Question

In: Mechanical Engineering

Air flows steadily through a converging-diverging nozzle with a throat area equal to 1.395 in2 ,...

Air flows steadily through a converging-diverging nozzle with a throat area equal to 1.395 in2 , and an exit area equal to 2.79 in2 . A normal shock wave stands at the exit plane of the nozzle. The exiting jet flows into a large room, where the pressure is equal to 14.7 psia. The temperature of the air in the exit jet stream, just after the nozzle exit, is measured at 87 deg F. Calculate the mass flow rate through the nozzle. Calculate the pressure, temperature and velocity at a location in the nozzle where the flow area is equal to 5.58 in2 .

keep in English units

Solutions

Expert Solution

samet mamat answered 2 years ago
Next > < Previous

Related Solutions

Air flows in a converging-diverging nozzle. The nozzle throat area is 50 cm2. The total pressure...
Air flows in a converging-diverging nozzle. The nozzle throat area is 50 cm2. The total pressure at the nozzle inlet is 1 MPa. The total pressure at the nozzle exit is 650 kPa. The Mach number at the nozzle exit is 0.70. Find the nozzle exit area. 51.7 cm2 84.2 cm2 35.6 cm2 54.7 cm2
Consider a converging-diverging nozzle with an exit-to-throat area of 3. The inlet reservoir pressure is 1...
Consider a converging-diverging nozzle with an exit-to-throat area of 3. The inlet reservoir pressure is 1 atm and the exit pressure is 0.5 atm. (a) For this pressure ratio a normal shock will stand somewhere inside the divergent portion of nozzle. Calculate the location of shock (A/At =?). (b) back pressure if the flow were isentropic throughout.
compressible flow: a converging-diverging nozzle has an area ratio of 5 and a stagnation pressure of...
compressible flow: a converging-diverging nozzle has an area ratio of 5 and a stagnation pressure of 1 MPa. Assume that the gas in the nozzle behaves exactly like air. Which of the following most accurately gives the range of nozzle exit pressures for which the flow is choked, but has subsonic flow at the nozzle exit? a)990 kPa ?? 1 MPa b)244 kPa ?? 1 MPa c)21 kPa ?? 1MPa d)1 kPa ?? 1 MPa e)244 kPa ?? 990 kPa...
A converging–diverging nozzle is designed to generate an exit Mach number of 2. The nozzle is...
A converging–diverging nozzle is designed to generate an exit Mach number of 2. The nozzle is supplied with air from a large reservoir in which the pressure is kept at 6.5 MPa. Assuming one-dimensional isentropic flow, find a. The maximum back-pressure at which the nozzle will be choked b. The range of back-pressures over which there will be a shock in the nozzle c. The design back-pressure d. The range of back-pressures over which there is supersonic flow on the...
A converging-diverging nozzle is designed to operate with an exit Mach number of 2. The nozzle...
A converging-diverging nozzle is designed to operate with an exit Mach number of 2. The nozzle is supplied from an air reservoir at 600 kPa and temperature is 300 K. The throat area of the nozzle is 5 cm2 . Determine: (a) The ratio of exit-to-throat area and exit area (b) Given the area ratio in part (a), find the range of back pressure over which the nozzle is choked. What is the critical pressure and design pressure? Also, calculate...
A converging-diverging nozzle is designed to operate with an exit Mach number of 2. The nozzle...
A converging-diverging nozzle is designed to operate with an exit Mach number of 2. The nozzle is supplied from an air reservoir at 600 kPa and temperature is 300 K. The throat area of the nozzle is 5 cm2. Determine: (a) The ratio of exit-to-throat area and exit area. (b) Given the area ratio in part (a), find the range of back pressure over which the nozzle is choked. What is the critical pressure and design pressure? Also, calculate the...
1.      Air enters a converging-diverging nozzle with a total pressure of 1100 kPa and a total temperature...
1.      Air enters a converging-diverging nozzle with a total pressure of 1100 kPa and a total temperature of 127°C.  The exit area to throat area ratio is 1.8.  The throat area is 5 cm2.  The velocity at the throat is sonic and the diverging section acts as a nozzle.  Determine the following: a.       The mass flow rate b.      The exit pressure and temperature c.       The exit Mach number d.      The exit velocity 2.      The converging-diverging nozzle now has a throat area of 100 mm2 and an exit area of 160...
Air flows through a nozzle which has inlet areas of (10 cm2 ). If the air...
Air flows through a nozzle which has inlet areas of (10 cm2 ). If the air has a velocity of (120 m/s) a temperature (300K) and a pressure of (700kpa) at the inlet section and a pressure of (250kpa) at the exit, find the mass flow rate through the nozzle and the velocity at the exit of the nozzle, assuming one- dimensional isentropic flow. (R=287 J/kg. K), (K=1.4). (25%)
A convergent–divergent nozzle with an exit area to throat area ratio of 3 is supplied with...
A convergent–divergent nozzle with an exit area to throat area ratio of 3 is supplied with air from a reservoir in which the pressure is 350 kPa. The air from the nozzle is discharged into another large reservoir. It is found that the flow leaving the nozzle exit is directed inward at an angle of 4° to the nozzle centerline. The velocity on the nozzle exit plane is supersonic. What is the pressure in the second reservoir?
3) Air flows steadily at the rate of 0.4 kg/s through an air compressor, entering at...
3) Air flows steadily at the rate of 0.4 kg/s through an air compressor, entering at 6 m/s with a pressure of 1 bar and a specific volume of 0.85 m3/kg, and leaving at 4.5 m/s with       a pressure of 6.9 bar and a specific volume of 0.16 m3/kg. The internal energy of air leaving is 88 kJ/kg greater than that of the air entering. Cooling water in a jacket surrounding the cylinder absorbs heat from the air at...
ADVERTISEMENT
Subjects
ADVERTISEMENT
Latest Questions
ADVERTISEMENT