In: Advanced Math

1)

A full rectangular water tank has a base of 10 ft x 15 ft and is 20 ft high. What is the pressure at the bottom of the tank in a) PSI b) Pa

2)

A cargo ship has a volume of 10,000 cubic meters. The total mass of the ship and cargo is 8 million kg. Will it sink or float at the surface of seawater having a density 1025 kg/m3? Why?

the floating condition is the bouyint force must be greater than or equal to wait of ship. Buoyant force = density*g*volume

La Proeste ut bellus egne Na Ants during a chur in eight Se preth 1 PDV Promo

Volume dephed by the Cargo Ship ey- 10000m² dotal weight of Cargo ship = 800 x qog N Bought tore by ggv s droity - 1025 kg / 7296 1025 296X1000 = 11025x107x9 08 N So here Bougest borce is greater than weight of chip. so ship will that

A rectangular tank with a square base, an open top, and a
volume of 1372 ft cubed is to be constructed of sheet steel. Find
the dimensions of the tank that has the minimum surface area.

A rectangular swimming pool is 5 ft deep, 10 ft wide, and 15 ft
long. The pool is filled with water to 1 ft below the
top. If the weight density of water is 62.4 lb /
ft3 and if x = 0 corresponds to the bottom of
the tank, then which of the following represents the work done (in
ft-lb) in pumping all the water into a drain at the top edge of the
pool?

a
rectangular open tank is to have a square base, and its volume is
to be 125 cubic metrrs. the cost per square meter for the bottom is
$24 and for the sides is $12. find the dimensions of the tank for
which the cost of the material is to be the least. what is the
least cost?

A filled water bed has the dimensions 8.0 ft x 7.0 ft x 0.75 ft.
Determine the mass of water, in kilograms, needed to fill the bed.
Density of water = 1.00 g/cm^3.

1) A tank is full of water. Find the work W required to
pump the water out of the spout. (Use 9.8 m/s2 for
g. Use 1000 kg/m3 as the weight density of
water. Assume that a = 4 m, b = 4 m, c =
12 m,and d = 1 m.)
W = ___ J
I got 5017600 then in scientific notation it would be 5.0176 X
10^6, then in Juls in would be 5.02?
I got the answer...

A 12 in. x 18 in. rectangular beam has an effective span of 20
ft. A dead load of 1500 lb/ft (includes self weight) and a live
load of 4000 lb/ft is applied to the beam. The concrete and steel
strengths are 4000 psi and 60000 psi respectively. Design and
detail the shear reinforcement for the beam. Assume d is 2 inches
less than h

1. A living room is 15 ft x 19 ft. The walls of the room are 8.5
ft tall.
Calculate the total area of the West wall?
How many rolls of wallpaper will you need to cover the wall. One
roll will cover 44 square feet
What will be the cost of the wallpaper? ($14.99 for a pack of 2
rolls)
2. Calculate the following for the remaining walls
Calculate the total area of the North Wall. (Note: You are...

Problem 2: A 3 ft x 5 ft (B x L) rectangular footing is shown in
following figure. Using generalized bearing equation (with shape,
depth and inclination factors), determine the allowable (safe) load
that the foundation carry. Given: gamma = 115 lb/ft3 , c’= 1100
lb/ft2 , phi’ = 35°, Df =3.5 ft, Ground water table is located at 5
ft below ground level. Assume factor of safety = 3. Assume gammasat
= 127.4 lb/ft

5. A large tank of water is full and has a depth of 10.0 m. What is the pressure at the bottom of the tank? What would the velocity of the water be if the tank was opened at the bottom?
6. A Two balloons of identical volume (radius 11.5 m) are filled with gas. The first with helium, the second with hydrogen (H2) gas. Each balloon and cage have a mass of 750 kg. What is the lift...

If the slab is 21 ft wide x 36 ft long x 15 inches deep with the
total steel reinforcement of 20,000 ft of #5 bar. Find the quantity
of concrete required (in cubic yards). The capacity of concrete
truck is 9 cubic yards. Assume waste factor as 10%. Density of
steel is 490 lbs/cubic feet.
(a) Calculate Slab Volume:
(b)Calculate Steel Volume and Weight:
(c) Calculate concrete Volume:

ADVERTISEMENT

ADVERTISEMENT

Latest Questions

- using Matlab only please. function sail_boat x = linspace(0,100,2*pi); for x plot(x, sin(x),'b','LineWidth',3) axis([0,2*pi+.1,-1.05,1.05]) hold on...
- based on the film Trapped, Do you think abortion restrictions might vary according to region? For...
- Route Canal Shipping Company has the following schedule for aging of accounts receivable: Age of Receivables...
- Distinguish between recourse and non recourse debt within a partnership.
- Discuss guaranteed payments within the confines of partnership operations.
- Which of the following team is responsible for mapping solutions with process flow? pick one Production...
- import math import numpy as np import numpy.linalg from scipy.linalg import solve A = np.array([[-math.cos(math.pi/6),0, math.cos(math.pi/3),0,...

ADVERTISEMENT