Question

In: Physics

A 2750 lb car has a frontal cross-sectional area A of 22.4 ft2, a drag coefficient...

A 2750 lb car has a frontal cross-sectional area A of 22.4 ft2, a drag coefficient Cd of 0.28, and a drive (or tractive) force of 280 lbs. Assume an air density of 2.3x10-3 slug/ft3.

A.  Determine the acceleration of the car when it is driving at 31 mph on a level road.

B.  Determine the acceleration of the car when it is driving at 31 mph on a level road into a 7 mph head wind.

C.  Determine the acceleration of the car when it is driving at 31 mph up a 2.1 degree hill (no head or tail wind).

Solutions

Expert Solution


Related Solutions

Cycling. For a touring bicyclist the drag coefficient C1ƒ = 1 CArv22 is 1.00, the frontal...
Cycling. For a touring bicyclist the drag coefficient C1ƒ = 1 CArv22 is 1.00, the frontal area A is 0.463 m^2, and the coefficient of rolling friction is 0.0045. The rider has mass 50.0 kg, and her bike has mass 12.0 kg. (a) To maintain a speed of 12.0 m/s (about 27 mi/h) on a level road, what must the rider’s power output to the rear wheel be? (b) For racing, the same rider uses a different bike with coefficient...
A 100 ft steel tape of cross-sectional area 0.0025 in2, weight 2.0 lb, and standardized at...
A 100 ft steel tape of cross-sectional area 0.0025 in2, weight 2.0 lb, and standardized at 68°F is 99.983 feet between end marks when supported throughout under a 10-lb pull. a. What is the true horizontal length of a recorded distance AB if AB was measured to be 140.23 ft? At the time of measurement, the average temperature was 55°F, the tape was unsupported and there was 17 lbs of tension on the tape. (Assume horizontal taping and all full...
A silver wire has a cross sectional area A = 2.0 mm2. A total of 9.4...
A silver wire has a cross sectional area A = 2.0 mm2. A total of 9.4 × 1018 electrons pass through the wire in 3.0 s. The conduction electron density in silver is 5.8 × 1028 electrons/m3 and e = 1.60 × 10-19 C. What is the drift velocity of these electrons?
A solenoid that is 112 cm long has a cross-sectional area of 14.9 cm2. There are...
A solenoid that is 112 cm long has a cross-sectional area of 14.9 cm2. There are 1310 turns of wire carrying a current of 7.32 A. (a) Calculate the energy density of the magnetic field inside the solenoid. (b) Find the total energy in joules stored in the magnetic field there (neglect end effects).
A solenoid that is 91.4 cm long has a cross-sectional area of 24.8 cm2. There are...
A solenoid that is 91.4 cm long has a cross-sectional area of 24.8 cm2. There are 811 turns of wire carrying a current of 8.08 A. (a) Calculate the energy density of the magnetic field inside the solenoid. (b) Find the total energy in joules stored in the magnetic field there (neglect end effects).
A bridge piling has a cross-sectional area of 1.250 m2 and supports a load of 1875...
A bridge piling has a cross-sectional area of 1.250 m2 and supports a load of 1875 N. What is the stress on the column? A) 1875 N B) 1875 N/m2 C) 1500 N/m2 D) 2344 N/m2
coil has 30 turns and carries current. The cross sectional area of the coil is 7.5cm....
coil has 30 turns and carries current. The cross sectional area of the coil is 7.5cm. At a point located on the axis of the coil at a distance 1.5m, the magnetic field os 0.2mG, what is current in the coil?
A cylinder of 10-m-high, and a cross-sectional area of 0.1 m2 , has a piston (that...
A cylinder of 10-m-high, and a cross-sectional area of 0.1 m2 , has a piston (that is free to move) assumed to have negligible mass and thickness (see Figure 1(a)). Above the piston there is a liquid that is incompressible (constant density and volume) with ρliquid = 1000 kg/m3 . Below the piston there is air at 300 K, with a volume of 0.3 m3 . Assume air is an ideal gas (Ru =8.314 J.mol-1 .K-1 ; Mair = 28.9628...
A long solenoid (n = 1500 turns/m) has a cross-sectional area of 0.40 m2 and a...
A long solenoid (n = 1500 turns/m) has a cross-sectional area of 0.40 m2 and a current given by I = 3.0t A, where t is in seconds. A flat circular coil (N = 500 turns) with a cross-sectional area of 0.15 m2 is inside and coaxial with the solenoid. What is the magnitude of the emf induced in the coil at t = 2.0 s?
A hydraulic lift in a garage has two pistons: a small one of cross-sectional area 4.50cm2...
A hydraulic lift in a garage has two pistons: a small one of cross-sectional area 4.50cm2 and a large one of cross-sectional area 220cm2 . There are two parts to this question please give CORRECT answer. Part A If this lift is designed to raise a 3400-kg car, what minimum force must be applied to the small piston? Part B If the force is applied through compressed air, what must be the minimum air pressure applied to the small piston?
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT