Question

In: Chemistry

Given four beakers labeled A, B, C, and D. Add 40 mL of distilled water to...

Given four beakers labeled A, B, C, and D.

Add 40 mL of distilled water to beakers A and C.

Add 40 mL of the prepared sodium acetate/acetic acid buffer solution to both beakers B and D.

Pipette 1.0 mL of 6 M HCl, hydrochloric acid solution into beakers A and B.

Pipette 1.0 mL of 6 M NaOH, sodium hydroxide solution into beakers C and D.

If the concentration of CH3CO2Na after dilution is 0.62M and the concentration of CH3CO2H after dilution is 0.51M

Calculated pH of beaker A and B after the addition of 6 M HCl.(Ka of CH3CO2H=1.32x10^-4)

Solutions

Expert Solution


Related Solutions

Suppose there are two suppliers of distilled water, labeled firm A and firm B. Distilled water...
Suppose there are two suppliers of distilled water, labeled firm A and firm B. Distilled water is considered to be a homogenous good (well, all water tastes the same, anyway). Let p denote the price per gallon, qA quantity sold by firm A, and qB the quantity sold by firm B. Firm A is located nearby a spring and therefore bears a production cost of cA = $1 per one gallon of water. Firm B is not located near a...
(3) Suppose there are two suppliers of distilled water, labeled firm A and firm B. Distilled...
(3) Suppose there are two suppliers of distilled water, labeled firm A and firm B. Distilled water is considered to be a homogenous good (well, all water tastes the same, anyway). Let p denote the price per gallon, qA quantity sold by firm A, and qB the quantity sold by firm B. Firm A is located nearby a spring and therefore bears a production cost of cA = $1 per one gallon of water. Firm B is not located near...
If you add 39 mL of distilled water to 48 mL of a 15 % (m/v)...
If you add 39 mL of distilled water to 48 mL of a 15 % (m/v) NaOH solution, what is the new concentration in % (m/v)? A 21.8 g sample of water contains how many water molecules? An unknown hydrocarbon compound was analyzed for hydrogen by elemental analysis and results show that it contains 15.88 % H. What is the empirical formula? Determine the empirical formula of the compound with the following composition by mass: 92.26 percent C and 7.74...
Given pure culture (labeled A,B,C, and D) of each of the four gram negative bacilli (Escherichia...
Given pure culture (labeled A,B,C, and D) of each of the four gram negative bacilli (Escherichia coli, Enterobacter aerogenes, Psuedomonas aeruginosa, and Proteus vulgaris?, describe a series of tests that could be set up and then intrepreted to determine the identity of each culture. The use of the crystal ID system is not an acceptable answer. Microbiology
The temperature of 500 mL of distilled water in a flask is between 70°C and 90°C....
The temperature of 500 mL of distilled water in a flask is between 70°C and 90°C. Room temperature is 20°C. the useful range of the only thermometer available is between 0°C and 50°C. Briefly describe an experiment you could carry out which would allow you to determine exactly the temperature of the water in the flask. Indicate the following in your description: What equipment would you use? What would you do? The equation(s) for any calculation(s) you would carry out,...
A vitamin C (ascorbic acid) tablet was dissolved in approximately 50 mL of distilled water and...
A vitamin C (ascorbic acid) tablet was dissolved in approximately 50 mL of distilled water and titrated with the standardized NaOH solution. From the results of this titration, the mg of ascorbic acid in the tablet was calculated. Molecular formula of ascorbic acid: C6H8O6 Volume of NaOH required to neutralize ascorbic acid in Vitamin C tablet (mL) 14.47 Concentration of NaOH in mol/L,   0.1964 Calculate the amount of ascorbic acid in the Vitamin C tablet in (mg).
A container of water has 400 mL of water at 90 degrees C. You add 100...
A container of water has 400 mL of water at 90 degrees C. You add 100 grams of ice at -20 degrees C. What is the final temperature of the mixture? please show work
Given an experimental design with four factors A, B, C and D where each factor has...
Given an experimental design with four factors A, B, C and D where each factor has two levels. Derive the formula for effect estimation of main effect of ?, interaction effect of ??, ??? and ????. (please use (1),a,b,c,d,ab,ac,ad,bc,bd,cd,abc,abd,acd,bcd,abcd to represent the response)
Given A*B*C and A*C*D, prove the corollary to Axion B-4.
Given A*B*C and A*C*D, prove the corollary to Axion B-4.
In step 4 of part A where you add distilled water to the acid KHP, suppose...
In step 4 of part A where you add distilled water to the acid KHP, suppose you add 40 mL DI h2o instead of 30mL to the flask to dissolve the KHP. Why would this affect the overall outcome of your data? Why/why not? Hint: try to determine whether or not your calculations are affected by this change.   this was a titration performed between KHP and NaOH solution
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT