The radius of a circular truncated cone varies with x as R(x) = (r/L)(8L-0.5x). Determine the...

The radius of a circular truncated cone varies with x as R(x) = (r/L)(8L-0.5x). Determine the extension of the truncated con due to it's own weight in terms of E, L, r,and Y. Where E and Y are the modulus of elasticity and the specific weight of the material, respectively.

Expert Solution

samet mamat answered 2 years ago

Let K be a cone with a circular bottom, that has a radius r, and the...

Let K be a cone with a circular bottom, that has a radius r, and the apex is directly above the center of the bottom. Let h represent the height of the cone. Show that the surface area of the cone K without the bottom is equal to pi * r * sqrt(r^2 + h^2) . (Use that a sector that is given with angle θ in a circle with radius R has the area (θ * R^2)/2

In the figure current is set up through a truncated right circular cone of resistivity ?,...

In the figure current is set up through a truncated right circular cone of resistivity ?, left radius a, right radius b, and length L. Assume that the current density is uniform across any cross section taken perpendicular to the length. In terms of the variables given, what is the resistance of the cone?

The surface area of a right-circular cone of radius r and height h is S=πrr2+h2−−−−−−√, and...

The surface area of a right-circular cone of radius r and height h is S=πrr2+h2−−−−−−√, and its volume is V=1/3πr2h. (a) Determine h and r for the cone with given surface area S=4 and maximal volume V. h= , r= (b) What is the ratio h/r for a cone with given volume V=4 and minimal surface area S? hr= (c) Does a cone with given volume V and maximal surface area exist? A. yes B. no

The tank in the form of a right-circular cone of radius 7 feet and height 39...

The tank in the form of a right-circular cone of radius 7 feet and height 39 feet standing on its end, vertex down, is leaking through a circular hole of radius 4 inches. Assume the friction coefficient to be c=0.6 and g=32ft/s^2 . Then the equation governing the height h of the leaking water is dhdt=_______________ If the tank is initially full, it will take _________ seconds to empty.

A metallic circular plate with radius r is fixed to a tabletop. An identical circular plate...

A metallic circular plate with radius r is fixed to a tabletop. An identical circular plate supported from above by a cable is fixed in place a distance dd above the first plate. Assume that dd is much smaller than r. The two plates are attached by wires to a battery that supplies voltage V. 1) What is the tension in the cable? Neglect the weight of the plate. Express your answer in terms of the variables d, r, V,...

There is a walled city that is circular with radius R. Assumethat when the population...

There is a walled city that is circular with radius R. Assume that when the population if this city is N, the benefit per person is ((π(R^2))/N)^2. The cost of defending is given by (b2πR)/N. Walls for defense were already built a long time ago, so people in the city do not have to bear the cost of building walls. Since there is a risk of epidemic, its cost is (C(N/πr)^2). Because this city still has much capacity, the government...

If R is the region bounded by the functions f(x)=x+4 and g(x)=−0.5x−1 over the interval [−2,0],...

If R is the region bounded by the functions f(x)=x+4 and g(x)=−0.5x−1 over the interval [−2,0], find the area of the region R as shown in the image.

A circular wire loop of radius r = 0.25 m and resistance R = 11.1 Ω...

A circular wire loop of radius r = 0.25 m and resistance R = 11.1 Ω rotates about a shaft through its diameter at a constant rate of f = 5.8 Hz in a uniform B = 0.49-T magnetic field directed perpendicular to the rotation axis. The plane of the loop is perpendicular to the magnetic field at time t = 0. a) Find the expression for the time-dependent magnetic flux through the loop. Φ = b) Find the value...

The velocity profile for a steady laminar flow in a circular pipe of radius R is...

The velocity profile for a steady laminar flow in a circular pipe of radius R is given by u=u0(1−r2R2) . If the fluid density varies with radial distance r from the centerline as ρ=ρ0(1+rR)14 , where ρ0 is the fluid density at the pipe center, obtain and choose the correct relation for the bulk fluid density in the tube.

Find the moment of inertia of a circular disk of radius R and mass M that...

Find the moment of inertia of a circular disk of radius R and mass M that rotates on an axis passing through its center. [Answer: ½ MR2] Step 1: Pictorial representation: Sketch a neat picture to represent the situation. Step 2: Physical representation: 1) Cut the disk into many small rings as it has the circular symmetry. 2) Set up your coordinate system and choose its origin at the pivot point (or the axle location) for convenience. Then choose a...

Question