A pump storage facility takes water from a river at night when demand is low and...

A pump storage facility takes water from a river at night when demand is low and pumps it to a hilltop reservoir 500 ft above the river. The water is returned through turbines in the daytime to help meet peak demand. (a) For a single 30-inch pipe, 2,500 ft long and carrying 20,000 gaVmin, what pumping power is needed if the pump efficiency is 85 percent? The friction loss is estimated to be 15 ft of water. (b) How much power can be generated by the turbines using the same total flow rate? (c) What is the overall efficiency of this installation as an energy storage system?

Expert Solution

SOLUTION:

Amanda K answered 2 years ago

A centrifugal pump is to be used to pump water from a lake to a storage...

A centrifugal pump is to be used to pump water from a lake to a storage tank which is 165 feet above the surface of the lake. The pumping rate is to be 10 - 35 gal/min at a water temperature of 43°F. The water is used for drinking but will have to undergo filtration and chlorine treatment because there is sediment in the lake. The pump on hand can develop a discharge pressure of 60.0 psig pumping at a...

A small water pump is used for an irrigation project. The pump takes water in from...

A small water pump is used for an irrigation project. The pump takes water in from a river at 10oC, 100 kPa at a mass flow rate of 16.83 kg/s. The exit line enters a pipe that goes up to an elevation 26.15 mm above the pump and river, where the water runs into an open channel. Assume the process is adiabatic and that the water stays at 10 oC. Find the required pump work.

A pump takes water at 60°F from a large reservoir and delivers it to the bottom...

A pump takes water at 60°F from a large reservoir and delivers it to the bottom of an open elevated tank 25 ft above the reservoir surface through a 3 inch ID pipe. The inlet to the pump is located 10 ft below the water surface, and the water level in the tank is constant at 160 ft above the reservoir surface. The pump delivers 150 gpm. If the total loss of energy due to friction in the piping system...

2. A pump delivers 30o C water from a supply reservoir to an elevated storage tank...

2. A pump delivers 30o C water from a supply reservoir to an elevated storage tank at a discharge rate of 120 litres/sec. At this discharge the manufacturer’s data indicates the net positive suction head (NPSH) for the pump is 6.0 m. The water surface elevation difference between the reservoir and the tank is 45.0 m. The total length of pipe between the two is 150.0 m, 10.0 m of which is located on the suction side of the pump....

On a day when the water is flowing relatively gently, water in the Niagara River is...

On a day when the water is flowing relatively gently, water in the Niagara River is moving horizontally at 4.5 m/s before shooting over Niagara Falls. After moving over the edge, the water drops 53 m to the water below. A) If we ignore air resistance, how much time does it take for the water to go from the top of the falls to the bottom? B) How far does the water move horizontally during this time?

A pump is to lift water from a source 10 ft below pump centerline and to...

A pump is to lift water from a source 10 ft below pump centerline and to be discharged to a tank 60ft above pump centerline. The installation uses 3”∅ and 2.5 “∅ pipe for suction and discharge, respectively. A pump is to handle 200 gpm of water at 80°F. The loss of head due to friction can be estimated equal to 8.5 ft. Determine: A) TDH B) WHP C)BHP if np = 60% D)time required to fill the cylindrical tank...

A sump pump (used to drain water from the basement of houses built below the water...

A sump pump (used to drain water from the basement of houses built below the water table) is draining a flooded basement at the rate of 0.55 L/s, with an output pressure of 2.95 × 105 N/m2. A. The water enters a hose with a 2.8 cm inside diameter and rises 2.2 m above the pump. What is its pressure at this point N/m2? You may neglect frictional losses. B. The hose goes over the foundation wall, losing 0.65 m...

The NPSH of pump of water piping system of low section loss of z1=5 m, P1=0...

The NPSH of pump of water piping system of low section loss of z1=5 m, P1=0 atm gauge, is about

Design a system to move 100 gpm of water from a river with surface water elevation...

Design a system to move 100 gpm of water from a river with surface water elevation of 201.35 ft msl to a tank with surface water elevation = 246.55 ft msl. The tank is pressurized; the air pressure in the tank is 60 psig. The total length of pipe is 125 ft with 6 standard elbows all made of Sch 40 steel pipe. Your design should specify the nominal diameter of pipe (use only commercially available sizes) and the power...

A pump lifts 1000 (liters) of water from ground to a tank on the roof of...

A pump lifts 1000 (liters) of water from ground to a tank on the roof of a building 100 (m) high. What is the potential energy in the water? [ 1 (liter) = 1000 cm3 ]. Show all your steps to the solution. A skier is coming downhill. At one point she is 50 (m) above the bottom of the hill and moving at 20 (m/s). What is her speed as she reaches the bottom of the hill? 22.3 (m/s)...

Question