Question

In: Biology

A CSTR is used in production of A → R Feed enters the reactor at a...

A CSTR is used in production of A → R Feed enters the reactor at a rate of vo(L/s), and the concentration of the reactant in the feed is CAo (mol A/L) The volume of the tank is V(L). Assume that the process is a well-mixed process, so that the concentration of A in product stream equals that in the tank. For this process, the rate of consumption of A equals kCA[mol/ (s L of reaction volume)] Assume that all fluids (feeds, tank contents and product) have the same density, ρ(g/L).
Write differential balance on total mass and mole of A, expressing the balances in term of the variables shown on the diagram below.

Solutions

Expert Solution

CSTR(Continous stirred tank reactor) is areactor runs at steady state with continous flow of reactants and products.Feed assumes a uniform composition throughout the reactor,exit stream has the same composition as in the tank.


Related Solutions

What are the operating conditions of ( plug flow reactor - CSTR - plug bed reactor...
What are the operating conditions of ( plug flow reactor - CSTR - plug bed reactor - batch reactor - semi-batch reactor ) ?
Consider a gaseous feed, CA0=100, CB0=200, enters a flow reactor at T0=1000 K and ?0= 5...
Consider a gaseous feed, CA0=100, CB0=200, enters a flow reactor at T0=1000 K and ?0= 5 atm. The reaction, ? + ? → 5?, occurs in the reactor. Calculate the XA, XB and CB if the exit stream leaves at T=400 K and ? = 4 atm. (Assume ideal gas behavior).
A well-mixed stirred tank reactor has a volume of 200 L. The feed to the reactor...
A well-mixed stirred tank reactor has a volume of 200 L. The feed to the reactor is a stream with a flow rate of 50 L/min that has a concentration of species A equal to 5 moles/L. This species undergoes a reaction in the tank of the form A ----> B The rate of the reaction (rate of consumption of A) is given by rA=kCa with K = 4 min-1. The exit stream from the reactor is also 50 L/min...
An isothermic reaction is carried out adiabatically and the CSTR reactor design algorithm is shown as...
An isothermic reaction is carried out adiabatically and the CSTR reactor design algorithm is shown as below: The reaction is second order in A. The feed which is equimolar in a solvent and A, and its enters the reactor at a total volumetric flow rate, v0 of 10 dm3/min with the initial concentration of A being 4 M. The rate constant, k given as 0.1 dm3/mol.min at 380 K. Determine the conversion can be achieved in 600 dm3 CSTR by...
Experiment data taken in a batch reactor predicted the CSTR conversion should be 50%. However, the...
Experiment data taken in a batch reactor predicted the CSTR conversion should be 50%. However, the concentration measured in the actual CSTR was 57%. Suggest a reason for the discrepancy between the predicted and measured conversion.
With two possible reactions in parallel, which type of reactor (CSTR, Batch, or Plug Flow) will...
With two possible reactions in parallel, which type of reactor (CSTR, Batch, or Plug Flow) will you choose to maximize selectivity? F-->P1 r1= k1(CF)^a1 F-->P2 r2= k2(CF)^a2
Explain the theory behind a steady state continuous stirred-tank reactor (aka CSTR) and as well an...
Explain the theory behind a steady state continuous stirred-tank reactor (aka CSTR) and as well an unsteady state CSTR.
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of...
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of ethane enters the reactor at 25.8 mol/hr and 93.7°C. The stream exiting the reactor contains ethane, oxygen, carbon dioxide (CO2), carbon monoxide (CO) and water (H2O), so ethane reacts by both complete and partial combustion reactions. The conversion of ethane is 15.8% and the conversion of oxygen is 12.3%. Assume that pressure effects are negligible. (a) Draw and label a process flow diagram. Number...
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of...
Ethane (C2H6) is combusted in 18.1% excess oxygen (O2) in an adiabatic reactor. The feed of ethane enters the reactor at 25.8 mol/hr and 93.7°C. The stream exiting the reactor contains ethane, oxygen, carbon dioxide (CO2), carbon monoxide (CO) and water (H2O), so ethane reacts by both complete and partial combustion reactions. The conversion of ethane is 15.8% and the conversion of oxygen is 12.3%. Assume that pressure effects are negligible. a.Draw and label a process flow diagram. Number each...
Gaseous feed to the reactor composition 75% butane ( C3H8) and 25% hydrogen ( percent by...
Gaseous feed to the reactor composition 75% butane ( C3H8) and 25% hydrogen ( percent by volume) is burned in a reactor with 25% excess air. The percentage conversion of butane to CO2 95% and the balance to CO. Calculate the mole composition of the stack
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT