mixed with 1.7 kg of water at 81◦C. After equilibrium is reached, the mixture has an uniform temperature of 52.8517◦C. What is the change in entropy of the system? The specific heat of water is 4186 J/kg · K. Answer in units of J/K.
order: heparin 50 units/kg (max of 5000 units) and start infusion at 20 units/kg/h supply: heparin...
order: heparin 50 units/kg (max of 5000 units) and start infusion at 20 units/kg/h supply: heparin 25,000 units diluted in a 250 mL bag to give a concentration of 100 units/mL patient weight 135 lbs 1. calculate the heparin bolus to the nearest hundred? mL 2. infusion rate in mL/h in whole number
Newton's Law of Cooling: Boil water in a cup and cool in a room at 32∘C....
Newton's Law of Cooling: Boil water in a cup and cool in a room at 32∘C. Assume that Newton's Law of Cooling is satisfied: the rate of change of water temperature is proportional to the difference between the temperature of the water and the temperature of the environment. We take the water temperature after 5 minutes and find it to be 83∘C. Establish and solve an Initial Value Problem to express the water temperature as a function of time, graph...
Question 1) Water at 20 C flows through a galvanized pipe at an average speed of...
Question 1) Water at 20 C flows through a galvanized pipe at an average speed of 2.5 m / s. The diameter of the pipe is 150 mm. The roughness of the pipe surface is 60 μm. Calculate the pressure drop in this pipe since the total length of the pipe is 300 meters. Take the necessary values for calculations from tables and diagrams.
Water Cost (in$) Number of house (fi) 20 -<40 16 40 -< 60 9 60 -<...
Water Cost (in$) Number of house (fi) 20 -<40 16 40 -< 60 9 60 -< 80 12 80 - < 100 10 Total 47 1.Calculate the mean cost of water. 2.Calculate the variance. 3.Calculate the mode
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT