Question

In: Physics

explain difference limen for frequency and loudness difference limen

explain difference limen for frequency and loudness difference limen

Solutions

Expert Solution

It is commonly believed that difference limens for frequency (DLFs) for pure tones depend on a temporal mechanism (phase locking) for frequencies up to 4–5 kHz and a place mechanism at higher frequencies. The DLFs predicted from a place mechanism, expressed as a proportion of center frequency (Δf/f), should be approximately invariant with frequency at medium to high frequencies. If there is a transition from a temporal to a place mechanism, Δf/f should increase with increasing center frequency until the transition occurs, and then reach a plateau. Published data do not show such an effect. In this study, DLFs were measured for center frequencies from 2 to 14 kHz, using earphones designed to produce a flat response at the eardrum. The level of every tone was varied over a range of ±4 dB, to reduce loudness cues. The value of Δf/f increased progressively from 2 to 8 kHz, but did not change significantly for frequencies from 8 to 14 kHz. The results are consistent with the idea that there is a transition from a temporal to a place mechanism at about 8 kHz, rather than at 4–5 kHz, as is commonly assumed.


Related Solutions

Using your understanding of the audibility curve, explain how sound frequency might affect perception of loudness....
Using your understanding of the audibility curve, explain how sound frequency might affect perception of loudness. How does the audibility curve demonstrate this?
a. State the difference between personal frequency and excitation frequency b. State the difference in angular...
a. State the difference between personal frequency and excitation frequency b. State the difference in angular frequency and linear frequency c. State the difference between transient response and steady state response d. Mention the different meanings of eigenvalue and eigenvector in the vibration equation e. Mention the difference between viscous and silencer d
Explain the formula of Relative Frequency Probability. Explain the formula of Classical Probability.  Recognize its difference from...
Explain the formula of Relative Frequency Probability. Explain the formula of Classical Probability.  Recognize its difference from the formula of relative frequency probability.  
1.) Explain the difference between a time domain signal and a frequency domain signal. 2.) When...
1.) Explain the difference between a time domain signal and a frequency domain signal. 2.) When would you select the frequency domain signal over the time domain signal.
a) Assuming that the frequency of oscillation is due to the difference in energy between the...
a) Assuming that the frequency of oscillation is due to the difference in energy between the 2p and 1s states of the H atom, and that the amplitude of oscillation is about one Bohr radius, estimate the rate at which energy is classically radiated in eV/s. b) Estimate the classical time it takes for this atom to radiate the energy difference between these two states.
a) Assuming that the frequency of oscillation is due to the difference in energy between the...
a) Assuming that the frequency of oscillation is due to the difference in energy between the 2p and 1s states of the H atom, and that the amplitude of oscillation is about one Bohr radius, estimate the rate at which energy is classically radiated in eV/s. b) Estimate the classical time it takes for this atom to radiate the energy difference between these two states.
The rule of thumb for loudness is that the power of a sound must be increaed...
The rule of thumb for loudness is that the power of a sound must be increaed by a factor of _____ to sound twice as loud. A. 2 B. 12 C. 20 D. 10 E. 100
Based upon the appropriate test, is there a difference in the frequency of Vomit2 by Head_in?...
Based upon the appropriate test, is there a difference in the frequency of Vomit2 by Head_in? Yes or No, and explain why you indicated yes or no. > vomit2_headintable <- table(vomit2, head_in) > vomit2_headintable head_in vomit2 0 1 0 305 639 1 1 10
Explain the vector space model and the term frequency-inverse document frequency.
Explain the vector space model and the term frequency-inverse document frequency.
Explain why the resonance frequency is a double of the driven frequency of the signal generator.
Explain why the resonance frequency is a double of the driven frequency of the signal generator.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT