In: Operations Management
This is for the student's study guide to help them learn.
Examples of fall hazards that have resulted in deaths on the jobsite include:
Falls to the ground or lower levels
Falls through existing floor or roof openings
Falls through the floor or roof surface
Falls on the same level
All the above (correct answer)
2.Incident investigation should focus on:
A.Assigning blame
B.Understanding why the accident or near miss occurred
C.What actions can be taken to preclude recurrence.
D.Both B and C above (correct answer)
3.When you've been assigned a new job or task, be sure to ask about the:
A.Additional pay and benefits
B.Time it takes to drive to the nearest OSHA office
C. Medical expenses that all you coworkers may have
D.Written procedures and any additional training that may be required (correct answer)
4.Underground electrical hazards are _______.
A.Easy to identify
B.Hard to find & pose a serious risk to laborers & equipment operators
(correct answer)
C.Always marked exactly where they are located
D. Always buried in red concrete
5.Underground electrical hazards are _______.
A.Easy to identify
B.Hard to find & pose a serious risk to laborers & equipment operators (correct answer)
6.Although mechanical failures do occur, most accidents while working on with machinery can be attributed to:
A.Bad luck
B.Failure to properly lock and tag out equipment (correct answer)
C.Bad start switch
D.None the above
7. Flying object hazards are especially dangerous when using powder actuated tools because:
A.The force behind the fastener is low and can fool you
B.The force behind the fastener is high and could go through a worker (correct answer)
C.The force behind the fastener doesn't matter
8.Which statement below is true regarding eye wash stations be provided on a job site?
A.OSHA has no requirement for eyewashes on construction job sites
B.Emergency eyewash or shower facilities must meet ANSI requirements. (correct answer)
C.Emergency eye wash and shower stations must be reachable within 10 minutes.
D.There should be enough cold water to flush exposed surfaces for 45 minutes.
9. Respiratory Protection is required for employees exposed to hazardous materials above the permissible exposure limit for particular hazardous materials and engineering controls cannot effectively control hazards. What are the two general types of respirators?
A.Air expelling and Air demanding
B.Cool laminar flow and pressure demand laminar flow
C.Air purifying and Atmosphere supplying (correct answer)
D.PAPR and UAPR
10. What do we know about the Hazard Communication Standard label requirements?
A.There is no standard format, just required elements (correct answer)
B.There are 19 required elements
C.There are only 3 required elements
Please view below for full choices