Question

In: Chemistry

A 2.20 g sample of the Ethane C2H6 gas was mixed with excess oxygen gas and...

A 2.20 g sample of the Ethane C2H6 gas was mixed with excess oxygen gas and a combustion reaction occurred to obtain water in liquid aggregate and carbon dioxide state. The combustion reaction occurred at a constant calorimeter under standard conditions.
After the reaction was completed, the temperature in the calorimeter rose by 1.3K. The heat capacity of the calorimeter is 88.8 kJ / K.


1. Write a balanced response to the burning process that took place.
2. Consider the change in standard enthalpy, ∆H for a 1 molar reaction of ethane. Show calculations.
3. Explain how you would calculate ∆Hf [C2H6(g)] given you values ​​of:
∆Hf [CO2(g)] and ∆Hf [H2O(l)]
Numerical calculations are not required.
4. Determine what the missing data is to calculate the change in the fire enthalpy,
∆Hc of ethane at 100 C?
5. Is a difference between ∆Ho and ∆Uo expected for the reaction formulated in section a? Explain

Solutions

Expert Solution

This question is related to combustion reaction.

I am giving step by step solution on page.

Please find it.


Related Solutions

The gas ethane, C2H6(g), can be used in welding. When ethane is burned in oxygen, the...
The gas ethane, C2H6(g), can be used in welding. When ethane is burned in oxygen, the reaction is: 2 C2H6(g) + 7 O2(g)------>4 CO2(g) + 6 H2O(g) (a) Using the following data, calculate ΔH° for this reaction. ΔH°f kJ mol-1:   C2H6(g) = -84.0 ; CO2(g) = -393.5 ; H2O(g) = -241.8 ΔH° = ___________ kJ (b) Calculate the total heat capacity of 4 mol of CO2(g) and 6 mol of H2O(g), using CCO2(g) = 37.1 J K-1 mol-1 and CH2O(g)...
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of...
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of ethane enters the reactor at 25.8 mol/hr and 93.7°C. The stream exiting the reactor contains ethane, oxygen, carbon dioxide (CO2), carbon monoxide (CO) and water (H2O), so ethane reacts by both complete and partial combustion reactions. The conversion of ethane is 15.8% and the conversion of oxygen is 12.3%. Assume that pressure effects are negligible. (a) Draw and label a process flow diagram. Number...
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of...
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of ethane enters the reactor at 25.8 mol/hr and 93.7°C. The stream exiting the reactor contains ethane, oxygen, carbon dioxide (CO2), carbon monoxide (CO) and water (H2O), so ethane reacts by both complete and partial combustion reactions. The conversion of ethane is 15.8% and the conversion of oxygen is 12.3%. Assume that pressure effects are negligible. a.Draw and label a process flow diagram. Number each...
16.05 g of methane (CH4) gas is mixed with 101.12 g of oxygen (O2) gas. The...
16.05 g of methane (CH4) gas is mixed with 101.12 g of oxygen (O2) gas. The mixture is ignited. After a bright flash and a loud bang, some water droplets form on the inside of the reaction vessel. A) Write the balanced chemical reaction for the combustion of methane . B) How many moles of water can you make? C) How many moles of CO2 can you make? D) Will anything be left over? What? Yes, there will be oxygen...
28.06 g of ethene (C2H4) gas is mixed with 158.72 g of oxygen (O2) gas. The...
28.06 g of ethene (C2H4) gas is mixed with 158.72 g of oxygen (O2) gas. The mixture is ignited. After a bright flash and a loud bang, some water droplets form on the inside of the reaction vessel. PART A How Much Oxygen is left over? PART B Calculate the theoretical Yield of Water. PART C Calculate the theoretical yield of Carbon Dioxide.
For the following reaction, 3.46 grams of hydrochloric acid are mixed with excess oxygen gas. The...
For the following reaction, 3.46 grams of hydrochloric acid are mixed with excess oxygen gas. The reaction yields 0.728 grams of water. hydrochloric acid (aq) + oxygen (g) water (l) + chlorine (g) What is the theoretical yield of water ? What is the percent yield of water ?
100 moles of ethane (C2H6) are burned with 50% excess air. The percentage conversion of the...
100 moles of ethane (C2H6) are burned with 50% excess air. The percentage conversion of the ethane is 90%; of the ethane burned, 25% reacts to form CO and the balance reacts to form CO2. Calculate the molar composition of the stack gas on a dry basis and the mole ratio of water to dry stack gas.
The chlorination of ethane proceeds as follows: C2H6(g) + Cl2(g) --> C2H5Cl(g) + HCl(g) However, some...
The chlorination of ethane proceeds as follows: C2H6(g) + Cl2(g) --> C2H5Cl(g) + HCl(g) However, some of the formed chloroethane further reacts with excess chlorine in an undesired side reaction: C2H5Cl(g) + Cl2(g) --> C2H4Cl2(g) + HCl(g) If only C2H6 and Cl2 are in the feed stream, determine their feed ratio (mol C2H6/mol Cl2) and the % yield of C2H5Cl given that the fractional conversion of C2H6 is 0.350 and the selectivity is 12. All chlorine is consumed in the...
Three gases (8.00 g of methane, CH4, 18.0 g of ethane, C2H6, and an unknown amount...
Three gases (8.00 g of methane, CH4, 18.0 g of ethane, C2H6, and an unknown amount of propane, C3H8) were added to the same 10.0-L container. At 23.0 ∘C, the total pressure in the container is 5.00 atm . Calculate the partial pressure of each gas in the container. Express the pressure values numerically in atmospheres, separated by commas. Enter the partial pressure of methane first, then ethane, then propane. Part B A gaseous mixture of O2 and N2 contains...
part A)Three gases (8.00 g of methane, CH4, 18.0 g of ethane, C2H6, and an unknown...
part A)Three gases (8.00 g of methane, CH4, 18.0 g of ethane, C2H6, and an unknown amount of propane, C3H8) were added to the same 10.0-L container. At 23.0 ∘C, the total pressure in the container is 4.80 atm . Calculate the partial pressure of each gas in the container. Express the pressure values numerically in atmospheres, separated by commas. Enter the partial pressure of methane first, then ethane, then propane. Part B) A gaseous mixture of O2 and N2...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT