Q1/ Multi Choices (25 Degrees) 1-one of the Advantages of Maintenance in power plant . A....

Q1/ Multi Choices (25 Degrees)
1-one of the Advantages of Maintenance in power plant .
A. Greater safety for workers.
B. To increase efficiency
C. To increase repair cost
D. To increase power
2- Used to conduct hot gas (flame) from one Combustion chamber to the next
A. Flow Sleeves
B. Support Clamp
C. Flame Detector
D. Cross Fire Tubes
3- Used to provide seal between transition piece and first stage nozzle
A. liner
B. Floating Seals
C. Flame Detector
D. Cross Fire Tubes
4- Provide frequency signal ( flame intensity) to control system
A. Cross Fire Tubes
B. Support Clamp
C. Flame Detector
D. Flow Sleeves
5- During combustion inspection can see many problem
A. Foreign Objects
B. Abnormal
C. Hot Spots
D. All Above
6- Borescope inspection can check for
A. Bleed valves
B. all the internal parts
C. Air Filter
D. Lube Oil System
7- The boilers contain
A. Superheater
B. Reheater
C. Economiser
D. A

Solutions

Expert Solution

please note, expert are allowed to solve only one question in case of multiple questions and maximum 4 questions for short type answers. Please upload question again and mention question no

samet mamat answered 1 year ago

Next > < Previous

Related Solutions

1. What is a multi-enzyme complex? What are the advantages of a multi-enzyme complex? 2. What...

1. What is a multi-enzyme complex? What are the advantages of a multi-enzyme complex? 2. What is the function of each of the three catalytic enzymes that make up pyruvate dehydrogenase? What is the role of prosthetic groups TPP and lipoic acid and which enzyme is each attached to? 3. What are the substrates and the products of the steps in the Citric Acid Cycle where CO2, NADH, and FADH2 are produced?

1. A multi-plant monopolist will maximize profits where a. the marginal revenue in each plant is...

1. A multi-plant monopolist will maximize profits where a. the marginal revenue in each plant is equal to the marginal cost in this plant b. the marginal revenue of monopoly is equal to the marginal cost of each plant c. average cost is at its minimum in both plants d. none of the above

An adiabatic steam power plant turbine receives 500kg/s in steady flow at 8MPa and 500 degrees...

An adiabatic steam power plant turbine receives 500kg/s in steady flow at 8MPa and 500 degrees C(state 1), the steam exits at 15kPa with quality of 0.95(state 2 actual). Find a) isentropic power output of the turbine using listed pressures, b) actual power output of the turbine, c) isentropic efficiency of the turbine, d) s2-s1

An adiabatic steam power plant turbine receives 500kg/s in steady flow at 8MPa and 500 degrees...

A power company operates three power generation plants. One is a wind plant, and the other...

A power company operates three power generation plants. One is a wind plant, and the other two consume a combination of Fuel 1 and Fuel 2, emitting carbon dioxide in the process. In addition, all three plants require maintenance. The amount of fuel consumed (in Mg), maintenance required (in person-hours), carbon dioxide (CO2) emitted (in Mg), and power generated (in MWh) per day of operation is as follows: Maintenance Fuel 1 Fuel 2 CO2 Power Plant Required Required Required Emitted...

Q1. A hydroelectric power plant uses the reaction of ethylene (?2?4) with oxygen to generate vapour....

Q1. A hydroelectric power plant uses the reaction of ethylene (?2?4) with oxygen to generate vapour. The products of this reaction are carbon dioxide and water. Additionally, the reaction produces −1323.16?? per mol of ethylene consumed. a) How much ethylene is required by the power plant if 8500 kg of steam at 120 °C is produced in an hour? (assume 100% yield) (12.5 marks) b) Recalculate your answer for a 75 % yield. (12.5 marks) Assumptions. The heat capacities of...

What are the advantages and disadvantages of a VLAN? Explain your choices in more than one...

What are the advantages and disadvantages of a VLAN? Explain your choices in more than one sentence.

A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam...

A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam enters the first turbine stagge at 12 MPa, 560*C and expands to 1 MPa, where some of the steam is extracted and diverted to the open feedwater heater operating at 1 MPa. The remaining steam expands through the second turbine stage to the condenser pressure of 6 kPa. Saturated liquid exits the open feedwater heater at 1 MPa. The net power output for the...

A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam...

A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam enters the first turbine stage at 12 MPa, 520◦C and expands to 1 MPa, where some of the steam is extracted and diverted to the open feedwater heater at 1 MPa. The remaining steam expands through the second turbine stage to the condenser pressure of 6 kPa. Saturated liquid exits the open feedwater heater at 1 MPa. For isentropic processes in the turbines and...

A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam...

A power plant operates on a regenerative vapor power cycle with one open feedwater heater. Steam enters the first turbine stage at 12 MPa, 560°C and expands to 1 MPa, where some of the steam is extracted and diverted to the open feedwater heater operating at 1 MPa. The remaining steam expands through the second turbine stage to the condenser pressure of 50 kPa. Saturated liquid exits the open feedwater heater at 1 MPa. The net power output for the...

Subjects