Question

In: Civil Engineering

A very wide embankment with height of 3m and the soil unit weight 19 kn/m3 to...

A very wide embankment with height of 3m and the soil unit weight 19 kn/m3 to be constructed. Calculate the normal stress, water pressure and effective stress at two positions: At the middle of clay, the depth = 5 m and the saturated unit weight = 27 kn/m3, and at the middle of sand, the depth = 5 and the saturated unit weight = 21 kn/m3.

For two cases

- Before constructing embankment

-Instantly after constructing the embankment

Solutions

Expert Solution


Related Solutions

A 3 m tall, 30 m wide, road embankment made of rockfill with a unit weight...
A 3 m tall, 30 m wide, road embankment made of rockfill with a unit weight of 20 kN/m3 is to be constructed over a 30 m thick normally consolidated clay layer resting on a very permeable fracture rock bed. The clay layer has a coefficient of consolidation cv=7 m^2/month, and a unit weight of γsat=18.5 kN/m3. The compression characteristics of the clay are mr=120, and m=12. a) Determine the time required for the remaining consolidation to be 25 mm...
A retaining wall with sloping back, of vertical height 9m retains soil of density 1.6 Mg/m3,...
A retaining wall with sloping back, of vertical height 9m retains soil of density 1.6 Mg/m3, and angle of friction 30o. The soil slopes upwards at 20o to the horizontal from the back edge of the wall, the angle between the slope and the back of the wall is 100o. Cohesion 10kN/m2, angle of friction between soil and wall is 25o but there is no cohesion between them. Find the thrust on the back wall per metre run using trial...
For a given soil, the following are given: Gs = 2.67; moist unit weight is 17.61...
For a given soil, the following are given: Gs = 2.67; moist unit weight is 17.61 kN/m3, and moisture content = 10.8%. Determine the weight of water, in KN, to be added per cubic meter : 100& degree of saturation (kN/m3)
A clean sand deposit has a total unit weight gabove the groundwater table of 18.9 kN/m3and...
A clean sand deposit has a total unit weight gabove the groundwater table of 18.9 kN/m3and a submerged unit weight of 9.84 kN/m3. The groundwater table is located 1.5 m below ground surface. Standard penetration tests were performed at 3 m below the ground surface with a blow count of 3 blows for the first 150mm, 4 blows for the second 150mm and 5 blows for the third 150mm. Estimate the shear wave velocity of the sand at 3 m...
A cylindrical beaker of height 0.100 m and negligible weight is filled to the brim with a fluid of density ρ = 890 kg/m3 . When the beaker is placed on a scale, its weight is measured to be 1.00 N
A cylindrical beaker of height 0.100 m and negligible weight is filled to the brim with a fluid of density ρ = 890 kg/m3 . When the beaker is placed on a scale, its weight is measured to be 1.00 N .(Figure 1) A ball of density ρb = 5000 kg/m3 and volume V = 60.0 cm3 is then submerged in the fluid so that some of the fluid spills over the side of the beaker. The ball is held...
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT