Use any method you choose to locate the important case of Hamer v. Sidway,124 N.Y. 538, 27 N.E. 256 (1891). Read the case and answer the following questions: Who is the offeror? What is the offer? Who is the offeree? How was the offer made? What was the consideration? Given your understanding of law, did the court make the right decision? Why or why not?

A small city requires about 10 MW of power. Suppose that instead of using high-voltage lines to supply the power, the power is delivered at 120 V.

Assuming a two-wire line of 0.48?cm -diameter copper wire, estimate the cost of the energy lost to heat per hour per meter. Assume the cost of electricity is about 10 cents per kWh.

A 4.0-cm-diameter parallel-plate capacitor with a 1.0 mm spacing is charged to 1000 V. A switch closes at t =0s, and the capacitor is discharged through a wire with 0.20? resistance.

Part A

Find an expression for the magnetic field strength inside the capacitor at r =1.0cm as a function of time t (where t is in ps).

Part B

Draw a graph of B versus t.

A voltaic cell consists of a Pb/Pb2+ half-cell and a Cu/Cu2+ half-cell at 25 ∘C. The initial concentrations of Pb2+ and Cu2+ are 5.20×10⁻²M and 1.50 M, respectively.

A) What is the cell potential when the concentration of Cu2+ has fallen to 0.250 M ?

B) What are the concentrations of Pb2+ and Cu2+ when the cell potential falls to 0.36 V?

What are Above or below of the line deductions?

What is a trade or business expense? How is it shown on the return(1040)?

What items discussed cannot be deducted?

What are the rules for illegal businesses and the differences between drugs and other illegal businesses?

What are The rules for expensing v capitalizing investigation expenses and the differences between the two terms?

What are Hobby loss rules and calculations?

Mark all pairs of H₀/H₁ below as valid (V) or invalid (I):

1. H₀: p = 0.4 vs.   H₁: p > 0.4
2. H₀: p ≠ 0.53 vs.   H₁: p = 0.53
3. H₀: σ² = 15 vs.   H₁: σ² ≠ 15
4. H₀: µ = 3   vs.   H₁: σ² ≠ 9
5. H₀: µ = 4   vs.   H₁: µ ≠ 0.2

Question 3
(a) Identify the location of the following corresponding operand if the address field in an instruction contains decimal value 15.
i. immediate addressing
ii. direct addressing
iii. indirect addressing
iv. register addressing
v. register indirect addressing

(b) Differentiate the characteristics between CISC and RISC architecture.

(c) Discuss the stages involved in fetch-decode-execute cycles.

When t = 0, the position of a point is s= 6m, and its velocity is v= 2m/s. From t = 0 to t= 6s, the acceleration of the point is a = 2+ 2t² m/s² .From t = 6s until it comes to rest, its acceleration is a = -4m/s²

^{a.) What is the total time of travel?}

^{b.) What total distance does the point move?}

I start with 3 mL of [Ru(bpy)3](PF6)2 solution. Every time Add 100 uL volume of DPA solution with 0.05M. Do it five times, the total amount of DPA is 500ul

500ul

I am so confused about how to calculate the concentration of DPA in each adding