Write a summary section outlining why your product or service idea would be successful relative to the critical decision areas of the course. (Use Chapter 1 along with the other two sections of your report to help you with this.)

Detail Strengths, Weaknesses, Opportunities, and Threats (SWOT) Analysis on New York Yellow Cab (Taxi) 300 words or more no copy and paste and use citation if positble thanks for your help and expertise.

How to Write a chemistry Lab report?

I have to write a chemistry lab report, also to presnte it.

The paper should incloud:

- Abstract

- Introduction

- Methods

- Results

- Discussion

- Conclusion

- Confined research

- Citation

Can I have help to describe for me what to write in general in each section of the worlds above (i mean what should write about: is it the equation and describ it? or just write a general info? or in methods just to write the prosses in points or more? and like this )

My Experment about :

System (1):

Investigate the heat lost or gained when a specific or group pf chemicals are added to water.

Sodium Chloride.

I need help to know what to write in the 7 section which the abstract and introducion and all other?

A water pipe tapers down from an initial radius of R₁ = 0.2 m to a final radius of R₂ = 0.09 m. The water flows at a velocity v₁ = 0.86 m/s in the larger section of pipe.

1. What is the volume flow rate of the water?
2. What is the velocity of the water in the smaller section?
3. Using this water supply, how long would it take to fill up a swimming pool with a volume of V = 130 m³? (give your answer in minutes)
4. The water pressure in the center of the larger section of the pipe is P₁ = 243120 Pa. Assume the density of water is 10³ kg/m³. What is the pressure in the center of the smaller section of the pipe?
5. If the pipe was turned vertical and the volume flow rate in the larger section is kept the same, which answers would change?

*the speed of water in the smaller section

*the volume flow rate in the smaller section

*the pressure in the smaller section

Question:Subject is EEC1960 Section 01 Field Experience I: Knowledge but I choose PSYCOLOGY to make easy for post.

Take some time this module to watch a single child or a group of children playing at your Field Experience Site. Jot down notes about what you see and hear. Based on your observations, try to determine what stage of play is being demonstrated. To complete this assignment, do the following: Review the Stages of Play lecture in this module. In a 1-2 page paper, describe what you observed and identify the stage(s) of play that the child was demonstrating using Partens (1932) framework.

7. What are the applications of an Embedded and Real Time Systems.

8. Analyze in detail about the challenges in Embedded and Real-Time systems design.

9. What are the parameters to be considered while designing an Embedded System Process?

10. Why microprocessor/microcontroller is used in Embedded system.

please no cursive

Lesson Twelve you've seen how to use F-Tests and Analysis of Variance to answer research questions relevant to those statistical analysis procedures. Respond to the following to demonstrate your grasp of these.

• Describe a scenario where a researcher could use an F-test for the equality of two variances to answer a research question. Fully describe the scenario and the variables involved and explain the rationale for your answer. Why is that test appropriate to use?

• Describe a scenario where a researcher could use a One-Way ANOVA to answer a research question. Fully describe the scenario and the variables involved and explain the rationale for your answer. Why is that test appropriate to use?

• Describe a scenario where a researcher could use a Two-Way ANOVA to answer a research question. Fully describe the scenario and the variables involved and explain the rationale for your answer. Why is that test appropriate to use?

• ANOVA is based on an F-ratio that is calculated as the ratio of two variance estimates, the variance between groups and the variance within groups, but enables conclusions to be made about the means of the samples involved. What is the logic of that? I.e., explain the rationale that supports the use of variance estimates.

• Describe the issue that would arise if you were to run a series of t-tests to compare differences between four means. Why is it preferable to use ANOVA instead?

XYZ Corporation is experiencing massive grown in the fashion industry. As the corporation grows and expands into new markets, it is exposed to increasing business risks. The company’s hiring manager is looking for candidates to fill a risk manager position to protect the corporate property and minimize loss. In your response, answer/respond to the following:

What characteristics and background would you look for in a risk manager candidate?

What would be deterring?

Explain in detail the job description and what is expected of this individual from XYZ.

3. Box A contains 6 red balls and 3 green balls, whereas box B contains 3 red ball and 15 green balls.

Stage one:One box is selected at random in such a way that box A is selected with probability 1/5 and box B is selected with probability 4/5.

Stage two: First, suppose that 1 ball is selected at random from the box selected at stage one.

a) What is the probability that the ball is red?

b) Given that the ball is red, what is the probability it came from box A? Next, suppose that two balls are selected at random without replacement from the box selected at stage one.

c) What is the probability that both balls are red?

d) Given that both balls are red, what is the probability they came from box A?

e) What is the probability that one ball is red and the other is green?

f) Given that one ball is red and the other is green, what is the probability they came from box A?