The formula for length contraction gives the length of an interval on a ruler moving with velocity v relative to an observer as where L is the length of the same interval on a ruler at rest with respect to the observer. By what fraction is the length of a meter stick reduced if its velocity relative to you is measured to be 87 percent of the speed of light?
In: Physics
A block of mass M is hanging from a rope of length L. You throw a ball of clay of mass m towards the block. The clay hits the block along the horizontal axis with a speed v, and proceeds to stick to the block. The block and clay swing up to a maximum height h. Find h.
In: Physics
Review the Medsker and McDorman article and Nixon's resignation address. How is the President treated as the accused by the courts? The Justices admit they were not "required to proceed against the president as against an ordinary individual" (United States v. Nixon 708, 715). What do you think Aristotle would have thought of this?
In: Psychology
Which of the following is a function of the investment banker in a M&A process? [I] identifying potential target firms [II] arranging mergers [III] developing defensive tactics [IV] establishing a fair value of the target firm [V] arranging financing of the merger.
I, II, III | ||
II, III, IV | ||
III, IV, V | ||
All of the above |
Which of the following is a type of systematic risk, and how would such a risk impact the beta of a firm involved in a merger? [I] labor strikes in the company [II] currency crisis [III] Bad product decision by the firm's management [IV] A rise in the delinquency rates and home foreclosures in the financial system.
I, II; Negative effect on beta | ||
II, III; Negative effect on beta | ||
III, IV; Positive effect on beta | ||
II, IV; Positive effect on beta | ||
I, III; Positive effect on beta | ||
None of the above answer combinations are correct |
In: Finance
1). Nebcin 35 mg IV every 8 hrs. for a child who weighs 14 kg. The recommended dosage for pediatrics is 2 -2.5mg / kg / dose.
(A) What is the recommended minimum dosage for this child? How many mg /dose?
(B) What is the maximum recommended dosage for this child? How many mg / dose?
(C) Is the ordered dose safe?
2).The flow rate (ml/hr.) for 1 Liter is 80ml/hr. It started at 1000. Calculate the infusion time and completion time in traditional time and military time?
Infusion Time
Military Time
Traditional Time
3). Order: V-cillin K 300,000 Units PO four times a day. It is supplied as: V-cillin K 200,000 units/ 5ml. How many mLs should be administered?
4).The child has an order for Thyroxine 0.2 g PO daily. Thyroxine is available in 100mg tablets. How many tablets will the nurse administer?
In: Nursing
R& V Hotel is consistently incurring losses for the past 2
years though the sales clerk receives customer orders, raises sales
invoices at a higher price and processes payments for customers.
Hotel customers have contracted prices, however online trade prices
automatically loaded in to the system but the Brenda clerk used to
amend manually. Mr. Zakariya an internal auditor found some
deficiencies, who has taken some necessary actions to cross check
those invoices and employees responsibilities and suggested the
management immediately to prevent from loss of customers and good
will of the hotel.
Based on the above scenario:
1. How the internal audit for R and V hotel can be helpful in
resolving the issues they are confronting at the moment? Justify
your answer practically
2. If you were Mr. Zakariya, prepare doable audit plan that Mr.
Zakariya that you can use for the company and provide
recommendations on how to overcome the deficiencies cited in the
case?
In: Accounting
The cell potential of a redox reaction occurring in an electrochemical cell under any set of temperature and concentration conditions can be determined from the standard cell potential of the cell using the Nernst equation E = E° − RT nF ln Q where E is the cell potential of the cell, E° is the standard cell potential of the cell, R is the gas constant, T is the temperature in kelvin, n is the moles of electrons transferred in the reaction, and Q is the reaction quotient. Use this relationship to answer the problem below.
For the following oxidation-reduction reaction Cu2+(aq) + Ni(s) → Cu(s) + Ni2+(aq) the standard cell potential is 0.60 V. What is the actual cell potential of the cell if the temperature is 314 K, the initial Cu2+ concentration is 0.00107 M, and the initial Ni2+ concentration is 0.0183 M? (Note that the reaction involves the transfer of 2 moles of electrons, and the reaction quotient is 17.1.)
_______________ V
In: Chemistry
In: Physics
Suppose you have a concentrated solution (S1) with a concentration equal to 1 M. You use their solution to make more dilute solutions S2-S6. Complete the following table, which describes the solution process. NOTE: Not all of the solutions are diluted S1; some are made from solutions that are derived from S1. The equation C1V1 = C2V2 should be used as a starting point for calculation. You can assume all volumes are additive. S2 is shown as an example.
| Solution | Volume (mL) of concentrated solution | Volume of solvent | Total Volume | Dilution with respect to S1 (v/v) | Concentration |
| S1 | - | - | - | - | 1 M |
| S2 | 10 mL of S1 | 40 mL | 50 mL | 1/5 | (0.20) |
| S3 | 100 mL | (0.40) | |||
| S4 | 5 mL of S2 | 35 mL | |||
| S5 | 10 mL of S1 | 1/2 | |||
| S6 | 20 mL of S1 | 1.0 L |
In: Chemistry
Consider a Carnot-cycle heat pump with R-410a as the working fluid. Heat is rejected from the R410a at 35 oC, during which process the R-410a changes from saturated vapor to saturated liquid. The heat is transferred to the R-410a at 0 oC. The specific volume during the isothermal heat addition process at 0 oC changes from 0.00841 m3 /kg to 0.02994 m3 /kg.
a. Show the cycle on P-T, P-v, and T-v diagrams.
b. Find the quality at the beginning and at the end of the isothermal heat addition process at 0 oC.
c. Find the pressure and specific volume at the four points.
d. Find the specific heat and specific work at each process.
e. Find the net specific heat and the net specific work during the cycle.
f. Determine the COP of the cycle using heat and work.
g. Determine the COP of the cycle using temperatures.
In: Mechanical Engineering